DVD LEXUS RX330 2006 Owners Manual

Page 287 of 651

AUDIO
266Vehicles with rear seat entertainment system —
The “DISC” button may also be used to operate a DVD player
when a
disc is loaded in the DVD player. Pressing the “DISC”
button changes between the CD player and DVD player. When
the DVD player is in operation, “AUX” appears on the display.
In the “TAPE” or “CD” mode, the applicable functions are
shown in the lowest part of the display. Push the switch
just below to turn on each function.
(b) Adjusting audio sounds
Your audio system can adjust tone and sound balance
or select the listening seat position.
How good an audio program sounds to you is largely
determined by the mix of the treble, mid−range, and bass
levels. In fact, different kinds of music and vocal programs
usually sound better with different mixes of treble, mid −range
and bass.

Page 300 of 651

AUDIO
279
(c) Searching for a desired track
Push the “SCAN” button briefly. “SCAN” will appear on the
display.
The CD player will play the next track for 10 seconds,
then scan again. To select a track, push the “SCAN” button a
second time. If the player reaches the end of the CD, it will
continue scanning at track 1.
After all the tracks are scanned in one pass, normal play
resumes. (d) Selecting a desired track“TRACK” button: Use for direct access to a desired track.
Push either
side of the “TRACK” button several times until the
desired track number appears on the display. As you release
the button, the player will start playing the selected track from
the beginning.
Vehicles with rear seat entertainment system —
While the DVD player is in operation, the chapter or track can
be changed by pushing the “ ” or “” side of the “TRACK”
button.
“Fast forward” button: Push the “” button and hold it to
fast forward the CD. When you release the button, the CD
player will resume playing from that position.
“Reverse” button: Push the “ ” button and hold it to
reverse the CD. When you release the button, the CD player
will resume playing.

Page 306 of 651

AUDIO
285
Push the “AM”, “FM”, “TAPE” or “DISC” button to turn on
that mode. The selected mode turns on directly.
Push these buttons if you want to switch from one mode to
another.
If the tape or CD is not set, the cassette player or CD player
does not turn on.
You can turn off each player by ejecting the cassette tape or
CD. If the audio system was previously off, then the entire
audio system will be turned off when you eject the cassette
tape or CD. If the other function was previously playing, it will
come on again. With rear seat entertainment system —
You can play a DVD or CD by pushing the “DISC” button when
a disc is loaded in the DVD player. Each time you push the
“DISC” button, you change between “CD” mode on the front
audio system and the DVD player. When you play the DVD
player, “AUX” appears on the display.

Page 325 of 651

AUDIO
304(i) If the player malfunctions
If the player or another unit equipped with the player
malfunctions, your audio system will display following error
messages.
If “WAIT” appears on the display:
It indicates that the inside
of the player unit may be too hot due to the very high ambient
temperature. Remove the CD from the player and allow the
player to cool down.
If “ERROR 1” appears on the display: It indicates that the CD
is dirty, damaged, or it was inserted up −side down. Clean the
CD or insert it correctly.
If “ERROR 3” or “ERROR 4” appears on the display: It
indicates there is a trouble inside the system. Eject the CD.
If the malfunction is not rectified: Take your vehicle to your
Lexus dealer.
AUDIO REMOTE CONTROLS
The switches are installed on the left side of the steering wheel.
“MODE” switch: Use this switch to turn on or off the audio
system, or change the audio mode.
 To turn on the system, push the switch briefly. To turn off the
system, push and hold the switch until you hear a beep.
 To change the audio mode, turn on the system and push the
switch briefly. If a tape or CD is not inserted, the “T APE” or
“CD” mode is skipped.
The DVD player will be selectable if a rear seat entertainment
system is installed in your vehicle.

Page 326 of 651

AUDIO
305

+” switches: Use these switches to adjust the volume.
To increase the volume, push the “+”. To decrease the volume,
push the “–”. The volume continues to increase or decrease
while the switch is being pressed.
(a) When the radio mode is selected

” or “” switch: Use these switches for seek tuning or to
select a preset station.
 To select a preset station, push this switch briefly. The
station you assigned to a switch on the audio system will be
selected.
 To seek a station, push and hold this switch until you hear
a beep. The radio will begin seeking up or down for a station,
and will stop on reception.
(b) When the “TAPE” mode is selected

” or “” switch: Use these switches to fast forward or
rewind the tape or for automatic program selection.
 To skip forward or reward for automatic program selection,
push this switch briefly. When automatically selecting a
program, you can skip up to 9 programs at a time. See page
276 or 296 for details.
 To fast forward or rewind the tape, push this switch until you
hear a beep. To stop fast forwarding or rewinding, push the
same side on the switch briefly. (c) When the “CD” mode is selected

” or “” switch: Use this switch to select a desired track.
Push this switch briefly, to select a desired track.
With a CD changer only —

” or “” switch: Use this switch to select a desired track
or CD.
 To select a desired track, push this switch briefly.
 To select a desired CD, push and hold this switch until the
desired number of the CD appears and you hear a beep.
Vehicles with rear seat entertainment system —
While the DVD player is in operation, the chapter or track can
be changed by pushing the “ ” or “” side of the switch.
CAUTION
Operate the switches with due care while you are
driving to avoid accidents.

Page 327 of 651

AUDIO
306
REAR SEAT ENTERTAINMENTSYSTEM1Front audio system
2Headphone volume control dial
3Headphone input jack
4DVD player
5Rear seat entertainment system display
6Rear seat entertainment system remote control
7Input terminal adapter
8Power outlet
9Power outlet main switch

Page 329 of 651

AUDIO
308The illumination of the screen is automatically turned off when
the display is closed. However, the rear seat entertainment
system is not turned off.
CAUTION
To reduce the chance of injury in case of an accident or
sudden stop while driving, close the display when it is
not in use.
NOTICE

The screen should be cleaned with a dry soft cloth.
If the screen is pushed by hand or wiped with a hard
cloth, the surface of the screen may be scratched.
 Benzene or alkaline solutions may damage the
coated surface of the screen.
 To prevent the battery from being discharged, do not
turn on the rear seat entertainment system longer
than necessary when the engine is not running.
Rear seat entertainment system remote
control
The rear seat entertainment system can be operated with
the rear seat entertainment system remote control and the
switches on the DVD player. The system cannot be
operated by touching the switches on the screen directly.
CAUTION
Do not disassemble or modify the remote control. It
may cause an accident, fire or electric shock.
NOTICE
Keep the remote control away from direct sunlight, high
heat and high humidity. These conditions could cause
the case to deform or the battery to explode or leak.

Page 332 of 651

AUDIO
311
NOTICE
Observe the followings, otherwise the remote control
may be damaged.
Do not drop or strongly knock the remote control
against hard objects.
 Do not sit on or place heavy objects on the remote
control.
 Do not leave the remote control exposed to high
temperatures (such as on the instrument panel) for a
long time, otherwise the remote control may be
damaged.
(c) Locating the remote control
If you lose sight of the remote control, push and hold the
“CURSOR (REMOTE)” button on the DVD player unit until you
hear a beep. A buzzer sounds from the remote control to let you
know where it is.
To stop the buzzer, push any button of the remote control.
If the remote control is located close to something that blocks
the signal, such as some kind of metal, the remote control may
not receive the signal and the buzzer may not sound.

Page 335 of 651

AUDIO
314
1“DVD” button: Turn on the DVD mode.
2“SOURCE” button: Turn on the rear seat
entertainment system and selects the mode.
3“INFO” button: Indicate the “Information Menu”
screen. (See the separate “Navigation System
Owner’s Manual”.)
4“MENU” button: Indicate the “Menu” screen when the
navigation system is operated. (See the separate
“Navigation System Owner’s Manual”.)
5“OFF” button: Turn off the rear seat entertainment
system.
6Joy stick: Select a control switch, mode switch on the
screen or the menu for the disc.
7“ENT” button: Input the selected switch or the
selected menu for the disc.
8“DISC/CH/PROG” button: Skip directly to a desired
preset station, disc, track or chapter.
9“  ” button: Fast forwards a screen when the DVD
player is operated.
10“RETURN” button: Skip to the predetermined scene
for the disc.
11“MENU” button: Indicate the menu screen for DVD
video when the DVD player is operated.
12“AUDIO” button: Indicate the changing audio screen
when the DVD player is operated.
13“SUB TITLE” button: Indicate the changing subtitle
screen when the DVD player is operated.
14“DISPLAY” button: Adjust the color, tone, contrast
and brightness of the screen.
15“SET UP” button: Indicate the initial set up screen
when the DVD player is operated.
16“ANGLE” button: Select the angle of the screen when
the DVD player is operated.
17“SEARCH” button: Indicate the title search screen
when the DVD player is operated.
18“TOP MENU” button: Indicate the title selection
screen for DVD video when the DVD player is operated.
19“” button: Pause a screen when the DVD player is
operated.
20“  ” button: Reverse a screen when the DVD player
is operated.
21“  ” button: Play a screen when the DVD player is
operated.
22“TUNE/TRACK” button: Operate the front audio
system or select the track/chapter when the DVD
player is operated.
23“CURSOR” button: Indicates the control switches on
the screen when the DVD player is operated.
24“MAP” button: Indicate the map screen when the
navigation system is operated. (See the separate
“Navigation System Owner’s Manual”.)
25“DEST” button: Indicate the “Destination” screen
when the navigation system is operated. (See the
separate “Navigation System Owner’s Manual”.)
26“VIDEO” button: Turn on the video mode when your
personal audio device is connected.

Page 336 of 651

AUDIO
315
Buttons on the DVD player unit
The rear seat entertainment system can be operate with the
switches on the DVD player.
1“” (eject) switch: Use this switch to eject the disc
from the DVD player.
2“SOURCE” switch: Push this switch to turn on the rear
seat entertainment system.
To change the audio mode, turn on the system and push the
source switch until the mode you desire is displayed. If a tape
or disc is not inserted, the “TAPE”, “CD” and “DVD” modes are
skipped.
3“TUNE/TRACK” switch: Use this switch to tune or seek
(radio mode), fast forward or rewind (“TAPE” mode),
select a desired track (“CD” mode) or select a desired
chapter/track (“DVD” mode).
Radio mode: Use this switch to tune or seek.
 To tune, repeatedly push this switch briefly until your desired
station is found.
 To seek, push and hold this switch until you hear a beep.
The radio will begin seeking up or down the band for a
station, and will stop on reception.
TAPE mode: Use this switch to fast forward or rewind a tape,
or for automatic program selection.
 To skip forward or rewind using automatic program
selection, push this switch briefly. By using automatic
program selection, you can skip up to 9 programs at a time.
For details, see page 276 or 296.
 To fast forward or rewind the tape, push and hold this switch
until you hear a beep. To stop fast forwarding or rewinding,
push and hold the same side of the switch until you hear a
beep.

Page:   1-10 11-20 21-30 31-40 41-50 ... 60 next >