engine coolant lexus LS400 1996 Audio System / 1996 LS400: ENGINE

189
SECTION 6 ± 2
SERVICE PROCEDURES AND
SPECIFICATIONS
Engine
Specifications 190
Fuel 192
Facts about engine oil consumption 193
Used engine oil 194
Checking the engine oil level 195
Checking the engine coolant level 197

ENGINE
191 ± COOLING SYSTEM
Capacity
11.0 L (11.6 qt., 9.7 Imp. qt.)
Coolant typeEthylene ± glycol coolant (Do not use alcohol type.)
± FUEL
Fuel type
Only UNLEADED
Research octane number96 (Octane Rating 91) or higher
± IGNITION SYSTEM
Spark plug
± MakeNIPPONDENSOPK20R11
NGK BKR6EP11
± Gap1.1 mm (0.043 in.)
± ELECTRICAL SYSTEM
Battery ±
Maintenance type battery
Specific gravity reading at 20C (68F): 1.260Fully charged
1.160Half charged
1.060Discharged
Charging rates Quick charge 15A max.
Slow charge 5A max.
±Non±maintenance battery
Open voltage at 20C (68F): 12.7VFully charged
12.3VHalf charged
11.9VDischarged
[Voltage that is checked 20 minutes after the key is
removed with all the lights turned off]
Charging rates5A max.

ENGINE
197
Oil identification marks
API Service SymbolILSAC Certification Mark
Either or both API registered marks are added to some oil
containers to help you select the oil you should use.
The API Service Symbol is located anywhere on the
outside of the container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SH.
The center portion of the label shows the SAE viscosity
grade such as SAE 5W±30. ªEnergy±Conserving IIº,
shown in the lower portion, indicates that the oil has
fuel±saving capabilities. Oils marked ªEnergy±Conserving
IIº will have higher fuel±saving capabilities than oils
marked ªEnergy±Conservingº.
The ILSAC (International Lubricant Standardization and
Approval Committee) Certification Mark is displayed on the
front of the container.
CHECKING THE ENGINE
COOLANT LEVEL

Reservoir capUpper lineLower line
Park the vehicle at a level spot and look at the
see±through coolant reservoir when the engine is cool.
The coolant level is satisfactory if it is between the
upper and lower lines on the tank. If the level is low, add
ethylene±glycol type coolant.
The coolant level in the reservoir will vary with engine coolant
temperature. However, if the level is on or below the lower
line, add coolant to bring the level up to the upper line.
Use only ethylene±glycol type coolant. It will prevent
freezing and corrosion. Neither supplemental inhibitors nor
additives are needed nor recommended. (For information on
ethylene±glycol coolant, see also ªEngine coolant selectionº
described below.)

ENGINE
198If the coolant level drops within a short time after
replenishing, there may be a leak in the system. Visually
check the radiator, hoses, reservoir cap, drain cock and
water pump.
If you can find no leak, have your Lexus dealer test the cap
pressure and check for leaks in the cooling system.
CAUTION!
To prevent burning yourself, do not remove the
reservoir cap when the engine is hot.
Engine coolant selection
Your coolant must contain ethylene±glycol antifreeze. In
addition to preventing freezing and subsequent damage to
the engine, this will also prevent corrosion. Further
supplemental inhibitors or additives are neither needed nor
recommended.
Read the antifreeze container for information on freeze
protection. Follow the manufacturer's directions for how
much to mix with water. The total capacity of the cooling
system is given on page 191. We recommend 50% solution
be used for your Lexus, or a sufficient quantity to provide
protection to about ±35C (±31F).
NOTICE
Do not use alcohol type antifreeze or plain water
alone.