height LEXUS NX300h 2015 User Guide
Page 578 of 681
578 8-2. Steps to take in an emergency
NX300h_U_OM78007U WA R N I N G ■
Using the tire jack
Observe the following precautions.
Improper use of the tire jack may cause the vehicle to suddenly fall off the jack, leading
to death or serious injury. ●
Do not use the tire jack for any purpose ot her than replacing tires or installing and
removing tire chains. ●
Only use the tire jack that comes with this vehicle for replacing a flat tire.
Do not use it on other vehicles, and do not use other tire jacks for replacing tires on
this vehicle. ●
Put the jack properly in its jack point. ●
Do not put any part of your body under the vehicle while it is supported by the jack.●
Do not start the hybrid system or drive the vehicle while the vehicle is supported by
the jack. ●
Do not raise the vehicle while someone is inside. ●
When raising the vehicle, do not pu t an object on or under the jack.●
Do not raise the vehicle to a height greater than that required to replace the tire. ●
Use a jack stand if it is necessary to get under the vehicle. ●
When lowering the vehicle, make sure that there is no-one near the vehicle. If there
are people nearby, warn them vocally before lowering.
Page 608 of 681
608 9-1. Specifications
NX300h_U_OM78007UMaintenance data (fuel, oil level, etc.)
* 1
: Unladen vehicle
* 2
: Vehicles with towing packageDimensions and weight Overall length 182.3 in. (4630 mm)
Overall width 72.6 in. (1845 mm)
Overall height
* 1
64.8 in. (1645 mm)
Wheelbase 104.7 in. (2660 mm)
Tr e a d Front 62.2 in. (1580 mm)
Rear 62.2 in. (1580 mm)
Vehicle capacity weight
(Occupants + luggage) 895 lb. (405 kg)
Trailer Weight Rating
* 2
(Trailer weight + cargo weight) 1500 lb. (685 kg)
Page 624 of 681
624 9-1. Specifications
NX300h_U_OM78007U ■
Typical tire size information
The illustration indicates typical tire size.
Ti r e u s e
(P = Passenger car,
T = Temporary use)
Section width (millimeters)
Aspect ratio
(tire height to section width)
Tire construction code
(R = Radial, D = Diagonal)
Wheel diameter (inches)
Load index (2 digits or 3 digits)
Speed symbol (alphabet with one letter)■
Tire dimensions
Section width
Tire height
Wheel diameterTire size 1
2
3
4
5
6
7
1
2
3
Page 641 of 681
6419-2. Customization
9
Vehicle specifications
NX300h_U_OM78007U ■
Power back door
* 1
( P. 1 2 9 )
* 1
: If equipped
* 2
: Configured by operating the switch of the lower back door. ( P. 1 3 2
* 3
: While carrying the electronic key on your person, press the back door opener switch. ■
Vehicle customization ●
When the speed linked door locking functi on and shift position linked door locking
function are both on, the door lock operates as follows.
• When shifting the shift lever to any position other than P, all th e doors will be locked.
• If the vehicle is started with all the door s locked, the speed linked door locking func-
tion would not operate.
• If the vehicle is started with any door un locked, the speed linked door locking func-
tion will operate. ●
When the smart access system with push-but ton start is off, smart door unlocking can-
not be customized. ●
When the doors remain closed after unloc king the doors and the automatic door lock
function is activated, the signals will be generated in accordance with the Operation
signal (buzzer) and the Operation signal (emergency flashers) settings. ■
In the following situations, customize mo de in which the settings can be changed
through the multi-in formation display will automatically be turned off.●
A warning message appears after the cu stomize mode screen is displayed.●
The power switch is turned off. ●
The vehicle begins to move while the customize mode screen is displayed.Function Default
setting Customized
setting
Set at the desired Position
(height)
* 2
Back Door Automatic
Open and Stop Position Initial settings
Po s i t i o n Stop at the
desired position
(height) – – – O
5 step configuration
Back Door Automatic
Open and Stop Position 5 1 to 5 O – O –
Back door opener switch
operations When the back
door is locked
* 3
When the back
door is unlocked – – O –
Power back door operations On Off – O – – 1 2 3 4