check engine LEXUS LX470 2006 Service Manual

ENGINE
410
CHECKING THE ENGINE OIL LEVEL
62X001e
With the engine at operating temperature and turned off,
check the oil level on the dipstick.
1. To get a correct reading, the vehicle should be on level
ground. After turning off the engine, wait a few minutes for the
oil to drain back into the bottom of the engine.
2. Pull the dipstick out, hold a rag under the end and wipe it
clean.
3. Standing up on the left side of the vehicle, reinsert the
dipstick in the direction so that the “ENGINE OIL” on top should
be read correctly and push it in as far as it will go, or the reading
will not be correct.
62X004d
 1 Add oil 2O.K. 3Too full
4. Pull the dipstick out and look at the oil level while holding a
rag under the end. If it is between the full line (
5 ) and the
low line ( 4 ), it is O.K.
NOTICE
Be careful not to drop engine oil on the vehicle
components.

ENGINE
411
62X002c
If the oil level is below or only slightly above the low line,
add engine oil of the same type as already in the engine.
Remove the oil filler cap and add engine oil a little at a time,
checking the dipstick. We recommend that you use a funnel
when adding oil. The approximate quantity of oil needed to
raise the level between low and full on the dipstick is indicated
as follows.
1.5 L (1.6 qt., 1.3 lmp. qt.)
For the engine oil capacity, see “Specifications” on page 402.
When the level reaches within the correct range, return the
filler cap and turn the cap clockwise until you hear a click.
NOTICE
 Be careful not to spill engine oil on the vehicle
components.
 Avoid overfilling, or the engine could be damaged.
 Check the oil level on the dipstick once again after
adding the oil.

ENGINE
413
CHECKING THE ENGINE COOLANTLEVEL
62X003d
 1Radiator cap 2“FULL” line 3“LOW” line
Look at the seethrough coolant reservoir when the
engine is cold. The coolant level is satisfactory if it is
between the“FULL” and “LOW” lines on the reservoir. If
the level is low, add the coolant. (For the coolant type, see
“Coolant type selection” described below.)
The coolant level in the reservoir will vary with engine
temperature. However, if the level is on or below the “LOW”
line, add coolant. Bring the level up to the “FULL” line. If the coolant level drops within a short time after replenishing,
there
may be a leak in the system. V isually check the radiator,
hoses, engine coolant filler cap, radiator cap and drain cock
and water pump.
If you can find no leak, have your Lexus dealer test the radiator
cap pressure and check for leaks in the cooling system.
CAUTION
To prevent burning yourself, do not remove the radiator
cap when the engine is hot.

ENGINE
414
Coolant type selection
Use of improper coolants may damage your engine cooling
system.
Only use “Toyota Super Long Life Coolant” or similar high
quality ethylene glycol based non−silicate, non −amine,
non− nitrite, and non −borate coolant with long −life hybrid
organic acid technology. (Coolant with long −life hybrid organic
acid technology is a combination of low phosphates and
organic acids.)
For the U.S.A.—“Toyota Super Long Life Coolant” is a mixture
of 50% coolant and 50% deionized water. This coolant
provides protection down to about –35 C (–31F).
For Canada—“Toyota Super Long Life Coolant” is a mixture of
55% coolant and 45% deionized water. This coolant provides
protection down to about –42 C (–44F).
NOTICE
Do not use plain water alone.
Lexus recommends “Toyota Super Long Life Coolant”, which
has been tested to ensure that it will not cause corrosion nor
result in malfunction of your engine coolant system with proper
usage. “Toyota Super Long Life Coolant” is formulated with
long−life hybrid organic acid technology and has been
specifically designed to avoid engine cooling system
malfunction on Lexus vehicles.
Please contact your Lexus dealer for further details.
CHECKING THE RADIATOR AND CONDENSER
If either of the above parts are extremely dirty or you are not
sure of their condition, take your vehicle to a Lexus dealer.
CAUTION
To prevent burning yourself, be careful not to touch the
radiator or condenser when the engine is hot.
NOTICE
To prevent damage to the radiator and condenser, do
not perform the work by yourself.

CHASSIS
422
CHECKING POWER STEERINGFLUID
63X002a
Check the fluid level on the dipstick. If necessary, add
automatic transmission fluid DEXRONII or III .
If the vehicle has been driven around 80 km/h (50 mph) for 20
minutes (a little more in frigid temperatures), the fluid is hot
(60 C − 80C or 140F − 175F). You may also check the level
when the fluid is cold (about room temperature, 10 C − 30C
or 50F − 85F) if the engine has not been run for about five
hours.
63X003a
 1 If hot O.K. 2If hot add 3If cold O.K.
4If cold add
Clean all dirt off the reservoir and look at the fluid level. If the
fluid is cold, the level should be in the “COLD” range. Similarly,
if it is hot, the fluid level should be in the “HOT” range. If th\
e
level is at the low side of the appropriate range, add automatic
transmission fluid DEXRON
II or III to bring the level within
the range.
To remove the reservoir cap, turn it counterclockwise and lift
up. To reinstall it, turn it clockwise. After replacing the reservoir
cap, visually check the steering box case, vane pump and hose
connections for leaks or damage.
CAUTION
The reservoir may be hot so be careful not to burn
yourself.

CHASSIS
423
NOTICE
Avoid overfilling, or the power steering could be
damaged.
 When adding the power steering fluid, avoid spilling
it. The generator under the power steering reservoir
could be damaged if fluid is spilled on it.
CHECKING SUSPENSION FLUID
AHC
63X007c
 1“MAX” line 2“MIN” line
Under the unloaded condition, check the Suspension
Fluid AHC in the following way.
1. Start the engine and put the vehicle height in the “LO” (Low)
mode and then “N” (Normal) mode.
2. Turn off the ignition switch about 30 seconds after the “N”
(Normal) mode indicator light comes on.
3. Make sure the fluid level is between “MAX” and “MIN”.
If the fluid level is lower than “MIN”, have suspension fluid AHC
filled by your Lexus dealer.

CHASSIS
424
NOTICE
Only use the Suspension fluid AHC for the active height
control suspension. If you fill other fluids such as brake
fluid, power steering fluid, engine oil, etc., the active
height control suspension could be damaged.
CHECKING TIRE INFLATION PRESSURE
63x600b
 Type A

ELECTRICAL COMPONENTS
452
NOTICE
Make sure the engine and all accessories are turned
off before performing maintenance.
 When checking the battery, remove the ground cable
first and reinstall it last.
 Be careful not to cause a short circuit with tools.
 Take care no solution gets into the battery when
washing it.
If the battery terminal is disconnected or the battery is run
down...
 The variable gear ratio steering system is reset temporarily
and “VGRS” warning light flashes after you reconnect the
battery terminal. In this case, you should turn off the light
and return the system to normal. To return the system to
normal, see “Variable gear ratio steering system” on page
293.
 The moon roof may not operate automatically and the jam
protection function will not operate correctly after you
reconnect, replace or recharge the battery with the moon
roof slide −opened or tilted up. In any of these cases, you
should return the moon roof to normal. To return the moon
roof to normal, see “Moon roof” on page 95.
Checking battery condition
(a) Checking by fluid level lines
64X005c
 1 Upper line 2Lower line
The fluid (electrolyte) level must be between the upper and
lower lines.
When checking the fluid level, look at all six cells, not just one
or two.
If the level is lower than the lower line, have the battery
checked by your Lexus dealer.

ELECTRICAL COMPONENTS
453
(b) Checking by indicator
64X006a
Check the battery condition by the indicator color.
1
BLUE − Good condition.
2
WHITE − Charging necessary. Have the battery checked
by your Lexus dealer.
3 RED − Have the battery checked by your Lexus dealer.
NOTICE
Do not refill the battery with water.
BATTERY RECHARGING
PRECAUTIONS
During recharging, the battery is producing hydrogen
gas.
Therefore, before recharging:
1. If recharging with the battery installed on the vehicle, be
sure to disconnect the ground cable.
2. Make sure the power switch on the recharger is off when
connecting the charger cables to the battery and when
disconnecting them.
CAUTION
Always charge the battery in an unconfined area. Do
not charge the battery in a garage or closed room
where there is not sufficient ventilation.
 Only do a slow charge (5 A or less). Charging at a
quicker rate is dangerous. The battery may explode
causing personal injuries.
NOTICE
Never recharge the battery while the engine is running.
Also, make sure all accessories are turned off.

ELECTRICAL COMPONENTS
454
CHECKING AND REPLACING THEBLADE TYPE FUSES
64X008a
Engine compartment
1
Spare fuses 2Pullout tool
64X007b
Driver’s side kick panel
64X503
Passenger’s side kick panel
1. Turn the ignition switch off and open the fuse box lid.
Determine which fuse may be causing the problem. The lid of
the fuse box shows the name of the circuit for each fuse.