wheel alignment MAZDA MIATA 1991 Factory User Guide
Page 354 of 392
Fig. 1: Exploded View of Rear Lower Arm Assembly
Courtesy of MAZDA MOTORS CORP.
Installation
To install, reverse removal procedure. Tighten all bolts with vehicle resting on ground and suspension
unloaded. Adjust rear wheel toe-in. See SPECIFICATIONS & PROCEDURES article in the WHEEL
ALIGNMENT section.
UPPER ARM
Removal
Raise and support vehicle. Remove wheel assembly. Remove upper arm-to-crossmember bolts. Remove upper
arm-to-knuckle bolts. Remove upper arm. Inspect arm for damage, cracks and deformation. Check for damaged
or worn bushings.
1991 Mazda MX-5 Miata
SUSPENSION - REAR 1991 SUSPENSION Rear
Microsoft
Sunday, July 05, 2009 2:09:35 PMPage 3 © 2005 Mitchell Repair Information Company, LLC.
Page 355 of 392
Installation
To install, reverse removal procedure. Tighten all bolts with vehicle resting on ground and suspension
unloaded. Adjust rear wheel toe-in. See SPECIFICATIONS & PROCEDURES article in the WHEEL
ALIGNMENT section.
STABILIZER BAR
Removal
Raise and support vehicle. Remove wheel assembly. Remove stabilizer bar-to-crossmember bolt, bracket and
bushing. See Fig. 2
. Remove stabilizer bar control link-to-lower arm nut and bolt. Remove stabilizer bar and
control link from vehicle. Separate stabilizer bar from control link.
Fig. 2: Exploded View of Rear Stabilizer Bar & Control Link
Courtesy of MAZDA MOTORS CORP.
1991 Mazda MX-5 Miata
SUSPENSION - REAR 1991 SUSPENSION Rear
Microsoft
Sunday, July 05, 2009 2:09:35 PMPage 4 © 2005 Mitchell Repair Information Company, LLC.
Page 370 of 392
Fig. 1: Aligning Clockspring Connector Alignment Marks
Courtesy of MAZDA MOTORS CORP.
Removal & Installation (All Others)
Remove steering wheel. See STEERING WHEEL & HORN PAD under REMOVAL & INSTALLATION.
Remove steering column covers. Disconnect combination switch connectors. Remove combination switch. To
install, reverse removal procedure.
IGNITION SWITCH & STEERING LOCK
Removal & Installation (All Models)
1. Remove steering wheel and combination switch. See STEERING WHEEL & HORN PAD and
COMBINATION SWITCH.
2. Remove ignition switch connectors. Remove ignition switch-to-steering lock screw. Remove ignition
switch.
3. With a hammer and chisel, make a groove on steering lock assembly shear screws. Remove 2 shear
screws with screwdriver. Remove ignition switch/steering lock assembly. To install, reverse removal
procedure. Tighten NEW shear screws until head breaks off.
STEERING COLUMN
CAUTION: Excessive pressure or impact to mainshaft during service may cause
column to collapse.
1991 Mazda MX-5 Miata
STEERING COLUMN 1991 STEERING Mazda - Steering Columns
Microsoft
Sunday, July 05, 2009 2:10:42 PMPage 3 © 2005 Mitchell Repair Information Company, LLC.