LEXUS NX300h 2022 Owners Manual

NOTICETo prevent serious engine damage, check the oil level on a regular basis.
1Park the vehicle on level ground. After warming up the engine and turning off
the hybrid system, wait more than 5 minutes for the oil to drain back into the
bottom of the engine.
2 Holding a rag under the end, pull the dipstick
out.
3 Wipe the dipstick clean.
4 Reinsert the dipstick fully.
5 Holding a rag under the end, pull the dipstick out and check the oil level.

A
Low
B
Normal
C
Excessive
The shape of the dipstick may differ depending on
the type of vehicle or engine.
6 Wipe the dipstick and reinsert it fully.
Checkingtheoiltypeandpreparingtheitemsneeded
Make sure to check the oil type and prepare the items needed before adding oil.

Addingengineoil
If the oil level is below or near the low level mark, add engine oil of the same type as
that already in the engine.
1 Remove the oil filler cap by turning it counterclockwise.
2 Add engine oil slowly, checking the dipstick.
3 Install the oil filler cap by turning it clockwise.
Checkingthecoolant
The coolant level is satisfactory if it is between the [ FULL@ and [ LOW@ lines on the
reservoir when the hybrid system is cold.

INFORMATION

WARNING

3Remove the reservoir cap.
4 Add brake fluid slowly while checking the fluid level.
Make sure to check the fluid type and prepare the necessary item.

Addingwasherfluid
If washer fluid does not spray from any of the
washers or "Windshield Washer Fluid Low" is
displayed on the multi-information display, the
washer fluid bottle may be empty. Add washer
fluid.WARNINGDo not add washer fluid when the hybrid system is hot or operating.
As washer fluid contains alcohol, it may catch fire if spilled on the engine, etc.NOTICE

12-voltbattery
12-voltbatterylocation
WARNING

The 12-volt battery is located on the left side of
luggage compartment.
Removingthe12-voltbatterycover
1 Open the deck board.
2 Remove the 12-volt battery cover.
Checkingthe12-voltbattery

NOTICEWhen recharging the 12-volt battery, make sure that the hybrid system is operating and
all accessories are off.
Afterrechargingorreconnectingthe12-voltbattery
The hybrid system may not start. Follow the procedure below to initialize the
system.
1 Change the shift position to P.
2 Open and close any of the doors.
3 Restart the hybrid system.
INFORMATION

Airconditioningfiltermaintenance
The air conditioning filter must be changed regularly to maintain air conditioning
efficiency.
Checkinginterval
Inspect and replace the air conditioning filter according to the maintenance sched-
ule. In dusty areas or areas with heavy traffic flow, early replacement may be
required.