lock MAZDA MODEL MX-5 MIATA 2002 User Guide
Page 38 of 248
3-4
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
To lock any door with the door-lock
button from the outside, push its door-
lock button and close the door.
Power Door Locks
Locking, unlocking with key
All doors lock automatically when any
door is locked with a key. All doors
unlock when the driver
’s door is unlocked
and the key is held in the unlock position.
Also, all doors unlock when the
passenger ’s door is unlocked. Locking, unlocking with door-lock
switch
All doors lock automatically when LOCK
is pushed. They all unlock when the
unmarked part of the door-lock switch is
pushed.
NOTE
When locking the doors this way, be
careful not to leave the key inside the
vehicle.
Door-lock button
Unlock
Lock
NOTE
Holding the key in the unlocked
position in the driver's door lock for
about a second unlocks all doors. To
unlock only the driver's door, insert a
key into the driver's door lock and turn
the key briefly to the unlock position
and then immediately return it to the
center position.
UnlockLock
J07L(02MY).book Page 4 Monday, June 11, 2001 4:52 PM
Page 39 of 248
3-5
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
This system locks and unlocks the doors
and opens the trunk.
It can also help you signal for attention in
an emergency.
Press the button slowly and accurately.
Keyless Entry System
To avoid damage to the transmitter, do
not:
•Drop it.
• Get it wet.
• Disassemble it.
• Expose it to heat or sunlight.
CAUTION
NOTE
•The keyless entry system is
designed to operate up to about 2.5
m (8 ft) from the center of the
vehicle, but this may vary because
of local conditions.
• The system doesn
’t operate when
the ignition switch is in the ON
position.
• If the transmitter does not operate
when pressing a button or the
operation range becomes too small,
the battery may be dead. To install a
new battery, refer to Maintenance
(page 3-7).
• Additional transmitters can be
obtained at an Authorized Mazda
Dealer. Up to 3 additional
transmitters can be used with the
keyless entry system per vehicle.
Bring all transmitters to an
Authorized Mazda Dealer when the
electronic codes need to be reset.
J07L(02MY).book Page 5 Monday, June 11, 2001 4:52 PM
Page 40 of 248
3-6
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Transmitter
Lock button
To lock the doors, press the LOCK button
and the hazard warning lights will flash
once.
To confirm that all the doors have been
locked, press the LOCK button again
within 5 seconds. If they are closed and
locked, the horn will sound and the hazard
warning lights will flash once. Unlock button
To unlock the driver
’s door, press the
UNLOCK button and the hazard warning
lights will flash twice.
To unlock all the doors, press the
UNLOCK button again within 5 seconds
and the hazard warning lights will flash
twice.
Trunk button
To open the trunk, press the button.Panic button
You can use the button to turn on the
alarm, which allows you to signal for
attention in an emergency.
NOTE
This device complies with part 15 of
the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation. (Outside
transmissions may momentarily
interfere with the device ’s operation.)
Panic button Lock button
Trunk button Unlock button
NOTE
Confirm that all the doors are locked
visually or aurally by use of the double
click.
NOTE
After unlocking with the transmitter,
all doors will automatically lock if one
of the doors is not opened within about
30 seconds.
NOTE
The alarm will work whether any door
is open or closed.
J07L(02MY).book Page 6 Monday, June 11, 2001 4:52 PM
Page 41 of 248
3-7
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Turning on the alarm
Pressing the button once will trigger the
alarm for about 2 minutes and 30 seconds,
and do the following:
•The horn sounds intermittently.
• The headlights flash. (except Canada)
• The hazard warning lights flash.
Turning off the alarm
Press any button on the transmitter. Maintenance
NOTE
If the LOCK and UNLOCK button are
pressed sequentially, the hazard
warning flasher may not flash
correctly.
• Make sure the battery is installed
with the correct pole facing upward.
Battery leakage could occur if it is
not installed correctly.
• When replacing the battery, be
careful not to bend the electrical
terminals or get oil on them. Also
be careful not to get dirt in the
transmitter as it could damage it.
• Danger of explosion if battery is
incorrectly replaced.
• Replace only with the same type
battery (CR2025 or the equivalent).
• Dispose of used batteries according
to the following instructions.
Insulate the plus and minus
terminals of the battery using
cellophane or equivalent tape.
Never disassemble.
Never throw the battery into fire
and/or water.
Never deform or crush.
CAUTION
J07L(02MY).book Page 7 Monday, June 11, 2001 4:52 PM
Page 42 of 248
3-8
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Replacing the transmitter battery
1. Insert a small screwdriver into the slot and gently pry open the transmitter.
2. Press the portion of the battery indicated by A and remove the battery. 3. Install a new battery (CR2025 or the
equivalent) into the front portion of the
holder with the positive pole ( )
facing up. Press on the B portion of the
battery to set the battery.
4. Align the front and back covers and snap the transmitter shut.
Slot
Back cover
A
Do not press any buttons when
replacing the battery. The electronic
code could be altered and cause the
keyless entry system to malfunction.
If the keyless entry system fails to
operate, contact an Authorized Mazda
Dealer.
B Back cover
Front
cover Front of
holder
CAUTION
J07L(02MY).book Page 8 Monday, June 11, 2001 4:52 PM
Page 43 of 248
3-9
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Service
If you have a problem with the keyless
entry system, consult an Authorized
Mazda Dealer.
If your transmitter is lost or stolen, bring
all remaining transmitters to an
Authorized Mazda Dealer as soon as
possible for a replacement and to make
the lost or stolen transmitter inoperative. The ignition switch must be in the ON
position for the power windows to
operate.
• Changes or modifications could
void your right to operate the
keyless entry system.
• Damage to your keyless entry
system will affect the vehicle
warranty coverage.
CAUTION
Power Windows
Closing Power Windows:
Closing power windows are
dangerous. A person
’s hands, head,
or even neck could be caught by the
window and result in serious injury or
even death.
This warning applies especially to
children. Make sure the opening is
clear before closing a window.
To prevent burning out the fuse and
damaging the power window system,
don ’t open or close more than two
windows at once.
WARNING
CAUTION
J07L(02MY).book Page 9 Monday, June 11, 2001 4:52 PM
Page 44 of 248
3-10
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Operating the Driver’s Side
Power Window
To open the window, push down the
switch.
To close the window, pull up the switch.
Auto-opening
To fully open the window automatically,
push the switch completely down.
To stop the window partway, pull up the
switch and then release it.
Operating the Passenger Power
Window
To open the window, push down the
switch.
To close the window, pull up the switch.
Opening the Hood
1. With the vehicle parked, pull the
release handle to unlock the hood.
2. Pull the safety catch up and lift the hood.
Open
Close
Left
window
Close
Open
Right window
Hood
Release handle
Safety catch
J07L(02MY).book Page 10 Monday, June 11, 2001 4:52 PM
Page 45 of 248
3-11
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
3. Use the support rod to hold the hood open.
Before closing the hood, secure the rod in
its clip.
Closing the Hood
1. Check under the hood area to make
certain all filler caps are in place and
all loose items (e.g. tools, oil
containers, etc.) have been removed.
2. Close the hood so that it locks securely.
Key-Operated Trunk
To open the trunk lid, insert the key into
the slot and turn it clockwise.
To close, use both hands to push the lid
down until the lock snaps shut. Don
’t
slam it.
Then pull up on it to make sure it ’s secure.
Clip
Support rod
Trunk Lid
Open Trunk and Exhaust Gas:
Exhaust gas in the cabin of a vehicle
is dangerous. This gas contains CO
(carbon monoxide), which is
colorless, odorless, and highly
poisonous. If inhaled, it can cause
loss of consciousness and death.
Because exhaust gas can get into the
cabin through an open trunk, keep
the trunk closed when driving.
WARNING
Open
J07L(02MY).book Page 11 Monday, June 11, 2001 4:52 PM
Page 46 of 248
3-12
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Remote Trunk Lid Release
The remote trunk lid release is mounted in
the center console.
To open the console, pull the release
catch.
To release the trunk lid, pull up on the
trunk lid release lever.
Remote Trunk Lid Release Lock-
Out
The remote release may be canceled to
prevent anyone in the vehicle from
opening the trunk.
Close the trunk, insert the key, and turn it
counterclockwise, then return the key to
the center position and remove it.
To activate the remote release, insert the
key, turn it clockwise and open the trunk
lid at the same time.
Trunk lid
release
lever
NOTE
If the remote trunk lid release does not
work, insert the key and turn it
clockwise.
J07L(02MY).book Page 12 Monday, June 11, 2001 4:52 PM
Page 47 of 248
3-13
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Trunk Light
The trunk light is on when the lid is open
and off when it's closed. Your vehicle is equipped with a trunk
release handle that provides a means of
escape for children and adults in the event
they become locked inside the trunk.
No matter how careful adults might be
with keys and locking their cars, parents
should be aware that children may be
tempted to play around vehicles and use
the trunk as a hiding place.
Adults are advised to familiarize
themselves with the operation and
location of the release handle so that all
children can be told about it in an
appropriate way, keeping in mind that
most vehicles don
’t have such handles.
Trunk Release Handle
J07L(02MY).book Page 13 Monday, June 11, 2001 4:52 PM