height LEXUS LS430 2005 Owner's Manual

Page 493 of 539

CHASSIS
474
63L025a
 1Section width
2Tire height
3Wheel diameter
Name of each section of tire
63SA14
 1Bead
2Sidewall
3Shoulder
4Tread
5Belt
6Inner liner
7Reinforcing rubber
8Carcass
9Rim lines
10Bead wires
11Chafer

Page 503 of 539

CHASSIS
484
Chain installation
Install the chains on the rear tires as tightly as possible.
Do not use tire chains on the front tires. Retighten chains
after driving 0.5 1.0 km (1/4 1/2 mile).
When installing chains on your tires, carefully follow the
instructions of the chain manufacturer.
CAUTION
Do not exceed 50 km/h (30 mph) or the chain
manufacturer’s recommended speed limit,
whichever is lower.
 Drive carefully avoiding bumps, holes, and sharp
turns, which may cause the vehicle to bounce.
 Avoid sharp turns or lockedwheel braking, as use of
chains may adversely affect vehicle handling.
 When driving with chains installed, be sure to drive
carefully. Slow down before entering curves to avoid
losing control of the vehicle. Otherwise an accident
may occur.
If the chains are installed, the tire pressure warning
system may not operate properly. See “Tire pressure
warning system” on page 370.
REPLACING WHEELS
When to replace your wheels
If you have wheel damage such as bending, cracks or
heavy corrosion, the wheel should be replaced.
If you fail to replace a damaged wheel, the tire may slip off the
wheel or cause loss of handling control.
Wheel selection
When replacing wheels, care should be taken to ensure
that they are equivalent to those removed in load capacity,
diameter, rim width, and offset.
Correct replacement wheels are available at your Lexus
dealer.
A wheel of a different size or type may adversely affect
handling, wheel and bearing life, brake cooling,
speedometer/odometer calibration, stopping ability, headlight
aim, bumper height, vehicle ground clearance, and tire or snow
chain clearance to the body and chassis.
Replacement with used wheels is not recommended as they
may have been subjected to rough treatment or high mileage
and could fail without warning. Also, bent wheels which have
been straightened may have hidden structural damage and
therefore should not be used. Never use an inner tube in a
leaking wheel which is designed for a tubeless tire.

Page 530 of 539

BODY
511
370.SPECIFICATIONS
– DIMENSIONS AND WEIGHTSOverall length
5015 mm (197.4 in.)
Overall width1830 mm (72.0 in.)
Overall height– with electronically modulated air suspension
– without electronically modulated air suspension
1470 mm (57.9 in.)*
1490 mm (58.7 in.)*
Wheelbase2925 mm (115.2 in.)
Tread
– Frontwith electronically modulated air suspension
without electronically modulated air suspension
– Rear with electronically modulated air suspension
without electronically modulated air suspension
1575 mm (62.0 in.)
1570 mm (61.8 in.)
1575 mm (62.0 in.)
1570 mm (61.8 in.)
Vehicle capacity weight (occupants + cargo)410 kg (900 lb.)
Towing capacity (trailer weight + cargo weight)907 kg (2000 lb.)
*Unladen vehicle
– FUEL TANK
Capacity
84 L (22.2 gal., 18.5 lmp.gal.)

Page:   < prev 1-10 11-20 21-30