warning MAZDA MODEL 6 2015 Quick Guide (in English)

22
When Driving
X Mark Full Low
Diesel Particulate Filter
The diesel particulate filter collects and removes most of the particulate matter
(PM) in the exhaust gas of a diesel engine.
Inspect the engine oil level periodically (before getting in the vehicle). When
inspecting the engine oil, if the engine oil level is close to or exceeds the “X” mark
on the dipstick, replace the engine oil.
Whenever the engine oil is replaced, the vehicles engine control unit needs to be
reset as soon as possible. Otherwise the wrench indicator light or engine oil
warning light may turn on.
For details, refer to Section 4, “i-ELOOP”, “Tyre Pressure Monitoring System”,
“Diesel Particulate Filter” or Section 6, “Owner Maintenance”.
The Tyre Pressure Monitoring System (TPMS) monitors the air pressure of all
four wheels. If the air pressure of one or more tyres is too low, the system warns
the driver by indicating the tyre pressure monitoring system warning light in the
instrument cluster and operating a beep sound.
In the following cases, system initialization must be performed so that the system
operates normally.
• A tyre pressure is adjusted.
• Tyre rotation is performed.
• A tyre or wheel is replaced.
• The battery is replaced or completely drained.
• The tyre pressure monitoring system warning
light is illuminated.
Tyre Pressure Monitoring System
To reset the engine control unit, refer to the vehicle engine control unit reset
procedure or consult an expert repairer, we recommend an Authorised Mazda
Repairer.
i-ELOOP Charging Display
If the vehicle is driven while “i-ELOOP charging”
is displayed, a beep sound is heard. Make sure the
message is no longer displayed before driving.
.B[EB@&"&&,@&EJUJPO@2VJDL(VJEFJOEC







If Trouble Arises
25
If Trouble Arises
• Flat Tyre
If you have a flat tyre, drive slowly to a level spot that is well off the road and
out of the way of traffic to change the tyre.
In the event of a flat tyre, use the emergency flat tyre repair kit to repair the tyre
temporarily or use the temporary spare tyre.
• Overheating
1. Drive safely to the side of the road and park off the right-of-way.
2. Check whether coolant or steam is escaping from the engine compartment.
If steam is coming from the engine compartment:
Do not go near the front of the vehicle. Stop the engine.
Wait until the steam dissipates, then open the bonnet and start the engine.
If neither coolant nor steam is escaping:
Open the bonnet and idle the engine until it cools.
• Towing Description
We recommend that towing be done only by an expert repairer, we recommend
an Authorised Mazda Repairer or a commercial tow-truck service.
• Warning Lights and Warning Sounds
If a warning light illuminates or flashes or a warning sound is heard, check for
details concerning the warning light or sound in this guide. If the problem
cannot be resolved, contact an Authorised Mazda Repairer.
For details, refer to Section 7, “Flat Tyre”, “Overheating”, “Emergency Towing” or
“Warning/Indicator Lights and Warning Sounds”.
.B[EB@&"&&,@&EJUJPO@2VJDL(VJEFJOEC