belt LEXUS LX470 2006 User Guide
Page 77 of 493
GAUGES, METERS AND SERVICE REMINDER INDICATORS
55
Any of the following conditions may occur, but do not
indicate the malfunction:
The light may stay on for about 60 seconds after the ignition
key is turned to the “ON” position. It is normal if it turns off
after a while.
Depressing the brake pedal repeatedly may turn on the
warning light and buzzer. It is normal if the light turns off and
the buzzer stops sounding after a few seconds.
You may hear a small sound in the engine compartment
after the engine is started or the brake pedal is depressed
repeatedly. This is a pump pulsating sound of the brake
system, and it is not a malfunction.
(b) Driver’s Seat Belt Reminder Light and
Buzzer
The light and buzzer act as a reminder to buckle up the driver’s
seat belt.
Once the ignition key is turned to “ON” or “START”, the
reminder light flashes and buzzer sounds if the driver’s seat
belt is not fastened. Unless the driver fastens the belt, the light
continues flashing and the buzzer stops after about 4 to 8
seconds.
(c) Front Passenger’s Seat Belt ReminderLight
The light acts as a reminder to have the front passenger buckle
up the seat belt.
Once the ignition key is turned to “ON” or “START”, the
reminder light flashes if a passenger sits in the front passenger
seat and does not fasten the seat belt. Unless the front
passenger fastens the belt, the light continues flashing.
If luggage or other load is placed on the front passenger seat,
depending on its weight and how it is placed on the seat,
built−in sensors in the seat cushion may detect the pressure,
causing the reminder light to flash.
Page 78 of 493
GAUGES, METERS AND SERVICE REMINDER INDICATORS
56
(d) SRS Warning Light
The indicator comes on when the ignition key is turned to
the “ON” position. It goes off after about 6 seconds. This
means the SRS airbags and seat belt pretensioners are
operating properly.
The SRS warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
front passenger occupant cassification system and indicator
light, front passenger seat belt buckle switch, inflators, seat
belt pretensioners, roll sensing of curtain shield airbags off
indicator light, interconnecting wiring and power sources.
If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.
The light does not come on when the ignition key is turned
to the “ON” position or remains on for more than 6 seconds
or flashes.
The light comes on or starts flashing while driving.
The SRS warning light will come on and front passenger
occupant classification indicator light will indicate “OFF” if
there is a malfunction in the front passenger occupant
classification system.
(e) Engine Oil Replacement Reminder Light (U.S.A. only)
The light acts as a reminder to replace the engine oil.
This light will come on when the ignition key is turned to “ON”
and will go off after about a few seconds.
When you drive for about 7200 km (4500 miles) after the
engine oil replacement, this light illuminates for about 3
seconds and then flashes for about 12 seconds with the
ignition key turned to “ON” position. If you continue driving
without the engine oil replacement, and if the driving range
exceeds 8000 km (5000 miles), the light will come on after the
ignition key is turned to “ON” position. The light will remain on\
thereafter.
If the light is flashing, we recommend that you replace the
engine oil at an early opportunity depending on the driving and
road condition. If the light comes on, replace it as soon as
possible.
You need to reset the light after the engine oil replacement.
Reset the light by following the procedure below:
1. Turn the ignition key to th e “LOCK” position with the
odometer re ading shown. (For details, see “Odometer and trip
meter” on page 51.)
2. Turn the ignition key to the “ON” position while holding down
the “ODO/TRIP” knob.
Hold down the knob until the light goes off. Before the light
goes off, it illuminates for 3 seconds, flashes for 2 seconds and
illuminates for 1 second.
Page 83 of 493
GAUGES, METERS AND SERVICE REMINDER INDICATORS
61
(n) Lexus Night View System Warning Light
When this light comes on, the bulb for the near−infrared
floodlight (night view projector) is burned out. Have it replaced
at Lexus dealer.
(o) Charging System Warning Light
This warning light comes on when the ignition switch is turned
to the “ON” position, and goes off when the engine is started.
When there are problems in the charging system while the
engine is running, the warning light comes on.
NOTICE
When the charging system warning light comes on
while the engine is running, malfunctions such as the
engine drive belt being broken may have occurred. If
the warning light comes on, immediately stop the
vehicle in a safe place and contact your Lexus dealer.
(p) Low Fuel Level Warning Light
This light comes on when the fuel level in the tank becomes
very low. Fill the tank as soon as possible.
On inclines or curves, due to the movement of fuel in the tank,
the low fuel level warning light may come on earlier than usual.
(q) Low Washer Fluid Warning Light
This light comes on when the fluid level in the tank becomes
very low. Fill the tank as soon as possible.
(r) Key Reminder Buzzer
This buzzer acts as a reminder to remove the key when you
open the driver’s door with the ignition key in the “ACC” or
“LOCK” position.
Page 123 of 493
SECTION 1 – 6
101
INSTRUMENTS AND CONTROLS
Occupant restraint systems
Seats102
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . .
Front seats 102
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . .
Rear seats 107
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . .
Head restraints 11 9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . .
Armrest 121
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . .
Seat belts 121
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . .
SRS driver airbag and front passenger airbag 134
. . . . . . . . . . . . . . . .
SRS side airbags and curtain shield airbags 144
. . . . . . . . . . . . . . . . .
Front passenger occupant classification system 157
. . . . . . . . . . . . . .
Child restraint 162
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . .
Driving position memory system 189
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Page 124 of 493
OCCUPANT RESTRAINT SYSTEMS
102
SEATS
While the vehicle is being driven, all vehicle occupants should
have the seatback upright, sit well back in the seat and properly
wear the seat belts provided.
CAUTION
Do not drive the vehicle unless the occupants are
properly seated. Do not allow any passengers to sit
in the luggage compartment or cargo area. Persons
not properly seated and/or not properly restrained by
seat belts can be severely injured in the event of
emergency braking or a collision.
During driving, do not allow any passengers to stand
up or move around between seats. Otherwise, severe
injuries can occur in the event of emergency braking
or a collision.
FRONT SEATS
Front seat precautions
Driver seat
CAUTION
The SRS driver airbag deploys with considerable force,
and can cause death or serious injury especially if the
driver is very close to the airbag. The National Highway
Traffic Safety Administration (“NHTSA”) advises:
Since the risk zone for driver airbag is the first 50 75
mm (2 3 in.) of inflation, placing yourself 250 mm (10 in.)
from your driver airbag provides you with a clear margin
of safety. This distance is measured from the center of
the steering wheel to your breastbone. If you sit less
than 250 mm (10 in.) away now, you can change your
driving position in several ways:
Move your seat to the rear as far as you can while still
reaching the pedals comfortably.
Slightly recline the back of the seat. Although vehicle
designs vary, many drivers can achieve the 250 mm
(10 in.) distance, even with the driver seat all the way
forward, simply by reclining the back of the seat
somewhat. If reclining the back of your seat makes
it hard to see the road, raise yourself by using a firm,
non slippery cushion, or raise the seat if your vehicle
has that feature.
Page 127 of 493
OCCUPANT RESTRAINT SYSTEMS
105
Adjusting seat position
16X002c
Move the control switch in the desired direction.
Releasing the switch will stop the seat in that position. Do not
place anything under the seat, as this might interfere with the
seat movement.
Adjusting seatback angle
16X003c
Move the control switch in the desired direction.
Releasing the switch will stop the seatback in that position.
CAUTION
Avoid reclining the seatback any more than needed.
The seat belts provide maximum protection in a frontal
or rear collision when the driver and the front passenger
are sitting up straight and well back in the seats. If you
are reclined, the lap belt may slide past your hips and
apply restraint forces directly to the abdomen or your
neck may contact the shoulder belt. In the event of a
frontal collision, the more the seat is reclined, the
greater the risk of death or personal injury.
Page 129 of 493
OCCUPANT RESTRAINT SYSTEMS
107
REAR SEATS
Rear seat precautions
CAUTION
Adjustment should not be made while the vehicle is
moving.
When folding the seat, secure the seat by adjusting
the length of the anchorage strap to prevent the seat
from falling down.
When returning the seat to its original position,
observe the following precautions in order to prevent
personal injury in a collision or sudden stop.
There is no person or luggage around the seat and
operate slowly by supporting the seat with your
hands.
The seat is securely locked by pushing forward and
rearward on the top of the seatback and by trying to
pull up the edge of the bottom cushion. Failure to do
so will prevent seat belt from operating properly.
The seat belts are not twisted or caught under the
seat and are arranged in their proper position and are
ready to use.
When using the seat, make sure the seat is securely
locked.
NOTICE
Avoid putting heavy loads on the removed seat. The
metallic tips of the seat legs may be damaged and the
seat cannot be reinstalled.
Tumbling or removing the seats will enlarge the luggage
compartment. See “Cargo an d luggage” on page 329 for
precautions to observe for loading luggage.
Adjusting rear seats
16X644
Second seat
Page 130 of 493
OCCUPANT RESTRAINT SYSTEMS
108
16X185b
Third seat
Lean forward and pull the lock release lever. Then lean
back to the desired angle and release the lever.
CAUTION
Avoid reclining the seatback any more than needed.
The seat belts provide maximum protection when the
passengers are sitting up straight and well back in the
seats. If you are reclined, the lap belt may slide past
your hips and apply restraint forces directly to the
abdomen or your neck may contact the shoulder belt.
In the event of a frontal collision, the more the seat is
reclined, the g reater the risk of death or personal injury.
Tumbling second seat for third seat entry
16X186b
For easy access to the third seat, tumble the second seat
in accordance with the following procedure.
Before tumbling the second seat, stow the second seat
buckles as shown in the illustration.
This prevents the buckles from falling out when you tumble the
second seat.
NOTICE
The seat belt buckles must be stowed before you tumble
the second seat.
Page 131 of 493
OCCUPANT RESTRAINT SYSTEMS
109
16X646
1. Lower the head restraints to the lowest position, unlock
the seatback by pulling the lever on the side of the
seatback and fold it down.
16X188c
2. Pull the lever under the seat cushion or pull the strap on
the rear end of the seat cushion and swing the whole seat
forward. 3. To return it to the original position, reverse the steps
above.
16x248a
If you cannot raise the seatback because of the locked seat
belt, do
not try it hard. Release the lock of the seat belt in the
following way.
1 Push in the lower front edge of the seatback cushion to
slacken the seat belt.
2Let the seat belt retract a little.
CAUTION
Do not sit on or place anything on the tumbled
seatback while driving.
Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback and
by trying to pull up the edge of the bottom cushion.
Failure to do so will prevent seat belt from operating
properly.
Page 132 of 493
OCCUPANT RESTRAINT SYSTEMS
11 0
Tumbling second seat
16X186b
Before tumbling the second seat, stow the second seat
buckles as shown in the illustration.
This prevents the buckles from falling out when you tumble the
second seat.
NOTICE
The seat belt buckles must be stowed before you tumble
the second seat.
16X646
1. Lower the head restraints to the lowest position, unlock
the seatback by pulling the lever on the side of the
seatback and fold it down.
16X188c
2. Pull the lever under the seat cushion or pull the strap on
the rear end of the seat cushion and swing the whole seat
forward.