buttons MERCEDES-BENZ E-Class 2004 W211 Comand Manual
Page 54 of 168
53 Audio
CD changer* operation
The following options are available:
Ejecting all CDs (
page 54)
Ejecting one CD
Ejecting one CD
1CD slot
2Magazine compartment buttons
Access the CD changer* (
page 49).
Briefly press the appropriate magazine
compartment button 2.
The button LED 2 flashes red. The CD
changer* ejects the CD.
Within 15 seconds, remove the CD
from the slot 1.
The CD will be retracted again if it is not
removed from the slot within 15 sec-
onds. The system starts playing the CD
again.
The ejection procedure is completed.
Retract the CD changer* (
page 49).
Ejecting CDs
iIf you are listening to a CD in the CD
changer and you eject another CD from
the changer:
While ejecting the CD, the system
interrupts CD playback.
The CD you were last listening to
starts from the beginning once the
ejection procedure is completed.
If you eject the CD you are currently lis-
tening to:
The next available audio CD is
played.
If there are no other CDs available,
the system switches to the audio
source listened to before CD mode.
Page 87 of 168
86 Telephone*Phone bookThe following options are now available:
Switching the phone book display from
COMAND (
page 86).
Selecting a phone book entry and call
initiation (
page 86).
Deleting a phone book entry from CO-
MAND (
page 87).
Switching the phone book display
Open the phone book from COMAND
(page 85).
Press the 123 soft key.
This switches the display to number
display. The name of the highlighted
entry is shown in the status bar;
or
Press the ABC soft key.
This switches the display to name dis-
play. The number of the highlighted en-
try is shown in the status bar.
On the COMAND control unit
Open the Phone Book main menu
(page 85).
As described in the “COMAND phone
book display” section (
page 85), a
list of phone book entries appears, be-
ginning with a specific first letter (ini-
tial).Changing initials:
Press or once or repeatedly.
Each time you press the button, the
display changes to the next letter up or
down. At the end of the list of letters is
the category Other.
This category combines all entries
without a name, or entries whose
names start with a special character
(e.g. * or #).
Selecting an entry:
If necessary, change the initial letter
(page 86).
Select an entry. You can scroll through
the list using or .
If you press and hold either one of the
buttons, the scrolling up or down accel-
erates.
Selecting a phone book entry and es-
tablishing the connection
Page 95 of 168
94 Navigation*Important notesWarning
G
For safety reasons, you should only enter a
destination when the vehicle is stationary.
When the vehicle is in motion, a passenger
should enter the destination. Study manual
and select route before driving.
Do not watch display screen or operate but-
tons while the vehicle is in motion - let voice
instructions guide you. Stop at a safe loca-
tion before using buttons or making correc-
tions.
Traffic regulations always have priority over
any route recommendations given.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate-
ly 14 m) every second.
The route calculated by COMAND is a rec-
ommendation on how to best reach your se-
lected destination.
During route guidance, you will not receive
any information on
Traffic lights
Stop and yield signs
Parking or stopping zones
One-way streets
Narrow bridges
Similar traffic regulation data
You should therefore always strictly observe
traffic regulations while driving. Drive care-
fully and always obey traffic laws and road
signs even if they contradict COMAND in-
structions.
Warning
G
The Navigation DVD module contains a
Class 1 laser product. There is a danger of
invisible laser radiation if the cover is
opened or damaged.
Do not remove the cover. The Navigation
DVD module does not contain any parts
which can be serviced by the user. For safe-
ty reasons, have any service work which
may be necessary performed only by quali-
fied personnel.
Page 116 of 168
115 Navigation*
Destination entry
Selectable soft keys:
soft key:
The map scale will change to display a
more detailed map.
soft key:
The map scale will change to display a
map that shows a wider area.
Memory soft key
The current location is stored
(page 101).
This soft key is visible only if the map
has been called up using.
.
Move the cursor using, , or
to select the desired destination.
Release the buttons.If the system finds a street name at the
location the cursor is pointing to, the
corresponding street name is shown in
the status bar.
In this example: WATER ST
Press .
The system sets the location the cursor
is pointing to as the destination.
The Start Route Guidance menu
(page 116) appears.
iThe cursor can also be moved diagonal-
ly using and .
iThe destination selection will be lost
when pressing the Back soft key.
The system reverses to the details of
the previously entered destination.