stop start MERCEDES-BENZ CL-Class 2008 C216 Comand Manual

657 Practical hints
What to do if …?
During severe operating conditions,
e.g. stop-and-go traffic, the coolant tem-
perature may rise close to 248°F (120°C).
Display
Possible cause/consequence
Possible solution
Coolant Low
Stop Vehicle
Turn Engine Off
The coolant is too hot.

Stop the vehicle in a safe location or as soon
as it is safe to do so and immediately turn off
the engine.

Engage the electronic parking brake
(page 412).

Only start the engine again after the message
disappears. You could otherwise damage the
engine.

Observe the coolant temperature gauge in
the instrument cluster (
page 30).
Warning!
G


Driving when your engine is overheated
can cause some fluids which may have
leaked into the engine compartment to
catch fire. You could be seriously
burned.


Steam from an overheated engine can
cause serious burns which can occur
just by opening the engine hood. Stay
away from the engine if you see or hear
steam coming from it.
Stop the vehicle in a safe location away from
other traffic. Turn off the engine, get out of
the vehicle and do not stand near the vehicle
until the engine has cooled down.
!
The engine should not be operated with the
coolant temperature above 248°F (120°C). Do-
ing so may cause serious engine damage which
is not covered by the Mercedes-Benz Limited
Warranty.

659 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Coolant Low
Stop Vehicle
Turn Engine Off

Restart the engine.
If this message disappears from the multi-
function display:
Drive immediately to the nearest autho-
rized Mercedes-Benz Center.
If this message does not disappear from the
multifunction display:

Call Roadside Assistance.
The cooling fan for the coolant is malfunc-
tioning.

Observe the coolant temperature gauge in
the instrument cluster (
page 30).

Have the fan replaced as soon as possible.
You are driving with one or both doors
open.
The display symbol shows you which doors
are open.

Close the doors.

661 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Key Not
Detected
The SmartKey with KEYLESS-GO* is not
recognized while the engine is running be-
cause the SmartKey with KEYLESS-GO* is
not in the vehicle.

Stop the vehicle in a safe location or as soon
as it is safe to do.

Engage the electronic parking brake
(page 412).

Search for the SmartKey.
Otherwise the vehicle cannot be centrally
locked nor can the engine be started again
after the engine is stopped.
The SmartKey with KEYLESS-GO* is not
recognized while the engine is running be-
cause there is strong radio-frequency inter-
ference.

Stop the vehicle in a safe location or as soon
as it is safe to do.

Engage the electronic parking brake
(page 412).

Remove KEYLESS-GO* button from over
starter switch (
page 366).

Operate the vehicle with the SmartKey in the
starter switch.
The SmartKey with KEYLESS-GO* is mo-
mentarily not recognized.

Change the position of the SmartKey in the
vehicle.

If necessary, operate vehicle using SmartKey
with KEYLESS-GO* in starter switch under
KEYLESS-GO* button (
page 366).

680 Practical hintsWhat to do if …?Display
Possible cause/consequence
Possible solution
Shift to P
You have attempted to turn off the engine
with the KEYLESS-GO* start/stop button
and opened the driver’s door with the auto-
matic transmission not shift to park
positionP.

Shift the automatic transmission to park
positionP (
page 417).
or

Close the driver’s door.
You are driving with the trunk open.

Close the trunk (
page 501).
Check
Washer Fluid
The water level has dropped to approx.
1.1 US qts (1.0 l).

Add washer fluid (
page 560).
Lock Seat Backrest
Front Left
The driver seat backrest is not engaged.
The driver’s seat belt can not secure the
driver.

Fold back and push the seat backrest until
the seat cushion and seat backrest audibly
engage into the driving position.
Lock Seat Backrest
Front Right
The passenger seat backrest is not en-
gaged.
The front passenger’s seat belt can not se-
cure the passenger.

Fold back and push the seat backrest until
the seat cushion and seat backrest audibly
engage into the driving position.

684 Practical hintsUnlocking/locking in an emergencyUnlocking the vehicle
If you cannot unlock the vehicle with the
SmartKey or KEYLESS-GO*, unlock the
driver’s door and the trunk using the me-
chanical key. Removing the mechanical key
1Mechanical key locking tab
2Mechanical key

Move locking tab1 in the direction of
arrow.

Slide mechanical key2 out of the
housing.Unlocking the driver’s door

Insert mechanical key2 into the driv-
er’s door lock until it stops.

Turn mechanical key2 counterclock-
wise to position1 and hold it there.

Pull the door handle until the locking
knob moves up.
The driver’s door is unlocked.

Pull the door handle once more to open
the driver’s door.
i
Unlocking the vehicle with the mechanical
key and opening the driver’s door or the trunk
with the mechanical key will trigger the anti-theft
alarm system (
page 79).
To cancel the alarm, insert the SmartKey or
SmartKey with KEYLESS-GO* in the starter
switch.
1
Unlocking
2
Mechanical key

695 Practical hints
Replacing wiper blades
Vehicles with KEYLESS-GO*
Make sure the vehicle’s on-board elec-
tronics have status 1 (
page 366).

Turn combination switch to wiper
settingu (
page 400).

Press KEYLESS-GO start/stop button
repeatedly until windshield wipers
start.

Press KEYLESS-GO start/stop button
when the wiper arms are in a vertical
position.
Removing wiper blades
Fold the wiper arm forward until it
snaps into place.

Turn the wiper blade at a right angle to
wiper arm (arrow 1).

Slide the wiper blade sideways out of
the retainer in the direction of
arrow2.
Installing wiper blades
Slide the wiper blade onto wiper arm
until it locks in place.

Rotate the wiper blade into position
parallel to wiper arm.

Fold the wiper arm backward to rest on
the windshield. Make sure you hold
onto the wiper when folding the wiper
arm back.
!
Do not pull on the wiper blade inserts. They
could tear.
!
Make certain that the wiper blades are prop-
erly installed. Improperly installed wiper blades
may cause windshield damage.

696 Practical hintsFlat tirePreparing the vehicle
Park the vehicle in a safe distance from
moving traffic on a hard, flat surface
when possible.

Turn on the hazard warning flasher
(page 397).

Turn the steering wheel so that the
front wheels are in a straight ahead
position.

Shift the automatic transmission to
park positionP.

Engage the electronic parking brake.

Turn off the engine.

Have any passenger exit the vehicle at
a safe distance from the roadway.

Vehicles with SmartKey: Remove the
SmartKey from the starter switch.
Vehicles with KEYLESS-GO*: Open the
driver’s door (this puts the starter
switch in position0, same as with the
SmartKey removed from the starter
switch). The driver’s door then can be
closed again.
Remove the KEYLESS-GO*
start/stop button from the starter
switch.
Mounting the spare wheel
i
Open the door only when conditions are safe
to do so.
Warning!
G
The dimensions of the spare wheel are dif-
ferent from those of the road wheels. As a
result, the vehicle handling characteristics
change when driving with a spare wheel
mounted. Adapt your driving style accord-
ingly.
The spare wheel is for temporary use only.
When driving with spare wheel mounted,
ensure proper tire inflation pressure and
do not exceed a vehicle speed
of 50 mph (80 km/h).
Contact the nearest Mercedes-Benz Center
as soon as possible to have the spare wheel
replaced with a regular road wheel.
Never operate the vehicle with more than
one spare wheel mounted.
Do not switch off the ESP
® when a spare
wheel is mounted.

711 Practical hints
Towing the vehicle
Towing with front wheels raised

Vehicles with KEYLESS-GO*: Remove
the KEYLESS-GO start/stop button
from the starter switch (
page 366).

Insert the SmartKey into the starter
switch.

Switch on the ignition.

Switch off the automatic central lock-
ing (
page 363).

Depress the brake pedal.

Shift the automatic transmission to
neutral positionN.

If engaged, manually release the
electronic parking brake.

Switch off the ignition and leave the
SmartKey in the starter switch.
Warning!
G
When leaving the SmartKey or SmartKey
with KEYLESS-GO* in the starter switch, do
not leave children unattended in the vehicle.
It is possible for children to switch on the
ignition which could result in unsupervised
use of vehicle equipment. Unsupervised use
of vehicle equipment could result in an
accident and/or serious personal injury.
!
Keep in mind that it is important for the
SmartKey to be left in starter switch with the ig-
nition switched off. As soon as the SmartKey is
removed from the starter switch the automatic
transmission will shift to park positionP.
!
Make sure that the ignition is switched off.
If the starter switch is in position2, active brak-
ing action through the ESP
® may otherwise seri-
ously damage the brake system.
!
The vehicle may be towed only for distances
up to 30 miles (50 km) and at a speed not to ex-
ceed 30 mph (50 km/h).

744 IndexAudio AUX (COMAND) 125
Audio DVD
Fast forward/rewind (COMAND) 123
Menu overview (COMAND) 119
Pause function (COMAND) 121
Stop function (COMAND) 121
Auto-dimming, Rear view mirrors 383
Automatic climate control 491
Adjusting air distribution
(COMAND) 271
Adjusting air flow from air vents
(COMAND) 275
Adjusting air volume (COMAND) 271
Adjusting the footwell temperature
(COMAND) 274
Air recirculation mode 496
Central climate control menu
(COMAND) 272
Defrosting 494
Operating via COMAND 269
Rear window defroster 496
Selecting Mono mode
(COMAND) 273
Setting temperature (COMAND) 270
Setting the temperature 494Switching cooling on or off
(COMAND) 272
Automatic headlamp mode 301, 392
Automatic lighting control, Interior
lighting 398
Automatic locking when driving 363
Automatic shift program 427
Automatic transmission
Accelerator position 424
Automatic shift program 427
Emergency operation
(Limp-Home Mode) 433
Fluid 733
Fluid level 558
Gear ranges 426
Gear selector lever 417
Gear shifting malfunctions 433
Hill start assist system 425
Kickdown 424
Kickdown, manual shift program
(CL 63 AMG and CL 65 AMG) 432
Manual shift program mode
(CL 63 AMG and CL 65 AMG) 430
Program mode selector switch 427
Shifting procedure 420Starting the engine 406
Steering wheel gearshift control 428
Transmission fluid 558
Transmission positions 421
AUX
Audio 125
Video 126
AUX jacks 125
B
Backup lamps
Replacing bulbs 689
Bar 586
BAS 67
Batteries, SmartKey
Checking battery condition 361
Replacing 686
Batteries, SmartKey with KEYLESS-GO*
Checking battery condition 361
Replacing 686
Batteries, vehicle 702
Charging 705
Discharged, Jump starting 707
Disconnecting 704
For electrical consumers 702
For starter 702