MERCEDES-BENZ GLE 2020 Owners Manual

Select Automatic , Day Design or Night
Design .
Switchingthetemperaturedisplayon/off
Select Temperature Display .Select Outside Temp. or Coolant Temp. .
The selected temperature is displayed in the instrument cluster.
Timeanddate
Settingthetimeanddateautomatically
Multimedia system:
4 © 5
Settings 5
System
5 Time and Date
Deactivate Manual Time Adjustment .
The time and date are set automatically for the selected time zone and summer time option.%The correct time is required for the followingfunctions: = Route guidance with time-dependent
traffic guidance.
= Calculation of expected time of arrival.Settingthetimezone
Requirements:
= Forthemanualtimezone: Automatic Time
Zone is switched off.
Multimedia system: 4 © 5
Settings 5
System
5 Time and Date
SettingthetimezonemanuallySelect Time Zone: .
The list of countries is displayed.%If there are several time zones available in a country, these will be shown after the coun

If a time zone is set the time is set automatically
using the time zone. The time can be adjusted by a maximum of plus or minus 60 minutes.Adjust the time using the slide control.
Settingthedate
Select Set Date .Set a date.%In vehicles with GPS, a date cannot be set
even with active manual time adjustments. The date is then set automatically through
the selected time zone.
Switchingvoiceamplificationtotherear
on/off(vehicleswithlongwheelbase)
Requirements:
= Your vehicle is equipped with the Burmester

Bluetooth

The type of connection established must be
selected on the multimedia system and on the
device to be connected.%The connection procedure may differ
depending on the device. Follow the instruc

Select Vehicle Hotspot .Select Connect Device to Vehicle Hotspot .
ConnectingusingWPSPINgeneration
Select Connect via WPS PIN Generation .Enter the PIN shown in the media display on
the device to be connected and confirm.
ConnectingusingWPSPINentry
Select Connect via WPS PIN Input .Enter the PIN that is shown on the external
device's display on the multimedia system.
Connectingusingabutton
Select Connect via WPS PBC .Press the push button on the device to be
connected (see the manufacturer's operating
instructions).Select Continue .
Connectingusingasecuritykey
Select Connect Device to Vehicle Hotspot .
A security key is displayed.Select the vehicle from the device to be con

the characters available for entry. The navigationannouncements are not available in all lan

originates from another vehicle, this is recog

=Activation of the update by restarting the
system
The multimedia system provides a message
when an update is available.
Depending on the source, you can perform vari

Select an update from the list and start theupdate.
Activatingthesoftwareupdate
Restart the system.
The modifications from the software update
will be active.
Functionofimportantsystemupdates
Important system updates may be necessary for the security of your multimedia system's data.Install these updates, or else the security of your
multimedia system cannot be ensured.
%If automatic software updates are activated, the system updates will be downloaded auto

A prompt appears again asking whether youreally wish to reset.Select Yes.
The multimedia system is reset to the factory settings. If you have set a PIN for your sys