LEXUS NX250 350 2023 Owners Manual

CScrewdriver
Emergencytirepuncturerepairkitdetails/nameofeachpart
WARNING

RepairingaflattireWARNINGObserve the following when repairing a flat tire.

NOTICEas possible. After use of liquid sealant, make sure to replace the tire pressure warningvalve and transmitter when repairing or replacing the tire.
1 Take out the emergency tire puncture repair kit.
2 Remove the valve cap from the valve of the punctured tire.
3Extend the hose. Remove the air release cap from the hose.
Attach the sticker enclosed with the bottle on the specified locations.(See step 10.)
The air release cap may be used later. Therefore keep it in a safe place.
4 Connect the hose to the valve of the flat tire.
Screw the end of hose clockwise as far as possible.
9-4.Ifatireisflat
6039
When trouble arises

WARNINGCheck the following.

9Connect the bottle to the compressor.
As shown in the illustration, insert the bottle securely into the compressor until the
upper side of the mark on the bottle is aligned with the upper end of the notch.
10 Attach the sticker provided with the tire puncture repair kit to a position easily
seen from the driver
s seat.
A
U.S.A.
9-4.Ifatireisflat
6059
When trouble arises

BCanadaWARNINGDo not attach the vehicle speed warning sticker to an area other than the one
indicated. If the sticker is attached to an area where an SRS airbag is located, such as the pad of the steering wheel, it may prevent the SRS airbag from operating properly.
11 Check the specified tire inflation pressure.
Tire inflation pressure is specified on the label as shown.
12 Start the engine.
13 To inject the sealant and inflate the tire, turn the compressor switch on.
WARNINGObserve the following precautions.

WARNING

WARNINGAfter inflation of the tire has completed, the sealant may splatter when the hose isdisconnected or some air is let out of the tire.
16 Install the valve cap onto the valve of the emergency repaired tire.
17 Attach the air release cap to the end of the hose.
If the air release cap is not attached, the sealant may leak and dirty the interior of the
vehicle or ones clothes.
18 Temporarily store the bottle in the luggage compartment while it is connected
to the compressor.
19 To spread the liquid sealant evenly within the tire, immediately drive safety for
about 3 miles (5 km) below 50 mph (80 km/h).
WARNINGObserve the following precautions when driving to spread the sealant evenly.