warning light MAZDA MODEL 626 2001 Owner's Manual

Form No. 8P95-EA-00G
Driving Your MazdaOperating your vehicle requires a good understanding of the many controls you must know and use. Section 5
describes all this in step-by-step information from use of the ignition switch to cruise control and braking.
Also highlighted are the gearshift and shifting modes, power steering, instruments and gaug\
es, warnings and
indicators, windshield wipers, and interior features. You’ll find complete details about the advanced audio
system too.Ignition Switch Positions 5- 2Starting the Engine 5- 4
Manual Transaxle Operation 5- 7 Automatic Transaxle 5- 9
Traction Control System (TCS) 5- 16 Brake System 5- 19
Power Steering 5- 24 Cruise Control 5- 24
Instrument Cluster 5- 30 Gauges 5- 31
Dashboard Illumination 5- 35 Warning Lights/Beeps 5- 35
Lighting Control and Turn Signals 5- 44 Windshield Wipers and Washer 5- 47 Rear Window Defroster 5- 49 Clock 5- 51
Accessory Socket 5- 51 Glove Box 5- 55
Cup Holders 5- 56
Storage Compartments 5- 57 Sunvisors 5- 59
Vanity Mirrors 5- 60
Climate Control System 5- 60
Radio Reception 5- 75
Safety Certification 5- 80
AM/FM Radio with Compact Disc Player 5- 82 AM/FM Radio with Cassette Tape
and Compact Disc Player/Changer (In-Dash CD Changer) 5- 83 Antenna 5-123
5
5-1

Q041-1B1E

Form No. 8P95-EA-00G
Driving Your Mazda5-2

042-1CE
Ignition Switch PositionsWithout immobilizer
system
J94A4001A
 ON
This is the normal running position
after the engine is started. The warning
lights (except brakes) should be
inspected before the engine is started
(page 5-35).
With immobilizer
system
J94S5001
 START
The engine is started in this position. It
will crank until you release the key;
then it returns to the ON position. The
brake warning light can be checked
after the engine is started (page 5-35). 
ACC (Accessory)
The steering wheel unlocks and some
electrical accessories will operate.
 LOCK
The steering wheel locks to protect
against theft. Only in this position can
the key be removed.

Form No. 8P95-EA-00G
Driving Your Mazda
5-11

045-4AE
 R (Reverse)
In position R, the vehicle moves only
backward. You must be at a complete
stop before shifting from R, except as
explained under Rocking the Vehicle
(page 4-11).
Q045-5AE
 N (Neutral)
In N, the wheels and transaxle are not
locked. The vehicle will roll freely
even on the slightest incline unless the
parking brake or brakes are on.
WARNING
!
Shifting from N or P:It’ s dangerous to shift from N or
P into a driving gear when the
engine is running faster than idle.
If this is done, the vehicle could
move suddenly, causing an
accident or serious injury. If the
engine is running faster than idle,
don’ t shift from N or P into a
driving gear. D (Drive)
D is the normal driving position. From
a stop, the transaxle will automatically
shift through a 4-gear sequence.

045-14A1E
 2 (Second)
The 2 position is helpful when driving
in heavy, slow-moving traffic and
climbing hills; for braking assist when
going down hills; or for starting on
slick surfaces and other situations
where gentle acceleration may be
necessary. Do not exceed 116 km/h
(72 mph)
*1 or 104 km/h (65 mph)
*2 in
the 2 position.
*1
2.0-liter engine
*2
2.5-liter engine

Form No. 8P95-EA-00G
Driving Your Mazda
5-17

114 –2B1E
J94A4010
Traction Control Indicators
 Traction control system (TCS)
warning light
This warning light stays on for a few
seconds when the ignition switch is
turned to the ON position. It flashes when the system regulates
engine torque. If the light stays on,
take your vehicle to an Authorized
Mazda Dealer. The traction control
system may have a malfunction.
NOTE•
In addition to the TCS warning
light flashing, a slight lugging
sound will come from the
engine. This indicates that the
traction control system is
operating properly.
• On slippery surfaces, such as
fresh snow, it will be
impossible to achieve high rpm
when the traction control
system is on.

Form No. 8P95-EA-00G
Driving Your Mazda5-20
WARNING
!
Riding the Brakes:Driving with your foot
continuously on the brake pedal
or steadily applying the brakes for
long distances is dangerous. This
causes overheated brakes,
resulting in longer stopping
distances or even total brake
failure. This could cause loss of
vehicle control and a serious
accident. Avoid continuous
application of the brakes. Shift to
a lower gear when going down
steep hills.
WARNING
!
Driving with Wet Brakes:Driving with wet brakes is
dangerous. Increased stopping
distance or the vehicle pulling to
one side when braking could
result in a serious accident. Light
braking will indicate whether the
brakes have been affected. Dry
the brakes by driving very slowly
and applying the brakes lightly
until brake performance is
normal.
047-2A1E
J94A4013
(J18Y4021)Brake Pad Wear Indicator
When the disc brake pads become
worn, the built-in wear indicators
contact the disc plates. This causes a
screeching noise to warn that the pads
should be replaced.

Form No. 8P95-EA-00G
*Some models.
Driving Your Mazda5-22

Q047-4AE
J94A4015
BRAKE
 Brake System Warning Light
If the brake warning light stays on
after the parking brake is fully
released, the brake system has a
malfunction. Refer to Warning
Lights/Beeps (page 5-36).
 Q047-5A2E
 Antilock Brake System (ABS)*
The ABS control unit continuously
monitors the speed of each wheel. If
one is about to lock up, the ABS
responds by automatically releasing
and reapplying that wheel’ s brake.
The driver will feel a slight vibration
in the brake pedal and may hear a
chattering noise from the brake
system. This is normal when the ABS
operates. Don’ t pump the brakes,
continue to press down on the brake
pedal.

Q047-7B2E
NOTEIf the ABS warning light stays on
while you’re driving, the ABS
control unit has detected a system
malfunction. If this occurs, your
brakes will function normally as if
the vehicle had no ABS. Should
this happen, consult an Authorized
Mazda Dealer as soon as possible.

Form No. 8P95-EA-00G
Driving Your Mazda
5-23
NOTEBraking distances may be longer
on loose surfaces (snow or gravel,
for example) which usually have a
hard foundation. A vehicle with a
normal braking system may
require less distance to stop under
these conditions because the tires
will build up a wedge of surface
layer when the wheels skid.
WARNING
!
ABS:The ABS cannot compensate for
unsafe and reckless driving,
excessive speed, tailgating
(following another vehicle too
closely), and hydroplaning
(reduced tire friction and road
contact because of water on the
road surface). You can still have
an accident. So don’t rely on ABS
as a substitute for safe driving.
NOTEWhen the engine is jump-started,
an unevenness of rpm occurs and
the ABS warning light comes on.
This is due to a lack of battery
capacity and doesn’ t indicate a
malfunction.
Have the battery recharged as soon
as possible.

Form No. 8P95-EA-00G
Driving Your Mazda
5-25

049-2F1E
CRUISE MAIN switchJ94A4017_2001
To activate the system, push the
CRUISE MAIN end of the switch.
To deactivate the system, push the
OFF end.

049-3AE
WARNING
!
Cruise Main Switch:Leaving the CRUISE MAIN
switch on when not using the
cruise control is dangerous as it
may be switched on accidently.
This could result in loss of vehicle
control. Keep the CRUISE MAIN
switch off when cruise control is
not in use.

049-12AE
J94A4018 Cruise Set Indicator Light
The cruise set indicator comes on
when a cruising speed is set.

Form No. 8P95-EA-00G
Driving Your Mazda5-30050-1AEInstrument Cluster
TachometerTurn signal indicator
Speedometer
Turn signal indicator
Odometer/Trip meter selector Fuel gauge
Water temperature gauge
Warning and indicator lights
Odometer and Trip meter
J94S5002
Warning and indicator lights

Form No. 8P95-EA-00G
Driving Your Mazda5-34
051-5EE
Warning light
J94S5005Fuel Gauge
The fuel gauge shows approximately
how much fuel is in the tank. We
recommend keeping the tank over 1/4
full. When the low fuel warning light
illuminates or when the needle is near
E, refuel as soon as possible.
051-7B1ERed
zone
J94A4027➀ 2.0-liter engine
➁ 2.5-liter engine
➁ ➀

Tachometer
The tachometer shows engine speed in
thousands of revolutions per minute
(rpm). Use it while selecting shift points and
to prevent lugging and overrevving
(page 5-8).
051-8AE
CAUTION
!
Don’
t run the engine with the
tachometer needle in the RED
ZONE.
This may cause severe engine
damage.