low LEXUS SC300 1999 Owners Manual

STARTING AND DRIVING
250
Anti±lock brake system
The anti±lock brake system is designed to automatically
help prevent lock±up of the wheels during a sudden brake
or braking on slippery road surfaces. This assists in
providing directional stability and steering performance
of the vehicle under these circumstances.
The anti±lock brake system becomes operative after the
vehicle has accelerated to a speed in excess of approximately
10 km/h (6 mph). It stops operating when the vehicle
decelerates to a speed below approximately 5 km/h (3 mph).
You may hear a sound in the engine compartment for a few
seconds when the engine is started or just after the vehicle is
started. This means that the anti±lock brake system is in the
self±check mode, and does not indicate a malfunction.
Effective way to press the ABS brake pedal: When the anti±
lock brake system function is in action, you may feel the brake
pedal pulsating and hear a noise. In this situation, to let the anti±
lock brake system work for you, just hold the brake pedal down
more firmly. Do not pump the brake in a panic stop. Pumping the
brake pedal makes the stopping distance longer.

STARTING AND DRIVING
251
The brake pedal pulsation caused by the anti±lock brake
system may indicate hazardous road surface conditions.
Although the anti±lock brake system assists in providing
vehicle control, it is still important to drive with all due care,
because
the anti±lock brake system cannot overcome the laws
of physics that act on your vehicle:
 Braking capability is dependent on tire friction with the
road surface. 
Even though the anti±lock brake system is operating, a
driver cannot maintain full control on certain slippery road
surfaces, when cornering at high speeds, or in violent
maneuvers.
 Avoid high speeds on wet roads. The anti±lock brake
system cannot eliminate the risk of hydroplaning and loss
of tire friction.
Always maintain a safe distance from the vehicle in front of
you. Compared with vehicles not fitted with an anti±lock
brake system, your vehicle may require a longer stopping
distance in the following cases:
 Driving on rough, gravel or snow±covered roads.
 Driving with tire chains installed.
 Driving on roads where the road surface is pitted or has
other differences in surface height.

STARTING AND DRIVING
253
This light comes on when the ignition key is turned to the
ºONº
position. After about a few seconds, the light will go
off.
If either of the following conditions occurs, this indicates a
malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as soon as
possible to service the vehicle.
 The light does not come on as described above, or remains
on.
 The light comes on while driving.
Even if the anti±lock brake system should fail, the brake
system will still operate conventionally. But when the ºABSº
warning light is on (and the brake system warning light is off),
anti±lock brake system is not assisting brake performance so
that the wheels could lock up during a sudden brake or
braking on slippery road surfaces. Have your vehicle
checked by your Lexus dealer as soon as possible.
Drum±in±disc type parking brake system
Your vehicle has a drum±in±disc type parking brake system.
This type of brake system needs bedding±down of the brake
shoes periodically or whenever the parking brake shoes
and/or drums are replaced.
Have your Lexus dealer perform the bedding±down.

DRIVING TIPS
259
BREAK±IN PERIOD
Drive gently and avoid high speeds.
You need not follow a break±in schedule with your new
Lexus. But following a few simple tips for the first 1600 km
(1000 miles) can add to the future economy and long life of
your vehicle:

Do not drive over 88 km/h (55 mph).

Avoid overrevving. Maintain engine speed between 2000
and 4000 rpm.

Avoid full±throttle starts.

Try to avoid hard stops during the first 300 km (200 miles).

Do not drive for a long time at any single speed, either fast
or slow.

Do not tow a trailer during the first 800 km (500 miles).
OPERATION IN FOREIGN
COUNTRIES
If you plan to drive your Lexus in another country ...
First, comply with the vehicle registration laws.
Second, confirm the availability of the correct fuel (unleaded
and minimum octane rating).
TIPS FOR DRIVING IN VARIOUS CONDITIONS

Always slow down in gusty crosswinds. This will allow
you much better control.

Drive slowly onto curbs and, if possible, at a right angle.
Avoid driving onto high, sharp±edged objects and other
road hazards. Failure to do so can lead to severe tire
damage resulting in tire bursts.

When parking on a hill, turn the front wheels until they
touch the curb so that the vehicle will not roll. Apply the
parking brake, and place the transmission in ºPº. If
necessary, block the wheels.

Washing your vehicle or driving through deep water may
get the brakes wet. To see whether they are wet, check that
there is no traffic near you and then press the pedal lightly.
If you do not feel a normal braking force, the brakes are
probably wet. To dry them, drive the vehicle cautiously
while lightly pressing the brake pedal with the parking
brake applied. If they still do not work safely, pull to the
side of the road and call a Lexus dealer for assistance.
CAUTION

Before driving, make sure the parking brake is fully
released and that the parking brake reminder light is off.

DRIVING TIPS
261
your Lexus dealer ± they will be pleased to help.
Check
the electronic ignition system for loose connections
or obvious damage.
Keep the door locks from freezing.
Squirt lock de±icer or glycerine into the locks to keep them
from freezing.
Use a washer fluid containing an antifreeze solution.
This product is available at your Lexus dealer and most auto
parts stores. Follow the manufacturer's directions for how
much to mix with water.
NOTICE
Do not use engine antifreeze or any other substitute
because it may damage your vehicle's paint.
Do not use your parking brake when there is a possibility
it could freeze.
When parking, put the transmission into ºPº and block the
front wheels. Do not use the parking brake, or snow or water
accumulated in and around the parking brake mechanism
may freeze the parking brake, making it hard to release.
Keep ice and snow from accumulating under the fenders.
Ice and snow built up under your fenders can make steering
difficult. During bad winter driving, stop and check under the
fenders occasionally. Depending on where you are driving, we recommend you
carry some emergency equipment.
Some of the things you might put in the vehicle are tire chains,
window scraper, bag of sand or salt, flares, small shovel,
jumper cables, etc.
TRAILER TOWING
Your vehicle is designed primarily as a passenger±carrying
vehicle. Towing a trailer will have an adverse effect on
handling, performance, braking, durability and driving
economy (fuel consumption, etc.). Your safety and
satisfaction depend on the proper use of correct equipment
and cautious driving habits. For your safety and the safety of
others, you must not overload your vehicle or trailer. Lexus
warranties do not apply to damage or malfunction caused by
towing a trailer for commercial purposes. Ask your local
Lexus dealer for further details before towing.

DRIVING TIPS
265
Hitches

If you wish to install a trailer hitch, your Lexus dealer
should be consulted.

Use only a hitch which is recommended by Lexus dealer
and conforms to the total trailer weight requirement.

Follow the directions supplied by the hitch manufacturer.
Lubricate the hitch ball with a light coat of grease.

Lexus recommends removing the trailer hitch whenever
you are not towing a trailer to reduce the possibility of
additional damage caused by the hitch if your vehicle is
struck from behind. After removing the hitch, seal any
mounting holes in the vehicle body to prevent entry of
pollutants such as exhaust fumes, dirt, water, etc.

Remove the trailer hitch whenever you are not towing a
trailer so that the rear license plate can be seen clearly.
NOTICE

Install the trailer hitch using only the position
recommended by your Lexus dealer. Do not install the
trailer hitch on the bumper; this may cause body
damage.

Do not use axle±mounted hitches as they can cause
damage to the axle housing, wheel bearings, wheels or
tires.
Brakes and safety chains

Lexus recommends trailers with brakes that conform
to any applicable federal and state/provincial
regulations.

A safety chain must always be used between the towing
vehicle and the trailer. Leave sufficient slack in the
chain for turns. The chain should cross under the
trailer tongue to prevent the tongue from dropping to
the ground in case it becomes damaged or separated.
For correct safety chain procedur es, follow the hitch or
trailer manufacturer's recommendations.
CAUTION

If the total trailer weight exceeds 450 kg (1000 lb.), trailer
brakes are required.

Never tap into your vehicle's hydraulic system as it will
lower its braking effectiveness.

Never tow a trailer without using a safety chain securely
attached to both the trailer and the vehicle. If damage
occurs to the coupling unit or hitch ball, there is possible
danger of the trailer wandering over into another lane.

DRIVING TIPS
266
Tires

Ensure that your vehicle's tires are properly inflated.
Adjust the tire pressure to the recommended cold tire
pressure indicated below:
SC400, SC 300 ± Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32
psi)

The trailer tires should be inflated to the pressure
recommended by the trailer manufacturer in respect to the
total trailer weight.
Trailer lights

Trailer lights must comply with federal, state/provincial
and local regulations. See your local recreational vehicle
dealer or rental agency for the correct type of wiring and
relays for your trailer. Check for correct operation of the
turn signals and stop lights each time you hitch up. Direct
splicing may damage your vehicle's electrical system and
cause a malfunction of your lights.
Break±in schedule

Lexus recommends that you do not tow a trailer with a new
vehicle or a vehicle with any new power train component
(engine, transmission, differential, wheel bearing, etc.) for
the first 800 km (500 miles) of driving.
Maintenance

If you tow a trailer, your vehicle will require more frequent
maintenance due to the additional load. For this
information, please refer to the scheduled maintenance
information in the ºOwner's Manual Supplement/
Maintenance Scheduleº.

Retighten all fixing bolts of the towing ball and bracket
after approximately 1000 km (600 miles) of trailer driving.
Pre±towing safety check

Check that your vehicle remains level when a loaded or
unloaded trailer is hitched. Do not drive if the vehicle has
an abnormal nose±up or nose±down condition, and check
for improper tongue load, overload, worn suspension or
other possible causes.

Make sure the trailer cargo is securely loaded so that it
cannot shift.

Check that your rear view mirrors conform to any federal,
state/provincial or local regulation. If they do not, install
required rear view mirrors appropriate for towing
purposes.

DRIVING TIPS
267
Trailer towing tips
When towing a trailer, your vehicle will handle differ ently
than when not towing. The three main causes of
vehicle±trailer accidents are driver error, excessive speed
and improper trailer loading. Keep these in mind when
towing:

Before starting out, check the operation of the lights and
all vehicle±trailer connections. After driving a short
distance, stop and recheck the lights and connections.
Practice turning, stopping and backing with a trailer in an
area away from traffic until you learn the feel.

Backing with a trailer is difficult and requires practice.
Grip the bottom of the steering wheel and move your hand
to the left to move the trailer to the left. Move your hand
to the right to move the trailer to the right. (This procedure
is generally opposite to that when backing without a
trailer.) Also, just turn the steering wheel a little at a time,
avoiding sharp or prolonged turning. Have someone guide
you when backing to reduce the risk of an accident.

Because stopping distance may be increased,
vehicle±to±vehicle distance should be increased when
towing a trailer. For each 16 km/h (10 mph) of speed,
allow at least one vehicle and trailer length between you
and the vehicle ahead. Avoid sudden braking as you may
skid, resulting in jackknifing and loss of control. This is
especially true on wet or slippery surfaces.

Avoid jerky starts or sudden acceleration.

Avoid jerky steering and sharp turns. The trailer could hit
your vehicle in a tight turn. Slow down before making a
turn to avoid the need of sudden braking.

Remember that when making a turn, the trailer wheels will
be closer than the vehicle wheels to the inside of the turn.
Therefore, compensate for this by making a larger than
normal turning radius with your vehicle.

Crosswinds and rough roads will adversely aff ect handling
of your vehicle and trailer, causing sway. Pay attention to
the rear from time to time to prepare yourself for being
passed by large trucks or buses, which may cause your
vehicle and trailer to sway. If swaying happens, firmly
grip the steering wheel and reduce speed immediately but
gradually. Never increase speed. If it is necessary to
reduce speed, brake slowly. Steer straight ahead. If you
make no extreme correction with the steering or brakes,
your vehicle and trailer will stabilize.

Be careful when passing other vehicles. Passing requires
considerable distance. After passing a vehicle, do not
forget the length of your trailer and be sure you have plenty
of room before changing lanes.

In order to maintain efficient engine braking and electrical
charging performance, do not use overdrive.
Transmission must be in the º4º position (SC400) or in the
º3º position (SC300).

DRIVING TIPS
268

Because of the added load of the trailer, your vehicle's
engine may overheat on hot days (at temperatures over
30C [85 F]) when going up a long or steep grade with a
trailer. If the engine coolant temperature gauge indicates
overheating, immediately turn off the air conditioning (if
in use), pull your vehicle off the road and stop in a safe
spot. See ºIf your vehicle overheatsº on page 280 of this
manual.

Always place wheel blocks under both the vehicle and
trailer wheels when parking. Apply the parking brake
firmly. Put the transmission in ºPº. Avoid parking on a
slope with a trailer, but if it cannot be avoided, do so only
after performing the following:
1. Apply the brakes and keep them applied.
2. Have someone place wheel blocks under both the vehicle
and trailer wheels.
3. When the wheel blocks are in place, release your brakes
slowly until the blocks absorb the load.
4. Apply the parking brake firmly.
5. Shift into ºPº and turn off the engine.
When restarting out after parking on a slope:
1. With the transmission in ºPº position, start the engine. Be
sure to keep the brake pedal depressed. 2. Shift into the º3º, º2º, ºLº or ºRº position.
3. Release the parking brake and brake pedal and slowly pull
or back away from the wheel blocks. Stop and apply your
brakes.
4. Have someone retrieve the blocks.

DRIVING TIPS
269
CAUTION

Do not exceed 72 km/h (45 mph) or the posted towing speed
limit, whichever is lower. Because instability (swaying) of
a towing vehicle±trailer combination usually increases as
the speed increases, exceeding 72 km/h (45 mph) may cause
loss of control.

Slow down and downshift before descending steep or long
downhill grades. Do not make sudden downshifts.

Avoid holding the brake pedal down too long or too
frequently. This could cause the brakes to overheat and
result in reduced braking efficiency.