key MERCEDES-BENZ M-Class 2002 W163 Comand Manual
Page 158 of 165
154
Introduction Audio Telephone Navigation Index
System settings
Use the softkeys “-” and “+” or “L“ and “R“ to set
the desired value.
Once you are satisfied with the sound setting press soft-
key “EXIT”.
Press and hold both softkeys “-” and “+” for longer
then 2 seconds to reset the selected parameter.
Vehicles with sound system:
With the softkeys , and select the
parameter “SOUND“.
You can select with the softkeys , and
the desired sound impression.Sound impressions available:
• Standard - the sound is set to linear for the centre of
the vehicle
• Speech - emphasises voices
• Driver - the sound is set to the optimum values for
the front seats
• Ambience - recreates the sound of rooms
Note:
Sound optimisation is not available for the service
sources.
System settings
Page 159 of 165
155
Introduction Audio Telephone Navigation Index
System settings
Reset the sound settings:
Return to the audio menu and press the softkey
“ADJ” for longer then 2 seconds. All parameters will be
set to 0 and the sound system will switch to “STAN-
DARD“, and the MCS will return automatically to the
audio mode.Switching between
the light mode and the dark mode
When the parking lights are turned on, the display
switches to the dark mode. The display is illuminated in
a low dimmed level.P82.85-7160-26
P82.85-7156-26
System settings
Page 160 of 165
156
Introduction Audio Telephone Navigation Index
System settings
If you want to switch to the light mode in the audio
modes (radio, tape or CD) press the softkey “ADJ”
and then press the softkey “LGHT” .
If you are in the navigation mode, press any softkey to
activate the softkeys. Then press the softkey
“LGHT” .
To return to the dark mode in the audio modes (radio,
tape or CD) press the softkey “ADJ” and then
press the softkey “DARK”.
If you are in the navigation mode press any softkey to
activate the softkeys. Then press the softkey
“DARK” .Adjusting the brightness
in the dark mode
You can adjust the brightness with the instrument clus-
ter illumination. See Operator’s Manual.
System settings