light LEXUS LX470 2006 Owner's Manual

SWITCHES
33
FOG LIGHT SWITCH
12X014a
To turn on the fog lights, turn the switch to the “ON”
position. They will come on only when the headlights are
on low beam.
WINDSHIELD WIPER AND WASHERSWITCH
12x004g
 1Automatic control adjuster 2Washer on
To turn the wipers on, move the lever down until you reach
the desired speed setting.
The ignition switch must be in the “ON” position.
There are 3 settings:
“AUTO” position: Automatic operation
The wiper speed is determined by the amount of raindrops
detected by the windshield sensor (shown in the illustration),
and the vehicle speed.
“LO” position: Low speed operation
“HI” position: High speed operation

SWITCHES
35
To make the washer squirt, pull the lever toward you and
release it.
If the wiper lever is in the “OFF” position, the wipers will
automatically make 3 wipes and then a single wipe later to
sweep the windshield completely.* The interval between the
3 wipes and the last wipe will depend on the vehicle speed.
The last sweep does not happen if the vehicle speed exceeds
about 170 km/h (106 mph).
NOTE: *The last single wipe can be deactivated. Ask your
Lexus dealer for details.
The low washer fluid warning light in the instrument cluster
comes on when the fluid level in the tank becomes very low.
For information on adding washer fluid, see “Adding washer
fluid” on page 458.
In cold weather, warm the windshield with the defroster before
using the washer. This will help prevent icing, which could
block your vision.
The rear window and outside rear view mirror defogger
automatically turns on when you operate the wipers.
NOTICE
Do not operate the wipers if the windshield is dry. It may
scratch the glass.
When waxing your vehicle, make sure the washer nozzles do
not become blocked. If a nozzle becomes blocked, contact
your Lexus dealer to have the vehicle serviced.
NOTICE
If a nozzle becomes blocked, do not try to clear it with
a pin or other object. The nozzle will be damaged.

SWITCHES
36
REAR WINDOW WIPER ANDWASHER SWITCH
12X009b
 1Washer on during wiping 2Washer on
To turn the wipers on, twist the knob at the end of the lever.
The ignition key must be in the “ON” position.
There are 2 settings:
“LO” position: Intermittent operation
“HI” position: Normal operation
If you stop the vehicle with the rear window wiper switch in the
“ON” position, the wiper speed automatically changes from low
speed to intermittent operation speed. If you shift the selector lever
to the “R” position while the
windshield wipers are operating or for 17 seconds after the
windshield wipers stop operating, the rear window wiper will
activate once.*
NOTE: *This feature can be deactivated. Ask your Lexus
dealer for details.
To make the washer squirt, twist the knob downward to
position 2.
The rear wiper will automatically make 3 wipes and then a
single wipe later to sweep the rear window completely.
To make the washer squirt while operating in “ON”
position, twist the knob upward to position 1.
The knob automatically returns from these positions after you
release it.
If the rear window wiper is off, it will operate a couple of times
after the washer squirt.
The low washer fluid warning light in the instrument cluster
comes on when the fluid level in the tank becomes very low.
For information on adding washer fluid, see “Adding washer
fluid” on page 458.
NOTICE
Do not operate the rear window wiper if the rear window
is dry. It may scratch the glass.

SWITCHES
37
HEADLIGHT CLEANER SWITCH(CANADA ONLY)
12X015d
To spray fluid on the headlights, push the switch with the
headlights on.
The ignition key must be in the “ON” position.
The low washer fluid warning light in the instrument cluster
comes on when the fluid level in the tank becomes very low.
For information on adding washer fluid, see “Adding washer
fluid” on page 458.
NOTICE
Do not turn the headlight cleaner on with the washer
fluid tank empty. It may cause the cleaner motor to
overheat.
REAR WINDOW DEFOGGER SWITCH
12X514a
To turn the electric rear window defogger on, push the
switch.
The ignition key must be in the “ON” position.
The thin heater wires on the inside of the rear window will
quickly clear the surface. An indicator light will illuminate to
indicate the defogger is operating.
The system will automatically shut off when the defogger has
operated about 15 minutes.
If further defrosting or defogging is desired, simply actuate the
switch again. When the surface has cleared, push the switch
once again to turn the defogger off. Continuous use may cause
the battery to discharge, especially during stop− and−go
driving. The defogger is not designed to dry rain water or to
melt snow.

SWITCHES
38
NOTICE
When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires or
connectors.
 To prevent the battery from being discharged, turn
the switch off when the engine is not running.
OUTSIDE REAR VIEW MIRROR
DEFOGGER SWITCH
12X500a
To turn the electric outside rear view mirror defogger on,
push the switch.
The ignition key must be in the “ON” position.
The thin heater wires on the heater panels in the outside rear
view mirrors will quickly clear the surface. Keep your hands off
the mirror faces when the switch is on. An indicator light will
illuminate to indicate the defogger is operating.
The system will automatically shut off when the defogger has
operated about 15 minutes.

SWITCHES
40
12L010
Operating the switches
To raise or lower the window, pull the switch halfway up
or push it halfway down.
Automatic operation: To fully raise or lower the window
automatically, pull the switch fully up or push it fully down.
To stop the window partway, lightly push or pull the switch in
the opposite direction and then release it.
Operating the window lock switch
12X007g
 Indicator light
With the window lock switch pressed in, only the driver’s
window can be raised or lowered.
The indicator lights on the switch tell you which of the switches
can be operated.
Even with the window lock switch pressed in, the windows will
be opened from outside the vehicle using an ignition key or
wireless remote control.

SWITCHES
43
CAUTION
To avoid serious personal injury, you must do the
following.
Always make sure the hands and other parts of the
bodies of all occupants are kept completely inside
the vehicle before you close the power quarter
windows. If someone’s hands get caught in a closing
window, it could result in a serious injury. When
anyone closes the power quarter windows, make
sure he/she operates the windows safely.
 When small children are in the vehicle, never let them
use the power rear quarter window switches without
supervision.
 Be sure to remove the ignition key when you leave
your vehicle.
 Never leave anyone (particularly a small child) alone
in your vehicle, especially with the ignition key still
inserted. Otherwise, he/she could use the power
quarter window switches and get trapped in a
window. Unattended person (particularly a small
child) can be involved in a serious accident.
EMERGENCY FLASHER SWITCH
12X503a
To turn on the emergency flashers, push the switch. To
turn them off, push the switch again.
All the turn signal lights will flash. The emergency flashers will
work with the engine running or off and with or without the
ignition key.
Turn on the emergency flashers to warn other drivers if you
must stop your vehicle where it might be a traffic hazard.
Always pull your vehicle as far off the road as possible.
The turn signal light switch will not work when the emergency
flashers are in operation.
NOTICE
To prevent the battery from being discharged, do not
leave the switch on longer than necessary when the
engine is not running.

SWITCHES
44
SEAT HEATER SWITCHES
12X025c
 1For driver’s seat 2For front passenger’s seat
3High heating temperature
4Low heating temperature
To turn on the seat heater, push the switch to “HI” (high
temperature) or “LO” (low heating temperature). To turn
off the seat heater, push the switch lightly on the opposite
side. At this time, the indicator light on either side will
illuminate to indicate the seat heater is operating.
The ignition key must be in the “ON” position to operate seat
heaters.
CAUTION
Occupants must use caution when operating the seat
heater because they may experience minor burns even
at low temperatures. Use extra caution for;
 Babies, small children, elderly persons, sick persons
or persons with physical disabilities
 Persons who have sensitive skin
 Persons who are exhausted
 Persons who have taken alcohol or drugs which
induce sleep (sleeping drug, cold remedy, etc.).
To prevent the seat from overheating, do not use the
seat heater with a blanket, cushion, or other insulating
objects which cover the seat.
NOTICE
 Do not put unevenly weighted objects on the seat and
do not stick sharp objects (needles, nails, etc.) into
the seat.
 When cleaning the seats, do not use organic
substances (paint thinner, benzine, alcohol,
gasoline, etc.). They may damage the heater and seat
surface.
 To prevent the battery from being discharged, turn
the switches off when the engine is not running.

SWITCHES
45
ROLL SENSING OF CURTAIN
SHIELD AIRBAGS OFF SWITCH
12x600a
The roll sensing of curtain shield airbags off switch can
turn off the curtain shield airbags and front seat belt
pretensioners in a vehicle rollover. This switch should
only be used in a situation where the inflation is not
desired (such as during extreme offroad driving).
When you push the roll sensing of curtain shield airbags off
switch for a few seconds with the ignition switch on, the roll
sensing of curtain shield airbags off indicator light comes on
and the roll sensing function is turned off. When you push the
switch again, the indicator light goes off and the roll sensing
function is turned on. In a severe side impact, the
curtain shield airbag on the
impacted side will inflate even if the roll sensing function is
turned off.
If the ignition switch is turned to “ACC” or “LOCK” with the r\
oll
sensing function off and then the ignition switch is turned back
to “ON”, the roll sensing function will be back on automatically.
For details, see “Seat belt pretensioners” on page 130 or “SRS
side airbags and curtain shield airbags” on page 144.
CAUTION
 Make sure the roll sensing of curtain shield airbags
off indicator light is not on.
 When the roll sensing of curtain shield airbags off
switch is turned on (and the roll sensing of curtain
shield airbags off indicator light is on), the curtain
shield airbags and front seat belt pretensioners will
not inflate in a vehicle rollover. Turning off the curtain
shield airbags can reduce the occupant protection
which your vehicle safety systems can provide to you
in certain accidents and increase the likelihood of
death or serious injuries.

SECTION 1 – 3
47
INSTRUMENTS AND CONTROLS
Gauges, meters and service reminder
indicators
Fuel gauge48
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . .
Engine coolant temperature gauge 48
. . . . . . . . . . . . . . . . . . . . . . . . . .
Engine oil pressure gauge 49
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Voltmeter 50
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . .
Tachometer 51
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . .
Odometer and trip meter 51
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service reminder indicators and warning buzzers 52
. . . . . . . . . . . . . .
Trip information display 63
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Instrument panel light control 66
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .