bulb MAZDA MODEL PROTÉGÉ 2002 Owners Manual (in English)
Page 128 of 270
5-34
Driving Your Mazda
Switches and Controls
Form No. 8Q36-EA-01F
Turn Signal
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The signal will self-cancel after
the turn is completed.
If the indicator light continues to flash
after a turn, manually return the lever to
its original position.
Green indicators on the dashboard show
which signal is working.
Lane-change signals
Move the lever slightly toward the
direction of the change —until the
indicator flashes— and hold it there. It
will return to the off position when
released.Use this switch to turn on the fog lights.
They help you to see as well as to be seen.
To turn on the fog lights, first turn on the
headlight switch. Then press the fog light
switch.
To turn the fog lights off, press the fog
light switch again or turn the headlight
switch off.
Turn and Lane-Change
Signals
NOTE
If an indicator light stays on without
flashing or if it flashes abnormally, the
turn signal bulb may be burned out.
Right turn
Left turn Right lane
change
Left lane
changeOFF
Fog Lights
J39L(02MY).book Page 34 Thursday, November 1, 2001 10:49 AM
Page 193 of 270
8-1
Form No. 8Q36-EA-01F
8Maintenance and Care
How to keep your Mazda in top condition.
Introduction
................................................................................. 8- 2
Introduction ............................................................................. 8- 2
Scheduled Maintenance
.............................................................. 8- 3
Scheduled Maintenance (Except Chile) .................................. 8- 3
Scheduled Maintenance (Chile) .............................................. 8- 6
Owner Maintenance
.................................................................... 8- 8
Owner Maintenance Schedule ................................................. 8- 8
Owner Maintenance Precautions ............................................. 8- 9
Engine Compartment Overview .............................................. 8-10
Engine Oil ................................................................................ 8-11
Engine Coolant ........................................................................ 8-14
Brake/Clutch Fluid .................................................................. 8-16
Power Steering Fluid ............................................................... 8-18
Automatic Transaxle Fluid (ATF) ........................................... 8-18
Washer Fluid ............................................................................ 8-20
Body Lubrication ..................................................................... 8-21
Air Filter .................................................................................. 8-21
Wiper Blades ........................................................................... 8-22
Battery ..................................................................................... 8-25
Tires ......................................................................................... 8-26
Light Bulbs .............................................................................. 8-30
Fuses ........................................................................................ 8-39
Appearance Care
......................................................................... 8-43
How to Minimize Environmental Paint Damage ..................... 8-43
Exterior Care ........................................................................... 8-45
Interior Care ............................................................................ 8-48
J39L(02MY).book Page 1 Thursday, November 1, 2001 10:49 AM
Page 222 of 270
8-30
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
Light Bulbs
License plate lights Front side-marker lights
Overhead lights/Map lights Sedan
Headlights
Front turn signal lights/
Parking lights
Brake lights/Taillights
Rear turn signal lights
Reverse lights
Taillights
High-mount brake light
Trunk light
Rear side-marker lights
J39L(02MY).book Page 30 Thursday, November 1, 2001 10:49 AM
Page 224 of 270
8-32
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
Your Mazda’s headlights have replaceable
halogen bulbs.Replacing a Headlight Bulb
Sedan
1. Make sure the headlight switch is off.
2. Lift the hood and find the bulb in the
rear of the headlight body.
3. Detach the electrical connector from
the bulb by pulling it to the rear.
4. Pull off the sealing cover.
5. Unhook the bulb retaining spring.
6. Swing the retaining spring out and
away to free the headlight bulb.
7. Carefully remove the headlight bulb
from the socket by pulling it straight
back.
8. Replace the bulb.
Handling Halogen Bulbs:
When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurized gas. If one is broken, it
will explode and serious injuries
could be caused by the flying glass.
If the glass portion is touched with
bare hands, body oil could cause the
bulb to overheat and explode when lit.
Never touch the glass portion of the
bulb with your bare hands and always
wear eye protection when handling or
working around halogen bulbs.
Children and Halogen Bulbs:
Playing with a halogen bulb is
dangerous. Serious injuries could be
caused by dropping a halogen bulb or
breaking it some other way.
Always keep halogen bulbs out of the
reach of children.
WARNING
Sedan
Hatchback
Headlight low beamDo not touch the glass surface
Headlight main beam
Sealing cover
J39L(02MY).book Page 32 Thursday, November 1, 2001 10:49 AM
Page 225 of 270
8-33
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
9. Install in the reverse order of removal.
Hatchback
1. Make sure the headlight switch is off.
2. Lift the hood and find the bulbs in the
rear of the headlight body.
(Low beam bulb)
3. Detach the electrical connector from
the bulb by pulling it to the rear.
4. Pull off the sealing cover.5. Unhook the bulb retaining spring.
6. Swing the retaining spring out and
away to free the headlight bulb.
7. Carefully remove the headlight bulb
from the socket by pulling it straight
back.
8. Replace the bulb.
9. Install in the reverse order of removal.
(High beam bulb)
10.Turn the socket and bulb assembly
counterclockwise and remove it.
Carefully remove the headlight bulb
from its socket in the reflector by
gently pulling it straight backward out
of the socket.
NOTE
•When reinstalling the sealing cover,
make sure faces up.
•Use the protective cover and carton
to dispose of the old bulb promptly
out of the reach of children.
NOTE
•When reinstalling the sealing cover,
make sure faces up.
•Use the protective cover and carton
to dispose of the old bulb promptly
out of the reach of children.
Sealing cover
J39L(02MY).book Page 33 Thursday, November 1, 2001 10:49 AM
Page 226 of 270
8-34
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
11.Remove the bulb from the electrical
connector by pressing the tab on the
connector with your finger and pulling
the bulb upward.
12.Install the new bulb in the reverse
order of removal.
NOTE
Use the protective cover and carton to
dispose of the old bulb promptly out of
the reach of children.
J39L(02MY).book Page 34 Thursday, November 1, 2001 10:49 AM
Page 227 of 270
8-35
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
Replacing a Bulb (Front)
To replace the fog light bulbs, contact an Authorized Mazda Dealer.
To replace the front side-marker light bulbs (Hatchback), contact an Authorized Mazda
Dealer.
Front turn signal lights/Parking lightsFront side-marker lights
Sedan
J39L(02MY).book Page 35 Thursday, November 1, 2001 10:49 AM
Page 228 of 270
8-36
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
Replacing a Bulb (Interior)
Overhead light (Type B)
Map lights (Type B)Map lights (Type A)
Overhead light (Type A)
Overhead light (Type C)Luggage compartment light
(Hatchback)
J39L(02MY).book Page 36 Thursday, November 1, 2001 10:49 AM
Page 229 of 270
8-37
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
Replacing a Bulb (Rear)
Rear bulb access
(Sedan)
To replace the turn signal light, brake
light/taillight, side-marker light or reverse
light bulb, the trunk end trim must be
removed and the inside cover must be
partially opened.
1. Pull the center section of the plastic
retainer and remove the retainers and
the trunk end trim.
2. Remove the inside cover’s plastic
retainers and partially open the inside
cover.(Hatchback)
To replace the turn signal light, brake
light/taillight or reverse light bulb, remove
the caps and the cover.
Jack cover
J39L(02MY).book Page 37 Thursday, November 1, 2001 10:49 AM
Page 230 of 270
8-38
Maintenance and Care
Owner Maintenance
Form No. 8Q36-EA-01F
Brake lights/Taillights
Rear side-marker lights
Reverse lights
Taillights
Rear turn signal lights
High-mount brake light (Sedan) License plate lights
Trunk light (Sedan)
Sedan
Sedan
Hatchback
Hatchback Brake lights/Taillights
Rear turn signal lights
Reverse lights
Sedan
To replace the high-
mount brake light bulb,
contact an Authorized
Mazda Dealer.
J39L(02MY).book Page 38 Thursday, November 1, 2001 10:49 AM