MERCEDES-BENZ GLE 2020 Owners Manual

Turn cap 1 counter-clockwise and remove
it.Add engine oil.Replace cap 1 and turn it clockwise as far
as it will go.Check the oil level again (  page 457).Checkingcoolantlevel&WARNING Risk of burns from hot com

Continue turning cap 1 counter-clockwise
and remove it.
The coolant level is correct in the following
cases:
= If the engine is cold, up to marker bar 2
= If the engine is warm, up to 0.6 in (1.5 cm)
over marker bar 2
If necessary, add coolant that has been
approved for Mercedes-Benz.
= Further information on coolant (  page 533)
Addingwasherfluidtothewindshield
washersystem
&WARNING Risk of burns from hot com

Keepingtheair-waterductfreeKeep the area between the hood and the
windshield free of deposits, e.g. ice, snow
and leaves.
Cleaningandcare
Notesonwashingthevehicleinacarwash
&WARNING Risk of accident due to
reduced braking effect after washing the
vehicle
The braking effect is reduced after washing the vehicle.
After the vehicle has been washed, brake carefully while paying attention to
the traffic conditions until the braking
effect has been fully restored.*NOTE Damage due to unsuitable car
washBefore driving into a car wash make
sure that the car wash is suitable for
the vehicle dimensions.Ensure there is sufficient ground clear

The following settings are made when car washmode is activated:
= The outside mirrors are folded down.
= The rain sensor is deactivated to prevent the
windshield washer system from starting up automatically.
= The rear window wiper is deactivated.
= The air conditioning system is set to air-recir

If one of the settings cannot be selected, this isdisplayed by a behind the respective set

Notesonpaintwork/mattefinishpaintworkcare
Observethefollowinginformation:
CleaningandcareAvoidingpaintworkdamageandinterferencetothedriverassistancesystemsPaintwork= Insect remains: soak with insect remover and rinse off the
treated areas afterwards.
= Bird droppings: soak with water and rinse off afterwards.
= Tree resin, oils, fuels and greases: remove by rubbing gen

CleaningandcareAvoidingpaintworkdamageandinterferencetothedriverassistancesystemsMattefinishOnly use care products approved for Mercedes-Benz.= Do not attach stickers, films or similar materials. Only
have film attached to the bumper at a qualified specialist
workshop.
= Do not polish the vehicle and alloy wheels.
= Only use car washes that correspond to the latest engi

Observethefollowinginformation:CleaningAvoidingdamagetothedecorativefoil=For cleaning, use plenty of water and a mild cleaning agent without
additives or abrasive substances, e.g. a car shampoo approved for Mercedes-Benz.
= Remove dirt immediately, where possible, whilst avoiding rubbing
too hard. There is otherwise a risk of damaging the decorative foil irreparably.
= If there is dirt on the finish or if the decorative foil is dull: use the
Paint Cleaner recommended and approved for Mercedes-Benz.
= Insect remains: soak with insect remover and rinse off the treated
areas afterwards.
= Bird droppings: soak with water and rinse off afterwards.
= To prevent water stains, dry a foil-wrapped vehicle with a soft,
absorbent cloth after every car wash.= The service life and color of decorative foils are impaired by:
- Sunlight
- Temperature, e.g. hot air blower
- Weather conditions
- Stone chippings and dirt
- Chemical cleaning agents
- Oily products
= Do not use polish on matte decorative foil. Polishing will have the effect
of shining the foil-wrapped surface.
= Do not treat matte or structured decorative foils with wax. Permanent
stains may occur.Scratches, corrosive deposits, areas affected by corrosion and damage caused by incorrect care
cannot always be completely repaired. In such cases, visit a qualified specialist workshop.
You can obtain more information on care and cleaning products from the manufacturer.In the case of foil-wrapped surfaces, optical dif

Notesoncareofvehicleparts&WARNING Risk of entrapment if the
windshield wipers are switched on while
the windshield is being cleaned
If the windshield wipers are set in motion
while you are cleaning the windshield or
wiper blades, you can be trapped by the
wiper arm.
Always switch off the windshield wipers
and the ignition before cleaning the windshield or wiper blades.&WARNING Risk of burns from the tail

NotesoncleaningandcareAvoidingvehicledamageExteriorlightingClean the lenses with a wet sponge and mild cleaning agent,
e.g. car shampoo.Only use cleaning agents or cleaning cloths that are suitable
for plastic lenses.SensorsClean the sensors in the front and rear bumper and in the
radiator grill with a soft cloth and car shampoo.When using a power washer, maintain a minimum distance of
11.8 in (30 cm).RunningboardsUse water and acid-free cleaning agents.Do not clean the aluminum trim insert of the running board
with alkaline or acidic cleaning agents such as wheel clean