fog light LEXUS RX330 2006 User Guide
Page 453 of 651
STARTING AND DRIVING
432If “E2” appears on the display,
the system may be having
trouble measuring the vehicle −to− vehicle distance because of
any of the following:
The wipers are operating at high or low speeds
Direct sunlight from the front
It is difficult to make a measurement because of bad
weather (such as rainy, foggy, or snowy weather)
Driving in “SNOW” mode
In the following cases, dynamic laser cruise control switches
to the ready mode:
The wipers are stopped or are switched to variable
intermittent operation.
No direct sunlight from the front
In the above conditions, push the lever up in the “+ RES”
direction and release it. Dynamic laser cruise control will be
restored. If the setting operation cannot be performed or if the
same code still appears even after the weather clears, the
system might have malfunctioned. Although there is no
problem to continue driving, please contact your Lexus dealer. If “E3” appears on the display,
a system malfunction has
been detected.
If this warning code appears, stop your vehicle in a safe place,
turn the ignition off, and then restart it to reset the system. If
the same code appears again or if the cruise control cannot be
set, the system may be malfunctioning. Although there is no
problem to continue driving, please contact your Lexus dealer.