Programming ac lexus LS400 1998 Engine / LEXUS 1998 LS400 OWNER'S MANUAL (OM50498U)

INTERIOR EQUIPMENT
54
GLOVEBOX
14L0371
1
Unlock 2
Open 3
Lock
To open the glovebox door, pull the lever. To lock the glovebox
door, insert the master key and turn it clockwise.
With the tail lights on, the glovebox light will come on when the
glovebox door is open.
CAUTION
To reduce the chance of injury in case of an accident or a
sudden stop, always keep the glovebox door closed while
driving.
GARAGE DOOR OPENER
Garage door openers manufactured under the license from
HomeLink can be programmed in the garage door opener on
the vehicle.
(a) Programming the garage door opener
14L040
1
Indicator light 2
Buttons
This garage door opener has 3 buttons and you can store one
program for each button.
1. Decide which one of the 3 buttons you want to program. Push and
hold down one of the buttons until its indicator light begins to flash.
While holding this button, follow the step ”2”.
2. Bring the original garage door opener closer to the garage door
opener equipped on the vehicle within about 25 mm (1 in.) and push
the button on the original garage door opener. The signal from the
original garage door opener is sent to the one to be programmed.

INTERIOR EQUIPMENT
55 3. When the frequency and code is registered, the indicator light
flashes rapidly. Then you can release both buttons.
4. If you wish, repeat the procedure for each remaining button for
another garage door opener.
If you want to write a new program over the program set already,
select a button you want to program and repeat the procedure from
step 1. The previous program is erased and a new program will be
set.
If the transmitter has a ”rolling code” feature, it is necessary to
program the garage door opener receiver on the garage, after
programming the garage door opener on the vehicle,. For the
setting of the receiver, refer to the instruction manual for the
receiver.
After setting the receiver, push the programmed button on the
vehicle for about 1 to 2 seconds within the operational range.
The oldtype garage door openers manufactured before 1982 cannot
be programmed in this system.
CAUTION
When programming or operating the garage door opener,
make sure there is no one around the moving door. It is
dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door opener. The
indicator light comes on. The garage door opener continues to send
the signal for up to 20 seconds as long as the button is pushed.
(c) Erasing the garage door opener memory
Push and hold down the 2 outside buttons until the indicator light
flashes. All memorized data will be erased.
FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Rules part 15.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference that may be received,
including interference that may cause undesired operation.
WARNING: This transmitter has been tested and
complies with FCC and DOC/MDC rules. Changes or
modifications not expressly approved by the partly
responsible for compliance could void the user’s
authority to operate the device.