lock MAZDA MODEL MPV 2003 (in English) Workshop Manual

3-20
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G

Operating the Driver’s Side
Power Window
To open the window, push down the
switch.
To close the window, pull up the switch.
Auto-opening
To fully open the window automatically,
push the switch completely down.
To stop the window partway, pull up the
switch and then release it.

Operating the Passenger Power
Windows
The power windows may be operated
when the power window lock switch on
the driver’s door is in the unlocked
position.
The passenger windows may be opened or
closed by the power window master
control switches on the driver’s door.
Front passenger-side power window
To open the window, push down the
switch.
To close the window, pull up the switch.
Close
OpenLeft front window
Right front window
Left rear window
Right rear window
OpenClose
J16L_8R21-EA-02G.book Page 20 Saturday, June 8, 2002 11:16 AM

3-21
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G
Rear power windows
To open a window, push the lower part of
the switch.
To close, push the upper part of the
switch.

Power Window Lock Switch
With the lock switch in the unlocked
position, all power windows on each door
can be operated.
With the lock switch in the locked
position, only the driver’s side power
window can be operated.
Close
Open
Unlocked positionLocked position
Unintentional Window Operation:
Unintentional window operation is
dangerous. A person’s hands, head,
or neck could be caught by the
window and result in serious injury.
Unless a passenger needs to operate a
window, keep the power window lock
switch in the locked position.
WARNING
J16L_8R21-EA-02G.book Page 21 Saturday, June 8, 2002 11:16 AM

3-22
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G
Open or close a swing-out rear quarter
window by releasing the latch and moving
the window.

Opening a Window
Pull the latch inward and then push the
window outward.

Closing a Window
Pull the latch inward and then push it
backward until it snaps shut. Make sure
the window is securely closed.
Rear Quarter WindowsFuel-Filler Lid and Cap
Fuel Spray:
Fuel spray is dangerous. Fuel can
burn skin and eyes and cause illness
when ingested. Fuel spray is released
when there is pressure in the fuel
tank and the fuel cap is removed too
quickly. When removing the fuel cap,
loosen the cap slightly and wait for
any hissing to stop. Then remove it.
Fuel Vapor:
Fuel vapor is dangerous. It could be
ignited by sparks or flames causing
serious burns and injuries. Before
refueling, stop the engine, and always
keep sparks and flames away from the
filler neck.
Always use only a genuine Mazda fuel
cap or an approved equivalent,
available at Authorized Mazda
Dealers. The wrong cap can result in a
serious malfunction of the fuel and
emission control systems. It may also
cause the check engine light in the
instrument cluster to illuminate.
WARNING
CAUTION
J16L_8R21-EA-02G.book Page 22 Saturday, June 8, 2002 11:16 AM

3-23
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G

Fuel-Filler Lid
To open, pull up the remote fuel-filler lid
release.

Fuel-Filler Cap
To remove the filler cap, turn it
counterclockwise.
To replace the filler cap, turn it clockwise
until it clicks.
NOTE
The fuel-filler lid cannot be opened
when the left-side sliding door is open.
Close the sliding door to open the fuel-
filler lid.
Remote fuel-filler
lid release
Open
Close
Make sure the fuel-filler cap is
tightened securely. The check engine
light comes on when the cap isn’t
tightened securely. If the light remains
on (even after you have tightened the
cap securely, driven, and restarted the
engine several times), it may indicate a
different problem. Contact an
Authorized Mazda Dealer as soon as
possible.
CAUTION
J16L_8R21-EA-02G.book Page 23 Saturday, June 8, 2002 11:16 AM

3-24
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G

Opening the Hood
1. With the vehicle parked, pull the
release handle to unlock the hood.
2. Pull the safety catch up and lift the
hood.3. Use the support rod to hold the hood
open.

Closing the Hood
1. Check under the hood area to make
certain all filler caps are in place and
all loose items (e.g. tools, oil
containers, etc.) have been removed.
2. Secure the rod in its clip.
3. Close the hood so that it locks securely.
Hood
Safety catch
Support
rod
Clip
J16L_8R21-EA-02G.book Page 24 Saturday, June 8, 2002 11:16 AM

3-25
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G
The sunroof can be opened or closed
electrically only when the ignition switch
is in the ON position.

Tilt Operation
The rear of the sunroof can be tilted open
to provide more ventilation.
To tilt, push the rear of the tilt switch.
To close, push the front of the tilt switch.
Sunroof
Extending the Head or Arms
Through the Sunroof:
Extending the head, arms, or other
parts of the body through the sunroof
is dangerous. The head or arms could
hit something while the vehicle is
moving. This could cause death or
serious injury. Don’t let passengers
stand up or extend anything through
the open sunroof while the vehicle is
moving.
Closing the Sunroof:
A closing sunroof is dangerous. The
hands, head, or even neck of a person
—especially a child—could be caught
in it as it closes, causing serious
injury or even death. Make sure the
opening is clear before closing the
sunroof.
Slide switch
Tilt switch
WARNING
NOTE
After washing your Mazda or after a
rain, wipe the water off the sunroof
before operating it.
Tilt up
Close
J16L_8R21-EA-02G.book Page 25 Saturday, June 8, 2002 11:16 AM

3-26
Knowing Your Mazda
Doors and Locks
Form No. 8R21-EA-02G

Slide Operation
To open to any position, press the rear of
the slide switch.
To close, press the front of the slide
switch.

Sunshade
The sunshade can be opened and closed
by hand.
The sunshade opens automatically when
the sunroof is opened, but must be closed
by hand.
NOTE
For safety reasons, the sunroof stops
moving approximately 20 cm (8 in)
prior to completely closing. After you
are sure it is unobstructed, resume
closing the sunroof by pressing the
switch again.
Open
Close
The sunshade doesn’t tilt. To avoid
damaging the sunshade, don’t push up
on it.
Sunshade
CAUTION
J16L_8R21-EA-02G.book Page 26 Saturday, June 8, 2002 11:16 AM

3-29
Knowing Your Mazda
Security System
Form No. 8R21-EA-02G
The optional theft-deterrent system is
designed to prevent your vehicle or its
contents from being stolen when all the
doors, hood, and liftgate are locked.
If forcible entry is attempted, the system
sounds the horn and flashes the hazard
warning lights.
The system won’t function unless it’s
properly armed. So when you leave the
vehicle, lock all the doors and the liftgate,
close all the windows, take your key, your
transmitter, and make sure the security
indicator light is flashing.

Operation
What turns it on:
•Forcing open a door, the hood or the
liftgate.
•Opening a door or the hood by
operating an inside door-lock button or
the hood release handle.
What it does:
•The horn sounds intermittently and the
hazard warning lights flash.
•The alarm continues for about 3
minutes, then stops.
If the system is triggered again, the lights
and horn will activate until a door or the
liftgate is unlocked with the key or with
the transmitter.

How to Arm the System
1. Remove the key from the ignition
switch.
2. Close the hood. Then close all doors
and the liftgate and lock them from the
outside using the key in the door. If you
have the keyless entry system, press the
LOCK button on the transmitter. The
hazard warning lights will flash one
time to indicate that the system is
armed.
The following method will also arm the
theft-deterrent system:
Close the hood. Press the area on the
door-lock switch marked "DOOR
LOCK" once. Close all doors and the
liftgate.
3. The indicator light flashes once every 3
seconds to indicate that the system is
fully armed. It continues to flash until
the theft-deterrent system is turned off.
Theft-Deterrent System
NOTE
The theft-deterrent system operates
without the keyless entry system
transmitter, as well.
NOTE
Locking the doors with the inside
door-lock button will not arm the
system.
J16L_8R21-EA-02G.book Page 29 Saturday, June 8, 2002 11:16 AM

3-30
Knowing Your Mazda
Security System
Form No. 8R21-EA-02G

To Tu r n o f f a n A r m e d S y s t e m
An armed system can be turned off by any
one of the following methods:
•Unlock a door or the liftgate with the
key.
•Press the UNLOCK button on the
keyless entry system transmitter.
•Insert the key into the ignition switch
and turn it to the ON position.
The hazard warning lights will flash twice
to indicate that the system is turned off.

To Stop an Alarm
A triggered alarm can be turned off by any
one of the following methods:
•Unlock a door or the liftgate with the
key.
•Press the UNLOCK button on the
keyless entry system transmitter.

Theft-Deterrent Labels
Labels indicating that your vehicle is
equipped with a Theft-Deterrent System
are in the glove box.
Mazda recommends that you affix them to
the lower rear corner of the front door
windows.
NOTE
If you have any problem with the theft-
deterrent system, consult an
Authorized Mazda Dealer.
J16L_8R21-EA-02G.book Page 30 Saturday, June 8, 2002 11:16 AM

3-31
Knowing Your Mazda
Form No. 8R21-EA-02G
Steering Wheel and Mirrors

Tilt Steering Wheel
To change the angle of the steering wheel,
stop the vehicle, pull the tilt wheel release
lever under the steering column down,
adjust the wheel, then push the release
lever up to lock the column.
After adjusting, push the wheel up and
down to be certain it’s locked before
driving.

Outside Mirrors
Check the mirrors’ angles before driving.
Manual control mirror
Adjust by hand.
Power control mirror
The ignition switch must be in the ACC or
ON position.
To a d j u s t :
1. Move the selector switch to the left or
right to choose the mirror.
Steering Wheel
Adjusting the Steering Wheel:
Adjusting the steering wheel while the
vehicle is moving is dangerous.
Moving it can very easily cause the
driver to abruptly turn to the left or
right. This can lead to loss of control
or an accident. Never adjust the
steering wheel while the vehicle is
moving.
WARNING
Tilt wheel release
lever
Mirrors
Convex Mirror (Passenger Side):
Changing lanes without taking into
account the actual distance of the
vehicle in the convex mirror is
dangerous. You could have a serious
accident. What you see in the convex
mirror is closer than it appears. Be
sure to look over your shoulder or to
check your inside mirror before
changing lanes.
WARNING
Outside mirror
J16L_8R21-EA-02G.book Page 31 Saturday, June 8, 2002 11:16 AM