turn signal MAZDA MODEL 3 HATCHBACK 2016 (in English) Service Manual

7–36
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Seat Belt Warning Beep
If the driver's seat belt is not fastened
when the ignition is switched ON, a beep
sound will be heard for about 6 seconds. If
the driver or the front passenger's seat belt
is not fastened and the vehicle is driven
at a speed faster than about 20 km/h (12
mph), a beep sound will be heard again for
a speci¿ ed period of time.
N O T E




y Placing heavy items on the front
passenger seat may cause the front
passenger seat belt warning function to
operate depending on the weight of the
item.
 


y To allow the front passenger seat weight
sensor to function properly, do not place
and sit on an additional seat cushion
on the front passenger seat. The sensor
may not function properly because the
additional seat cushion could cause
sensor interference.
 


y When a small child sits on the front
passenger seat, it is possible that the
warning beep will not operate.

Ignition Not Switched Off (STOP)
Warning Beep
If the driver's door is opened with the
ignition switched to ACC, a beep will
be heard continuously in the cabin to
notify the driver that the ignition has not
been switched OFF (STOP). Under this
condition, the keyless entry system will
not operate, the vehicle cannot be locked,
and the battery voltage will be depleted.

Key Removed from Vehicle
Warning Beep
Vehicles with advanced keyless function
If the key is taken out of the vehicle while
the ignition is not switched OFF and
all the doors are closed, the beep which
sounds outside of the vehicle will be heard
6 times, the beep which sounds inside
the vehicle will be heard 6 times, and the
KEY warning light (red) in the instrument
cluster À ashes continuously to notify
the driver that the ignition has not been
switched OFF.
Vehicles without advanced keyless
function
If the key is taken out of the vehicle while
the ignition is not switched OFF and all
the doors are closed, a beep will be heard
in the cabin 6 times and the KEY warning
light (red) in the instrument cluster turns
on continuously to notify the driver that
the ignition has not been switched OFF.
N O T E
Because the key utilizes low-intensity
radio waves, the Key Removed From
Vehicle Warning may activate if the key is
carried together with a metal object or it
is placed in a poor signal reception area.

Request Switch Inoperable
Warning Beep (With the advanced
keyless function)
If the request switch is pressed with the
door open or ajar, or the ignition is not
switched OFF with a key being carried,
a beep will be heard outside for about 2
seconds to notify the driver that the door
or liftgate/trunk lid cannot be locked.
.B[EB@'"&"(@&EJUJPOJOEC


.B[EB@'"&"(@&EJUJPOJOEC










7–38
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Blind Spot Monitoring (BSM)
System Warning Beep *
D r i v i n g f o r w a r d
The warning beep operates when the turn
signal lever is operated to the side where
the Blind Spot Monitoring (BSM) warning
light is illuminated.
N O T E
A personalized function is available to
change the Blind Spot Monitoring (BSM)
warning beep sound volume.
Refer to Personalization Features on page
9-12 .

Reversing
If a moving object such as a vehicle or
two-wheeled vehicle approaches on the
left or right from behind your vehicle, the
Blind Spot Monitoring (BSM) warning
sound is activated.
Mazda Radar Cruise Control
(MRCC) System Warnings *
The Mazda Radar Cruise Control (MRCC)
system warnings notify the driver of
system malfunctions and cautions on use
when required.
Check based on the beep sound.

Cautions What to check
The beep sounds 1 time
while the Mazda Radar
Cruise Control (MRCC)
is operating The vehicle speed is
slower than 25 km/h (16
mph) and the Mazda
Radar Cruise Control
(MRCC) system has
been canceled.
The beep sounds
continuously while
driving The distance between
your vehicle and the
vehicle ahead is too
close. Verify the safety
of the surrounding area
and reduce vehicle
speed.
When the Mazda
Radar Cruise Control
(MRCC) is operating,
the beep sounds and the
Mazda Radar Cruise
Control (MRCC)
warning light (amber)
in the instrument cluster
À ashes. A malfunction in
the system may be
indicated. Have your
vehicle inspected at
an Authorized Mazda
Dealer.

Collision warning *
If there is the possibility of a collision
with a vehicle ahead, the beep sounds
continuously and a warning is indicated in
the display.
Power Steering Warning Buzzer
If the power steering system has
a malfunction, the power steering
malfunction light turns on or À ashes and
the buzzer operates at the same time.
Refer to Warning/Indicator Lights on page
4-20 .
.B[EB@'"&"(@&EJUJPOJOEC


.B[EB@'"&"(@&EJUJPOJOEC










9–9
Speci¿ cations
Speci¿ cations
Air Conditioner
The type of refrigerant used is indicated on a label attached to the inside of the engine
compartment. Check the label before recharging the refrigerant. Refer to Climate Control
System on page 5-2 .
Item Classi¿ cation
Refrigerant Type HFC134a (R-134a)

Light Bulbs
Exterior light
Light bulb Category
Wattage UNECE *1 (SAE)
Headlights Halogen High beam 65 HB3 (9005)
Low beam 55 H11 (H11)
Xenon fusion High/Low beam 35 D4S (D4S)
Daytime running lights With halogen bulb headlights 65 HB3 (9005)
With xenon fusion bulb headlights LED
*2 — (—)
Parking lights (Front side-
marker lights) With halogen bulb headlights 5 WY5W (—)
Front side-marker lights With xenon fusion bulb headlights 5 W5W (—)
Parking lights With xenon fusion bulb headlights LED
*2 — (—)
Front turn signal lights 21 WY21W (7443NA)
Fog lights
* 55 H11 (H11)
Side turn signal lights * L E D *2 — (—)
High-mount brake light LED *2 — (—)
Rear turn signal lights 21 WY21W (7443NA)
Brake lights/Taillights/Rear
side-marker lights LED type LED
*2 — (—)
Bulb type 21/5 W21/5W (7443)
Taillights (Liftgate side/Trunk lid side)
* LED *2 — (—)
Reverse lights 4–Door 18 W16W (921)
5–Door 21 W21W (7440)
License plate lights 5 W5W (—)
*1 UNECE stands for United Nations Economic Commission for Europe.
*2 LED is the abbreviation for Light Emitting Diode.


.B[EB@'"&"(@&EJUJPOJOEC


.B[EB@'"&"(@&EJUJPOJOEC










9–16
Speci¿ cations
Personalization Features
Item Feature Factory
Setting Available
Settings Settings change method

Vehicle Auto-wiper
control
Refer to
Windshield
Wipers and
Washer on
page 4-47 . The auto-wiper
control function can
be changed. On On/Off
*4

Refer to
Settings
on page
5-55 . —


Daytime
running lights
Refer to
Daytime
Running
Lights on page
4-45 . The function of the
daytime running
lights can be
changed. On On/
O f f — —


Auto headlight
off
*5
Refer to
Headlights on
page 4-40 . The time required
for headlights to turn
off after ignition is
switched off can be
changed. 30 seconds 120
seconds/
90 seconds/
60 seconds/
30 seconds/
O f f
*6

Refer to
Settings
on page
5-55 . —


Auto-light
control
Refer to
Headlights on
page 4-40 . The headlight
illumination on/
off timing based
on surrounding
lightness/darkness
can be changed. Medium High/
Med. High/
Medium/
Med. Low/
L o w

Refer to
Settings
on page
5-55 . —


High Beam
Control
System (HBC)
Refer to High
Beam Control
System (HBC)
on page 4-
77 . The High Beam
Control System
(HBC) function can
be changed.
*1 On On/Off

Refer to
Settings
on page
5-55 . —


Lights-on
reminder
*7
Refer to
Lights-On
Reminder on
page 7-35 . The volume of the
lights-on reminder
warning alarm can be
changed. Off High/Low/
Off
Refer to
Settings
on page
5-55 . —


Turn indicator
Refer to
Turn and
Lane-Change
Signals on
page 4-46 . The turn indicator
beep volume level
can be changed. High High/Low

Refer to
Settings
on page
5-55 . —


.B[EB@'"&"(@&EJUJPOJOEC


.B[EB@'"&"(@&EJUJPOJOEC










9–17
Speci¿ cations
Personalization Features
Item Feature Factory
Setting Available
Settings Settings change method

Vehicle Three-À ash
turn signal
Refer to Three-
Flash Turn
Signal on page
4-47 . The three-time À ash
function can be
changed. On On/Off

Refer to
Settings
on page
5-55 . —


System Distance unit The distance unit can
be changed. mi or km mi/km

Refer to
Settings
on page
5-55 . —


Language The display language
can be changed.
*8 English English/
F r e n c h /
Spanish

Refer to
Settings
on page
5-55 . —


Temperature
unit The temperature unit
can be changed. °F or °C °F/°C

Refer to
Settings
on page
5-55 . —


Fuel
Economy
Monitor
Refer
to Fuel
Economy
Monitor
on page
4-69 . Ending display Setting can be
changed so that the
ending display of
the Fuel Economy
Monitor is displayed. Off On/Off

Refer
to Fuel
Economy
Monitor
on page
4-69 . —


Fuel economy
resetting
procedure Setting can be
changed so that the
fuel economy reset is
linked with the trip
meter reset. Off On/Off

Refer
to Fuel
Economy
Monitor
on page
4-69 . —


.B[EB@'"&"(@&EJUJPOJOEC


.B[EB@'"&"(@&EJUJPOJOEC