lock LEXUS RX330 2006 Workshop Manual

INTERIOR EQUIPMENT
11 04. Continuously press and release (cycle) the hand
−held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
 changes from a
slow to a rapid flash after 20 seconds, you can release both
buttons.
6. Test the operation of the HomeLink
 by pressing the newly
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink

button to program another device.
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
dealer for assistance.
Reprogramming a button
Individual HomeLink buttons cannot be erased, however, to
reprogram a single button, follow the procedure “Programming
the HomeLink
”.
(b) Operating the HomeLink
To operate the HomeLink, press the appropriate HomeLink
button to activate the programmed device. The HomeLink
indicator light should come on. The HomeLink continues to
send the signal for up to 20 seconds as long as the button is
pressed.
(c) Erasing the entire HomeLink memory (all
three programs)
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
in the HomeLink
 memory.

INTERIOR EQUIPMENT
120
Removing luggage cover
To remove the luggage cover, lift it up after pushing
forward the lock release knobs on both sides.
You can stow the luggage cover in the auxiliary box in the
luggage compartment as shown in the illustration.
After removing the luggage cover, stow it in the auxiliary box
or place it somewhere other than the passenger compartment.
This will prevent passengers from being injured in the event of
a sudden stop or accident.

INTERIOR EQUIPMENT
121
FLOOR MAT
Use a floor mat of the correct size.
If the floor carpet and floor mat have 2 holes, then they are
designed for use with locking clips. Fix the floor mat with
locking clips into the holes in the floor carpet.CAUTION
Make sure the floor mat is properly placed on the floor
carpet. If the floor mat slips and interferes with the
movement of the pedals during driving, it may cause an
accident.

EXTERIOR EQUIPMENT
124
HOOD
1. To open the hood, pull the hood lock release lever under
the driverside instrument panel. The hood will spring up
slightly.
2. Insert your fingers under the hood, push up the
auxiliary catch lever and lift the hood.
Before closing the hood, check to see that you have not
forgotten any tools, rags, etc. Then lower the hood and make
sure it locks.
CAUTION
Before driving, be sure that the hood is closed and
securely locked. Otherwise, the hood may open
unexpectedly while driving and an accident may occur.

EXTERIOR EQUIPMENT
126
2. To remove the fuel tank cap, turn the cap
counterclockwise by 90 degrees (to the pressure point
1), and then turn it a additional 30 degrees (to point 2).
Pause slightly before removing it.
It is not unusual to hear a slight swoosh when the cap is
opened.
3. The removed cap can be stored on the back side of the
fuel filler door.
Position the cap so that the hooks point to the left and right, and
set it in the receptacle on the back side of the door.
When installing the cap, turn the cap clockwise until you
hear a click. When you hear the click, the cap is fully
closed.
If the cap is not tightened securely, the malfunction indicator
lamp comes on. Make sure the cap is tightened securely.
The indicator lamp goes off after driving several times. If the
indicator lamp does not go off, contact your Lexus dealer as
soon as possible.

EXTERIOR EQUIPMENT
129
1Tilt up2Tilt down
To tilt up the moon roof, push the “TILT” switch on the rear
side. The moon roof will fully tilt up. To stop partway, push
either side of the “TILT” switch.
To tilt down the moon roof, push the “TILT” switch on the
front side. The moon roof will fully tilt down. To stop
partway, push either side of the “TILT” switch. To operate the moon roof, the
ignition key must be in the “ON”
position.
If the moon roof is left open when you turn the ignition key to
the “ACC” or “LOCK” position and open the driver’s door, a
buzzer will remind you to close the moon roof.
Retained accessory power operation: Even if the ignition
key is turned to the “ACC” or “LOCK” position, the moon roof
can be operated until either front door is opened (or for 43
seconds).

EXTERIOR EQUIPMENT
130
Operating the moon roof from outside the
vehicle
The moon roof can be operated using an ignition key.*NOTE:
* This feature can be deactivated.
Ask your Lexus dealer for details.
 Close Open
Insert the ignition key into the key hole on the driver’s
door. To close the moon roof: Turn the key in the locking direction
and hold it.
After the doors are locked, the moon roof begins to close. To
stop in the middle, return the key.
To open the moon roof: Turn the key in the unlocking
direction and hold it.
After the door is unlocked, the moon roof begins to open. To
stop in the middle, return the key.
The moon roof also can be opened using the wireless remote
control. For details, see page 22.
Jam protection function

If something gets caught between the moon roof and frame
during slide closing operation, the moon roof stops and
opens half way.
 If something gets caught between the moon roof and frame
during tilting down operation, the moon roof stops and
opens fully.
If the moon roof receives a strong impact, this function may
work even if nothing is caught.

EXTERIOR EQUIPMENT
132
MOON ROOF (multipanel type)
To open the moon roof, push the slide control switch
toward the back. The front panel tilts up and the center
and rear panels fully open. To stop partway, push either
side of the slide control switch or the “TILT” switch briefly.
The sunshade can be opened or closed manually. However,
if you open the moon roof, the sunshade will be opened with
the moon roof.
Before opening the moon roof, make sure the radio antenna is
in the lock position. Otherwise, the antenna may get caught
between the moon roof and frame.
To close the moon roof, push the slide control switch
toward the front. The center and rear panels fully close.
Then push and hold the slide control switch toward the
front or the “TILT” switch on the front side until the front
panel is fully down. To stop partway, push either side of
the slide control switch or the “TILT” switch briefly.
The center and rear panels will not close automatically when
the center panel position is near its closed position. In this
case, push the slide control switch toward the front until the
panels fully close.

EXTERIOR EQUIPMENT
133
1Tilt up2Tilt down
To tilt up the front panel, push the “TILT” switch on the rear
side. The moon roof will fully tilt up. To stop partway, push
either side of the “TILT” switch or the slide control switch
briefly.
To tilt down the front panel, push and hold the “TILT”
switch on the front side or the slide control switch toward
the front until the panel is fully down. To operate the moon roof, the
ignition key must be in the “ON”
position.
If the moon roof is left open when you turn the ignition key to
the “ACC” or “LOCK” position and open the driver’s door, a
buzzer will remind you to close the moon roof.
Retained accessory power operation: Even if the ignition
key is turned to the “ACC” or “LOCK” position, the moon roof
can be operated until either front door is opened (or for 43
seconds).

EXTERIOR EQUIPMENT
136
ROOF LUGGAGE CARRIER
1Cross rails2Roof rails
The roof luggage carrier consists of roof rails and sliding
cross rails.
Adjusting the position of cross rails
1. Pull the lock rele ase lever up to release the cross rails.
You can release the cross rails by operating only the single side
lock release lever.