LEXUS NX300h 2022 Owners Manual

BCanadaWARNINGDo not attach the vehicle speed warning sticker to an area other than the one
indicated. If the sticker is attached to an area where an SRS airbag is located, such as the pad of the steering wheel, it may prevent the SRS airbag from operating properly.
11 Check the specified tire inflation pressure.
Tire inflation pressure is specified on the label as shown.
12 Start the hybrid system.
13 To inject the sealant and inflate the tire, turn the compressor switch on.
WARNINGObserve the following precautions.

WARNING

WARNINGAfter inflation of the tire has completed, the sealant may splatter when the hose isdisconnected or some air is let out of the tire.
16 Install the valve cap onto the valve of the emergency repaired tire.
17 Attach the air release cap to the end of the hose.
If the air release cap is not attached, the sealant may leak and dirty the interior of the
vehicle or ones clothes.
18 Temporarily store the bottle in the luggage compartment while it is connected
to the compressor.
19 To spread the liquid sealant evenly within the tire, immediately drive safety for
about 3 miles (5 km) below 50 mph (80 km/h).
WARNINGObserve the following precautions when driving to spread the sealant evenly.

21Turn the compressor switch on and wait for several seconds, then turn it off.
Check the tire inflation pressure.
A
If the tire inflation pressure is below 19 psi (130 kPa, 1.3 kgf/cm 2
or bar): The
puncture cannot be repaired. Contact your Lexus dealer.
B
If the tire inflation pressure is between 19 psi (130 kPa, 1.3 kgf/cm 2
or bar) and a
point below the specified level: The tire can be repaired. Proceed to step 22.
C
If the tire inflation pressure is at the specified level: Proceed to step 23.
Even if the tire inflation pressure is at the recommended level, the tire pressure warning light may come on/flash.
22 Turn the compressor switch on to inflate the tire until the specified tire inflation
pressure is reached. Drive for about 3 miles (5 km) and then perform step 20.
23 Attach the air release cap to the end of the hose.
If the air release cap is not attached, the sealant may leak and dirty the interior of the
vehicle or ones clothes.
9-4.Ifatireisflat662

24Store the bottle in the luggage compartment while it is connected to the
compressor.
25 Taking precautions to avoid sudden braking, sudden acceleration and sharp
turns, drive carefully at under 50 mph (80 km/h) to your Lexus dealer that is less than 100 km (62 miles) away for tire repair or replacement.
When having the tire repaired or replaced, make sure to tell the Lexus dealer that the sealant is injected.
After using the emergency tire puncture repair kit, have the vehicle inspected and the
tire pressure warning valve and transmitter replaced by your Lexus dealer. Otherwise
the tire inflation pressure may not be able to be measured correctly.
RelatedLinks
Function and operation of the power outlet (12 VDC)(P. 285)
Checking the specified tire inflation pressure(P. 587)
Decreasingthetireinflationpressurewhenatireisoverinflated
1 Disconnect the hose from the valve.
2 Install the air release cap to the end of the hose and push the protrusion on the
air release cap into the valve to let some air out.
3 Disconnect the hose from the valve, remove the air release cap from the hose
and then reconnect the hose.
4 Turn the compressor switch on for a few seconds and then turn it off and check
the tire inflation pressure.
If the air pressure is lower than the specified level, turn the compressor switch on again and repeat the inflation procedure until the specified pressure is reached.
9-4.Ifatireisflat6639
When trouble arises

Precautionsforwhenyouhaveaflattire(vehicleswithrun-flattires)
Your vehicle is not equipped with a spare tire, but instead you can continue driving the vehicle with run-flat tires even if any tire goes flat. In this case, slow down and
drive with extra caution.
Take your vehicle to the nearest Lexus dealer or authorized tire dealer as soon as
possible if any tire goes flat.
The vehicle can be driven for a maximum of 50 miles (80 km) at a speed below
50 mph (80 km/h) after the tire pressure warning light comes on.
A run-flat tire has a
mark on the side wall.
INFORMATION

Ifadoorcannotbeopenedorlocked
IfakeyhasbeenlostNew genuine mechanical keys can be made by your Lexus dealer using another
mechanical key and the key number stamped on your key number plate.
Keep the plate in a safe place such as your wallet, not in the vehicle.NOTICEIf the electronic key remains lost, the risk of vehicle theft increases significantly. Visit your Lexus dealer immediately with all remaining electronic keys and the card key *
that were provided with your vehicle.* : If equipped
9-5.Ifadoorcannotbeopenedorlocked6659
When trouble arises

Whenthedoors/windows/moonroofcannotbeoperatedusinganelec-tronickey
If communication between the electronic key and vehicle is interrupted or the
electronic key cannot be used because the battery is depleted, the smart access
system with push-button start and wireless remote control cannot be used.
The smart access system with push-button start may have been disabled by a
customize setting.
In this case, change the customize setting to enable the smart access system
with push-button start.NOTICEWhen taking the vehicle to your Lexus dealer due to a malfunction of the smart access system with push-button start, make sure to bring all registered electronic keys
(including the card key).
The electronic key may have been set to battery saving mode.
battery saving mode has been set, cancel it.
The battery of the electronic key may be discharged.

INFORMATION

WARNING