MERCEDES-BENZ EQE 2023 Owners Manual

The fuse box is located in the center of the vehicle
under the seat.To open and close it, consult an authorized Mercedes-Benz Center.Breakdown assistance369

Notes on noise or unusual handling characteris-tics
Make sure there are no vibrations, noises or unusual handling characteristics when the vehicle
is in motion. This may indicate that the wheels or
tires are damaged. Hidden tire damage could also
be causing the unusual handling characteristics.
If you suspect that a tire is defective, reduce yourspeed immediately and have the tires and wheels
checked at a qualiNed specialist workshop.
Notes on regularly inspecting wheels and tires
&WARNING Risk of injury through damaged
tires
Damaged tires can cause tire pressure loss.
Check the tires regularly for signs of
damage and replace any damaged tires immediately.&WARNING Risk of hydroplaning due to
insuPcient tire tread
*nsuPcient tire tread will result in reduced tire
grip.
In heavy rain or slush the risk of hydroplaning is increased, in particular where speed is not
adapted to suit the conditions.
Thus, you should regularly check the
tread depth and the condition of the
tread across the entire width of all tires.
Minimum tread depth for:
= Summer tires:

Notes on snow chains&WARNING Risk of accident due to incor-
rectly installed snow chains
If you have installed snow chains on the front wheels, they may drag against the vehicle
body or chassis components.
Never install snow chains on the front
wheels.Only install snow chains on the rear
wheels in pairs.*NOTE Damage to components of the vehi-
cle body or chassis due to mounted snow
chains
If you mount snow chains to the front wheels
of 4MATIC vehicles, you may damage compo-
nents of the vehicle body or chassis.
Only mount snow chains to the rear
wheels of 4MATIC vehicles.*NOTE Damage to wheel trims due to snow
chains being installed
If you install snow chains on aluminum wheels
you could damage the wheel trims.
Remove the wheel trims from the alumi-
num wheels before installing snow
chains.
Observe the following notes when using snow
chains:
= Snow chains are only permissible for certain
wheel/tire combinations. You can obtain infor-
mation about this from an authorized
Mercedes-Benz Center.
= For safety reasons, only use snow chains that
have been speciNcally approved for your vehi-
cle by Mercedes-Benz, or snow chains with
the same quality standard.
= Comply with the installation instructions of the
snow chain manufacturer.
= If snow chains are installed, the maximum per-
missible speed is 30 mph (50 km/h).
= Vehicles with Active Parking Assist: do not use
Active Parking Assist when snow chains are
installed.
= Vehicles with rear axle steering: if snow chains
are installed, only drive with snow chain mode
active (  page 371).\bYou can deactivate ESP n
to pull away
(  page 216). This allows the wheels to spin,
achieving an increased driving force.
Activating or deactivating snow chain mode
Multimedia system: 4 © 5

Tire pressure
Notes on tire pressure
&WARNING Risk of accident due to insuP-
cient or excessive tire pressure
UnderinOated or overinOated tires pose in par-
ticular the following risks:
= The tires can burst.
= The tires can wear excessively and/or
unevenly.
= The driving characteristics as well as the
steering and braking characteristics may
be greatly impaired.
Comply with the recommended tire pres-
sures and check the tire pressure of all
tires, including the spare wheel, regu-
larly:
= Monthly
= When the load changes
= Before embarking on a longer journey
=
If operating conditions change, e.g. oM-
road drivingAdjust the tire pressure, if necessary.
Tire pressure which is too high or too low can:
= Shorten the service life of the tires.
= Cause increased tire damage.
= Adversely aMect driving characteristics and
thus driving safety, e.g. due to hydroplaning.
&WARNING Risk of accident due to too low
a tire pressure
Tires with pressure that is too low can over-
heat and burst as a consequence.
In addition, they also suMer from irregular
wear, which can signiNcantly impair the brak-
ing properties and the handling characteris-
tics.
Avoid excessively low tire pressure.
Tire pressure which is too low can cause:
= Tire defects as a result of overheating
=Impaired handling characteristics
= Irregular wear
= Increased energy consumption&WARNING Risk of accident due to too high
a tire pressure
Tires with excessively high pressure can burst.
In addition, they also suMer from irregular
wear, which can signiNcantly impair the brak-
ing properties and the handling characteris-
tics.
Avoid excessively high tire pressures.
Tire pressure which is too high can cause:
= Increased braking distance
= Impaired handling characteristics
= Irregular wear
= Impaired driving comfort
= Susceptibility to damage
372Wheels and tires

&WARNING Risk of accident due to repea-
ted pressure drop in the tires
The wheels, valves or tires could be damaged.
Too low a tire pressure can lead to the tires
bursting.
Examine the tires for foreign objects.Check whether the tire has a puncture or
the valve has a leak.If you are unable to rectify the damage,
contact a qualiNed specialist workshop.
You can Nnd information on tire pressure for the
vehicle\bs factory-installed tires on the following
labels on the B-pillar on the driver\bs side:
= Tire and Loading Information placard
(  page 377)
= Tire pressure table (  page 373).
Observe the maximum tire pressure
(  page 383).
Use a suitable pressure gage to check the tire
pressure. The outer appearance of a tire does not
permit any reliable conclusion about the tire pres-
sure.
Only correct tire pressures when the tires are
cold. Conditions for cold tires:
= The vehicle has been parked with the tires out
of direct sunlight for at least three hours.
= The vehicle has traveled less than 1 mile
(1.6 km).
The vehicle\bs tires heat up when driving. As the temperature of the tires increases, so too does
the tire pressure.
Vehicles with a tire pressure monitoring system: you can also see the tire pressure in the driver\bs display (  page 376).
The tire pressures recommended for increased
load/speed in the tire pressure table can aMect
the ride comfort.&WARNING Risk of accident due to unsuita-
ble accessories on tire valves
If you mount unsuitable accessories onto tire
valves, the tire valves may be overloaded and
malfunction, which can cause tire pressure
loss.Only screw standard valve caps or valve
caps speciNcally approved by Mercedes-
Benz for your vehicle onto the tire valve.
Tire pressure table
The tire pressure table is on the B-pillar on the driver\bs side.
\bThe data shown in the images is example
data.Wheels and tires373

The tire pressure table shows the recommended
tire pressure for all tires approved for this vehicle.
The recommended tire pressures apply for cold
tires under various operating conditions, i.e. load-
ing and/or speed of the vehicle.
If one or more tire sizes precede a tire pressure,
the tire pressure information following is only valid for those tire sizes.
The load conditions "partially laden" and "fully
laden" are deNned in the table for diMerent num-
bers of passengers and amounts of luggage. The actual number of seats may diMer from this.
Some tire pressure tables only show the rim diam-
eter instead of the complete tire size, e.g. R18.
The rim diameter is part of the tire size and can
be found on the tire side wall (  page 384).
Be sure to also observe the following further rela-
ted subjects:
= Notes on tire pressure (  page 372)
= Tire and Loading Information placard
(  page 377)
=
Maximum tire pressure (  page 383)
Checking the tire pressure manually
Read the tire pressure recommended for the
current operating conditions from the tire and
loading information placard or the tire pres-
sure table. Observe the notes on tire pressure.Remove the valve cap of the tire to be
checked.Press the tire pressure gauge securely onto the valve.Read the tire pressure.If the tire pressure is lower than the recom-
mended value, increase the tire pressure to
the recommended value.If the tire pressure is higher than the recom- mended value, release air. To do so, press
down the metal pin in the valve, e.g. using the
tip of a pen. Then check the tire pressure
again using the tire pressure gauge.Screw the valve cap onto the valve.374Wheels and tires

Further related subjects:
= Notes on tire pressure (  page 372)
= Tire pressure table (  page 373)
= Tire and loading information placard
(  page 377)
Tire pressure monitoring system

qFunction of the tire pressure monitoring system
&DANGER Risk of accident due to incorrect
tire pressure
Each tire, including the spare (if provided),
should be checked monthly when cold and inOated to the inOation pressure recommen-
ded by the vehicle manufacturer on the vehi-
cle placard or tire inOation pressure label. (If
your vehicle has tires of a diMerent size than
the size indicated on the vehicle placard or
tire inOation pressure label, you should deter-
mine the proper tire inOation pressure for
those tires.)
As an added safety feature, your vehicle has
been equipped with a tire pressure monitoring system (TPMS) that illuminates a low tire pres-sure telltale when one or more of your tires is
signiNcantly under-inOated. Accordingly, when
the low tire pressure telltale illuminates, you
should stop and check your tires as soon as
possible, and inOate them to the proper pres-
sure. Driving on a signiNcantly under-inOated
tire causes the tire to overheat and can lead
to tire failure. Under-inOation also reduces fuel
ePciency and tire tread life, and may aMect
the vehicle!

The tire pressure monitoring system is only an aid.
It is the driver\bs responsibility to set the tire pres-
sure to the recommended cold tire pressure suita-
ble for the operating situation.
In most cases, the tire pressure monitoring sys- tem will automatically update the new reference
values aser you have changed the tire pressure.
You can, however, also update the reference val-
ues by restarting the tire pressure monitoring sys- tem manually (  page 376).
System limits
The system may be impaired or may not function
particularly in the following situations:
= incorrect reference values were taught in
= sudden pressure loss caused by a foreign
object penetrating the tire, for example
= there is a malfunction caused by another radio
signal source

q Checking the tire pressure with the tire pres-
sure monitoring system
Requirements:
= The vehicle is switched on.Driver\bs display:
4 © 5
ServicePress v to conNrm.
One of the following displays appears:
= Current tire pressure of each wheel:
=Tire pressure displayed after driving for a
few minutes. : current values are not yet
known to the system. The pressure/tempera-
ture values of each tire are displayed as soon
as they are known to the system.
= Tire Pressure Monitor Active : the teach-in
process of the system is not yet complete. The
tire pressures are already being monitored.
Compare the current tire pressure with the
recommended tire pressure for the current
operating condition (  page 373). Addition-
ally, observe the notes on cold tires (  page 372).\bThe values displayed on the driver\bs display
may deviate from those of the tire pressure
gauge as they refer to sea level. At high eleva-
tions, the tire pressure values indicated by a tire pressure gauge are higher than those
shown on the driver\bs display.
Bear in mind the following related topic:
= Notes on tire pressure (  page 372)

q Restarting the tire pressure monitoring system
Requirements
= The recommended tire pressure is correctly
set for the respective operating status on each
of the four wheels (  page 372).
Restart the tire pressure monitoring system in the
following situations:
= The tire pressure has changed.
376Wheels and tires

=The wheels or tires have been changed or
newly installed.
Driver\bs display: 4 © 5
ServiceSelect Tire Pressure and conNrm with v.Swipe downwards on Touch Control on the
steering wheel.
The Use current pressures as new reference
values" message is shown in the driver\bs dis-
play.Select Yes and conNrm the restart with v.
The Tire Pressure Monitor Restarted message
is shown in the driver\bs display.
Current warning messages are deleted and
the yellow w warning lamp goes out.
Aser you have been driving for a few minutes,
the system checks whether the current tire
pressure values are within the speciNed range.
The current tire pressure values are then
accepted as reference values and monitored.
If the tire pressure levels are not within the
speciNed range, the Please Correct Tire Pres-
sure message appears.Note also the following related topic:
= Notes on tire pressure (  page 372)
Loading the vehicle
Notes on Tire and Loading Information placard
&WARNING Risk of accident from overloa-
ded tires
Overloaded tires may overheat and burst as a
consequence. Overloaded tires can also
impair the steering and handling characteris-
tics and lead to brake failure.
Observe the load rating of the tires.The load rating must be at least half the
permissible axle load of the vehicle.Never overload the tires by exceeding
the maximum load.
The Tire and Loading Information placard is on the
B-pillar on the driver\bs side of the vehicle.
1Tire and Loading Information placardWheels and tires377

\bThe data shown in the illustration is example
data.
The Tire and Loading Information placard shows
the following information:
= Maximum number of seats 2 according to
the maximum number of people permitted to
travel in the vehicle.
= Maximum permissible load 3 comprises the
gross weight of all vehicle occupants, load and luggage.
= Recommended tire pressure 1 for cold tires.
The recommended tire pressures are valid for
the maximum permissible load and up to the maximum permissible vehicle speed.
Please also note: = Information on permissible weights and loads
on the vehicle identiNcation plate
(  page 401).
= Information on tire pressure in the tire pres-
sure table (  page 373).
Further related subjects:
= Determining the maximum permissible load
(  page 378)
= Notes on tire pressure (  page 372).
Steps for Determining Correct Load Limit
The following steps have been developed as
required of all manufacturers under Title 49, Code
of U.S. Federal Regulations, Part 575, pursuant to
the "National TraPc and Motor Vehicle Safety Act
of 1966".(1): Locate the statement !