MERCEDES-BENZ EQA SUV 2022 Owners Manual

Page 131 of 461

&
DANGER Risk of deat h due to using the
socket incorrectly
In particular, you could receive an electric
shoc
k:
= if you touch the inside of the socket
= if you insert unsuitable devices or objects
into the socket 
Do not touch the inside of the socket. 
Only connect suitable devices to the
soc

ket. Make sure that no liquids get into the 230 V
soc
ket.
When the 230 V socket is not in use, keep the
socket Oap closed.
Requirements: = The de

vice is equipped with a suitable plug
which conforms to the standards speciNc to
the country you are in.
= A device up to a maximum of 150 W (0.65 A)
is used.
= Do not use multiple socket outlets. 
Open socket Oap 3. 
Insert the plug of the device into 230 V socket
1.
When t
he on-board electrical system voltage is
suPcient, indicator lamp 2 lights up. USB port in the rear passenger compartment
%
Depending on the vehicle equipment, the
design of t

he stowage compartment and the
number of USB ports in the rear centre con-
sole may vary.
When the vehicle is switched on, you can charge a
USB de
vice, such as a mobile phone, at USB ports
using a suitable charging cable. Wireless charging of the mobile phone and con-
nection wit

h the exterior aerial Notes on wirelessly charging the mobile phone
&
WARNING Risk of injur
y due to objects
being stowed incorrectly
If objects in the vehicle interior are stowed
incor
rectly, they can slide or be thrown around
and hit vehicle occupants. In addition, cup
holders, open stowage spaces and mobile
phone receptacles cannot always retain all
objects within. 128
Seats and stowing

Page 132 of 461

There is a risk of injury, particularly in the
e
vent of sudden braking or a sudden change
in direction. 
Always stow objects so that they cannot
be t
hrown around in such situations. 
Always make sure that objects do not
pr

otrude from stowage spaces, luggage
nets or stowage nets. 
Close the lockable stowage spaces
bef
ore starting a journey. 
Always stow and secure heavy, hard,
point
ed, sharp-edged, fragile or bulky
objects in the boot/load compartment. Observe the notes on loading the vehicle.
&
WARNING Risk of Nr
e from placing objects
in the mobile phone stowage compart-
ment
Placing other objects in the mobile phone
s
towage compartment could constitute a Nre
hazard. 
Apart from a mobile phone, do not place
an

y other objects in the mobile phone
stowage compartment, especially those
made of metal. *
NOTE Damag
e to objects caused by plac-
ing them in the mobile phone stowage
compartment If objects are placed in the mobile phone
s

towage compartment, these may be dam-
aged by electromagnetic Nelds. 
Do not place credit cards, storage
media, ski passes or o

ther objects sensi-
tive to electromagnetic Nelds in the
mobile phone stowage compartment. *
NOTE Damag
e to the mobile phone stow-
age compartment caused by liquids If liquids enter the mobile phone stowage
com
partment, the compartment may be dam-
aged. 
Ensure that no liquids enter the mobile
phone s
towage compartment. The following notes on wirelessly charging the
mobile phone mus

t be observed:
= Depending on the vehicle equipment, the
mobile phone is connected to the vehicle's
exterior aerial via the charging module.
= The charging function and wireless connection
of the mobile phone to the vehicle's exterior
aerial are only available if the vehicle is
switched on.
= Small mobile phones may not be able to be
charged in every position of the mobile phone
stowage compartment.
= Large mobile phones which do not rest Oat in
the mobile phone stowage compartment may
not be able to be charged or connected with
the vehicle's exterior aerial.
= The mobile phone may heat up during the
charging process. This may particularly
depend on the applications (apps) currently
open in the background.
= To ensure more ePcient charging and connec-
tion with the vehicle's exterior aerial, remove
the protective cover from the mobile phone. Seats and stowing
129

Page 133 of 461

Protective covers which are necessary for
wir eless charging are an exception. Charging a mobile phone wirelessly
Requirements:
= The mobile phone is suit

able for wireless
charging.
A list of compatible mobile phones can be
found at: https://www.mercedes-benz-
mobile.com. 
Place the mobile phone as close to the centre
of t

he marked surface on mat 1 as possible
with the display facing upwards.
When a message is shown in the multimedia
system, the mobile phone is being charged.
Malfunctions during the charging process are
shown in the central display.
% The mat can be removed for cleaning, e.g.
using clean, luk

ewarm water.
Stowage compartment without cover
Mak
e sure the mobile phone is properly stored
and secured to prevent it from falling out while
you are driving. 
To secure the mobile phone: swing le
ver 2
out.
Radio equipment approval numbers for Brazil
This de
vice operates on a secondary basis, that is
to say it has no protection against harmful inter-
ference, not even from the same type of stations,
and must not cause interference with systems
operating on a primary basis.
This product is permitted in accordance with the
procedure deNned in Directive 242/2000 by the
Brazilian telecommunications agency ANATEL and
meets the applicable technical requirements.
Further information is available on the ANATEL
website. www.anatel.gov.br 
Further information on the declaration of con-
f

ormity for vehicle components which receive
and/or transmit radio waves. 130
Seats and stowing

Page 134 of 461

Fitting/removing the
Ooor mats &
WARNING Risk of accident due t o objects
in the driver's footwell
Objects in the driver's footwell may impede
pedal tr
avel or block a depressed pedal.
This jeopardises the operating and road safety
of the vehicle. 
Stow all objects in the vehicle securely
so t
hat they cannot get into the driver's
footwell. 
Always Nt t
he Ooor mats securely and as
prescribed in order to ensure that there
is always suPcient room for the pedals. 
Do not use loose Ooor mats and do no
t
place Ooor mats on top of one another. 
To Nt: slide the corresponding seat backwards
and lay the Ooor mat in the footwell. 
Press studs 1 ont
o holders 2. 
Adjust the corresponding seat. 
To remove: slide t
he corresponding seat back-
wards and pull the Ooor mat oM holders 2. 
Remove the Ooor mat. Seats and stowing
131

Page 135 of 461

Exterior lighting
Notes on changing the lights when driving abroad
It is not necessary to adjust the headlamps. The
leg
al requirements are also met in countries in
which traPc drives on the other side of the road. Information about lighting systems and your
r
esponsibility The various lighting systems of the vehicle are
onl
y aids. The driver of the vehicle is responsible
for correct vehicle illumination in accordance with
the prevailing light and visibility conditions, legal
requirements and traPc situation. Light switch
Operating the light switch
1
W Les-hand par
king lights
2 X Right-hand par
king lights
3 ` S
tanding lights and licence plate light-
ing
4 X A
utomatic driving lights (preferred light
switch position) 5
L Lo
w beam/high beam
6 ^ Switc
hes the rear fog light on/oM
When low beam is activated, the ` indicat
or
lamp for the standing lights will be deactivated
and replaced by the L low-beam indicator
lamp. 
Always park your vehicle safely using suPcient
lighting, in accor
dance with the relevant legal
stipulations.
* NOTE Batt
ery discharging by operating the
standing lights Operating the standing lights over a period of
hour
s puts a strain on the battery. 
Where possible, switch on the right X
or les W par
king light. For vehicles that are wider than 2 m or longer
t
han 6 m, single-sided parking lighting is not per-
mitted in some countries. In this case, the stand-
ing lights are also switched on in the parking
lights position. 132
Light and sight

Page 136 of 461

If the battery is
insuPcientl y charged, the stand-
ing lights or parking lights will be switched oM
automatically to facilitate the next drive system
start.
The exterior lighting (except standing and parking
lights) will switch oM automatically when the driv-
er's door is opened.
= Observe the notes on surround lighting
( page 135).
Automatic driving lights function
When the vehicle is switched on, the standing
lights, low beam and daytime running lights are
switched on automatically depending on the light
conditions. &
WARNING Risk of accident when t
he
dipped beam is switched oM in poor visi-
bility
When the light switch is set to X, t
he
dipped beam may not be switched on auto-
matically if there is fog, snow or other causes
of poor visibility such as spray. 
In such cases, turn the light switch to
L. The automatic driving lights are only an aid. You
ar
e responsible for vehicle lighting.
Switching the rear fog light on/oM
R
equirements:
= The light switch is in the L or X posi-
tion. 
Press button ^ .
Please observe the countr
y-speciNc laws on the
use of rear fog lamps. Operating the combination switch for the lights
1
High beam
2 Turn signal light, right
3 Headlamp Oashing
4 Turn signal light, les 
Use the combination switch to select the
desir
ed function. Light and sight
133

Page 137 of 461

Switching on high beam

Turn the light switch to the L or X
position. 
Push the combination switch in the direction
of ar row 1.
When the high beam is activated, the indicator
lamp for low beam L will be deactivated
and replaced by the indicator lamp for high
beam K.
Switching oM high beam 
Push the combination switch in the direction
of ar
row 1 or pull it in the direction of arrow
3.
Headlamp Oashing 
Pull the combination switch in the direction of
ar
row 3.
Turn signal light 
To indicate br
ieOy: push the combination
switch brieOy to the point of resistance in the
direction of arrow 2 or 4.
The corresponding turn signal light will Oash
three times. 
To indicate permanently: push t
he combina-
tion switch beyond the point of resistance in
the direction of arrow 2 or 4. Activating/deactivating the hazard warning lights

Press button 1. The hazard warning lights will switch on automati-
call
y if:
= the airbag has been deployed.
= the vehicle is braked heavily from a speed of
more than 70 km/h to a standstill.
When you pull away again, the hazard warning
light system will switch oM automatically at
approximately 10 km/h. You can also switch oM
the hazard warning light system using button 1. Setting the exterior lighting
switc
h-oM delay time Multimedia system:
4 © 5
Settings 5
Lights
5 Ext. light. del. sw. off 
Set the switc
h-oM delay time.
When the vehicle's engine is switched oM, the
exterior lighting will be activated for the set
time. 134
Light and sight

Page 138 of 461

Switching the surround lighting
on/oMMultimedia system:
4 © 5
Settings 5
Lights
5 Surround lighting
When Surround lighting is activ
e, the exterior
lighting lights up for 40 seconds aser the vehicle
is unlocked. When you start the vehicle, the sur-
round lighting is deactivated and the automatic
driving lights are activated. 
Activate or deactivate the function. Interior lighting
Adjusting the interior lighting
Front overhead control panel
1
= F
ront les reading lamp
2 3 A
utomatic interior lighting control
3 J F
ront interior lighting
4 B R
ear interior lighting
5 = F
ront right reading lamp 
To switch on or oM: pr
ess button 1 !

Page 139 of 461

Adjusting the brightness

Select Brightness. 
Adjust the brightness.
Activating the brightness for zones 
Select Brightness. 
Select Brightness zones .
Activate or deactivate the function.
or 
Set the brightness for the desired zones.
Activating multi-coloured lighting 
Select Colour .
Select Multi-colour .
Select a colour combination.
Activating multi-coloured animation 
Select Colour .
Select Multi-colour animat. .
The c hosen colour combination will change at
predeNned intervals. Activating welcome lighting 
Select Colour . 
Select Welcome .
When t
he vehicle is unlocked, a special ambi-
ent lighting sequence will run.
Activating the charge visualisation 
Select Colour . 
Select charge visualisation .
The ambient lighting pr
ovides visual feedback
on the diMerent states of charge when the
vehicle is connected to or disconnected from
the charging station.
Activating dependency on air conditioning set-
tings 
Select Colour . 
Select Climate .
If c
hanges are made to the temperature set-
ting in the vehicle, the colour of the ambient
lighting will change brieOy. Switching the interior lighting switc

h-oM delay
time on/oM Multimedia system:
4 © 5
Settings 5
Lights
5 Int. light. del. sw. off 
Switch the switc
h-oM delay time on or oM.
When this function is active, the interior light-
ing lights up for a short time aser the vehicle
is locked. 136
Light and sight

Page 140 of 461

Windscreen wipers and windscreen washer sys-
t em Switching the windscreen wipers
on/oM1
g W
indscreen wipers oM
2 Ä A
utomatic wiping, normal
3 Å A
utomatic wiping, frequent 4
° Continuous wiping, slo
w
5 ¯ Continuous wiping, f
ast 
Turn the combination switch to the corre-
sponding position 1 - 5. 
Single wipe/washing: push t
he button on the
combination switch in the direction of arrow
1.
= í Single wipe
= î Wipes with washer Ouid
% Observe the notes on washing the vehicle in a
car w

ash ( page 308). Switching the rear window wiper
on/oM 1

Page:   < prev 1-10 ... 91-100 101-110 111-120 121-130 131-140 141-150 151-160 161-170 171-180 ... 470 next >