LEXUS NX300h 2022 Owners Manual

3Push both the sides of the glove box inward
and disengage each claw on the upper side.
Then, pull the glove box to disengage the
claws on the lower side and remove the glove box.
4 Unlock the filter cover (
), pull the filter
cover out of the claws (
), and remove the
filter cover.
5 Remove the filter case.
6 Remove the air conditioning filter from the
filter case and replace it with a new one.
The [
UP @ marks shown on the filter should be
pointing up.
8-4.Inspectionofconsumables5698
Maintenance and care

Tiremaintenance
Tiremaintenance
Replace or rotate tires in accordance with maintenance schedules and treadwear.NOTICETake particular care when driving on uneven rough roads with cracks and potholes. These conditions may cause loss of tire inflation pressure, reducing the cushioning ability of the tires. Driving on rough roads may also cause damage to the tires themselves, as
well as the vehicle
s wheels and body.
8-5.Tiremaintenance570

TireinspectionitemsWARNING

INFORMATION

originally installed tires. Since your vehicle has radial tires as original equipment, make
sure your snow tires also have radial construction. Do not install studded tires without
first checking local regulations for possible restrictions.
Snow tires should be installed on all wheels.

Run-flattirefeatures*
When run-flat tires are installed, the vehicle can be driven for a maximum of 50 miles (80 km) at a speed below 50 mph (80 km/h) after any tire goesflat. (However, the vehicle speed may not increase to near 50 mph [80 km/h@
depending on weather or driving conditions.)
Make sure to replace the flat tire before the vehicle has been driven for near 50
miles (80 km). Also, do not use a repaired tire.
A run-flat tire has a
mark on the side wall.
INFORMATION

Operationofthetirepressurewarningsystem
Your vehicle is equipped with a tire pressure warning system that uses tire pressure
warning valves and transmitters to detect low tire inflation pressure before serious
problems arise.
The tire pressure warning system of this vehicle adopts a 2-type warning system.

RTire chains, etc. are equipped.
R If a window tint that affects the radio wave signals is installed.
R If there is a lot of snow or ice on the vehicle, particularly around the wheels or wheel
housings
R If the tire inflation pressure is extremely higher than the specified level.
R If tires not equipped with tire pressure warning valves and transmitters are used.
R If the ID code on the tire pressure warning valves and transmitters is not registered
in the tire pressure warning computer.

NOTICE

7Select [Continue@.
A message indicating that wheel position registration is being performed will be
displayed on the multi-information display. "---" will be displayed for the tire inflation
pressure of each tire and wheel position registration will begin.
8 Drive straight (with occasional left and right turns) at approximately 25 mph
(40 km/h) or more for approximately 10 to 30 minutes.
When wheel position registration is complete, a message indicating that registration
has been completed and the inflation pressure of each tire will be displayed on the
multi-information display.
Even if it is not possible to drive continuously at approximately 40 km/h (25 mph) or
more, registration can be completed by driving for a long time. However, if registration does not complete after driving for 1 hour or more, park the vehicle in a safe place and
leave it with the power switch in ON for approximately 15 minutes or more, and then perform the driving procedure again.
Even if it is not possible to drive continuously at approximately 25 mph (40 km/h) or
more, registration can be completed by driving for a long time. However, if registration does not complete after driving for 1 hour or more, park the vehicle in a safe place and
leave it with the power switch in ON for approximately 15 minutes or more, and then perform the driving procedure again.INFORMATION