LEXUS NX250 350 2023 Owners Manual

SettingusingthecurrenttireinflationpressureWARNINGMake sure to adjust the tire inflation pressure of each tire to the appropriate level before
performing tire pressure setting. Otherwise, the tire pressure warning light may not
illuminate even if the tire inflation pressure drops or may illuminate even though the tire inflation pressure is normal.INFORMATION

INFORMATION

5Select [Tire pressure@.
6 Check if the desired wheel set ([Set 1@ or [Set
2@) is displayed.
ID codes will be registered to the displayed wheel
set.
To change the wheel set to be registered, select
the displayed set, and then select the wheel set
you wish to register.
If ID codes have already been registered for that wheel set, the tire pressure warning light will slowly blink 3 times, and a message
indicating that change is occurring will be displayed on the multi-information display.
7 Select [New tire registration@.
8 Select [Continue@.
The tire pressure warning light will slowly blink 3
times and a message indicating that ID code reg-
istration is being performed will be displayed on
the multi-information display. Wheel set changing
will be canceled and registration will begin.
When registration is being performed, the tire
pressure warning light will blink for approximately
1 minute then illuminate and "---" will be displayed for the inflation pressure of each tire
on the multi-information display.INFORMATIONIf the tire pressure warning light does not blink 3 times when starting ID code
registration procedure, the procedure may not have started. Perform the procedure
again from the beginning.
9 Drive straight (with occasional left and right turns) at approximately 25 mph
(40 km/h) or more for approximately 10 to 30 minutes.
When registration is complete, the tire pressure warning light will turn off and a
message indicating that registration has been completed will be displayed on the
multi-information display.
Registration may take longer than normal to complete if the vehicle speed cannot be
maintained at approximately 25 mph (40 km/h) or more. If registration cannot be
completed after driving for 1 hour or more, perform the registration procedure again from the beginning.
8-5.Tiremaintenance
5418
Maintenance and care

INFORMATION

If the warning light does not turn off, ID code registration may not have been cancelled
correctly. To cancel registration, select [ New tire registration@ again on the center display.
Selectingwheelset
Your vehicle is equipped with a tire pressure warning system with a function to
register two sets of ID codes. This allows for registration of a second wheel set, for example a winter set.

7If the specified tire inflation pressure of the wheel set installed differs from that
of the previous set, it will be necessary to perform the tire inflation pressure
setting procedure of the tire pressure warning system.
If the specified tire inflation pressure is the same, it will not be necessary to perform the
tire inflation pressure setting procedure.
8 Register the position of each wheel.
RelatedLinks
Registration of the position of each wheel after performing a tire rotation(P. 536)
8-5.Tiremaintenance
544

Checkingtireinflationpressure
You should check tire inflation pressure every two weeks, or at least once a
month.Do not forget to check the spare.WARNINGIn order to ensure the performance of the tires, maintain proper tire inflation pressure.
If the tires are not properly inflated, the following may occur:

Liftingthevehiclewithafloorjack
When using a floor jack, follow the instructions in the manual provided with the
jack and perform the operation safely.When raising your vehicle with a floor jack,
position the jack correctly.Improper placement may damage your vehicle or cause
injury.
Frontjackpointposition
Rearjackpointposition
8-5.Tiremaintenance
5478
Maintenance and care

Rotatingthetires
To equalize tire wear and extend tire life, Lexus recommends that tire rotation be
performed at the same interval as tire inspection.
Rotate the tires as shown in the illustration.
Make sure to perform wheel position registration procedure after rotating the tires. A
Front
RelatedLinks
Registration of the position of each wheel after performing a tire rotation(P. 536)
8-5.Tiremaintenance
548