tire type MAZDA MODEL CX-5 2014 Smart Start Guide (in English)

11
SHIFT POSITION
INDICATOR LIGHT S
PEEDOMETER
G LOSSARY OF W ARNING AND INDICATOR LIGHTS
NOTE: See Owner’s Manual for more details and explanations.
Instrument Cluster
TCS
OFF

Traction Control System (TCS)
Off Indicator Light

Low Engine Oil Pressure

Traction Control System

(TCS)/Dynamic Stability
Control (DSC)
On: TCS/DSC malfunction
Flashing: TCS/DSC operating

Shift Position Indicator Light

KEY Warning Light RED
(pp. 1, 3)

KEY Indicator Light GREEN (pp. 3-4)

Power Steering Malfunction

Air bag/Front Seat b
elt
Pretensioner System Malfunction

Turn Signals/Hazard

Warning Indicator Lights
4WD

4WD Warning Light
On:
Flashing: Stop vehicle/tow to
Mazda dealer.

Check Engine Light

Master Warning Light

Tire Pressure

Monitoring System
(TPMS) Warning Light
(p. 20) On/ Warning Beep: Low tire
pressure in one or more tires.
Flashing: TPMS Malfunction

Security Indicator Light

Cruise Main Indicator Light

On (A M bER)/Cruise Set
Indicator Light On (G REEN)

Automatic Transaxle

Warning Light

Lights On (Exterior) (p. 13)
bSM
OFF

b
SM OFF
( b lind Spot Monitoring) (p. 22)

Seat b
elt
Unbuckled/Malfunction

Headlight High b
eams On (p. 13)
TACHOMETER
There are two different types of
instrument clusters (Type A &
Type B). Type B is shown here.
Type A is similar, but with different
warning & indicator light locations.
Refer to Owners Manual for
instrument cluster Type A.

20
Tires
CAUTION: Using a wire brush, polishing
compound, solvent, or any type of abrasive
cleaner may damage the protective coating. www.MazdaUSA.com
T
IRE PRESSURE MONITORING SYSTEM (TPMS)
Your vehicle is equipped with a Tire Pressure Monitoring System (TPMS)
that detects low tire pressure in one or more tires. In the following cases,
the TPMS must be “initialized” so the system can operate normally.
• The tire pressure is adjusted (up or down) in one or more tires.
• A tire rotation is performed.
•
Any tire or wheel is replaced.
•
The vehicle’s battery is disconnected, replaced or completely dead.
Initialization Process (TPMS Warning Light is Illuminated):
1
Park the vehicle in a safe place and firmly apply the parking brake.
2
Let the tires cool, then adjust the tire pressure to the specified
pressure (See tire label located on the driver’s side B-pillar or edge
of driver’s door frame for specification) on all four (4) tires.
3
Switch the ignition ON, but leave the vehicle parked.
4
Push and hold the TPMS “Set Switch” (left side of dash)
until the TPMS warning light
in the instrument cluster flashes twice

and a
beep sound is heard once.
NOTE: See Page 9 for TPMS switch location.
CAUTION: If the TPMS “Set Switch” is pushed without adjusting the tire
pressure, the system cannot detect the normal tire pressure. The TPMS
warning light may not illuminate, even if the tire pressure is low, or it may
illuminate if the tire pressure is normal.
ALUMINUM WHEEL CARE
Your aluminum wheels have a protective
coating on them. Only use a mild soap or
neutral detergent with a sponge or soft cloth
to clean them.