jacking points MERCEDES-BENZ ML320 1997 Complete Repair Manual

LIFTING VEHICLE WITH PIT LIFT OR WORKSHOP JACK - AR00.60-P-1000-01GH
Lifting at front

Place inspection pit lift or garage jack at the front cross bridge for the front-axle carrier The garage jack can use
the side jacking points.
Fig. 638: Identifying Lifting At Front

Lifting at rear

Place inspection pit lift or
garage jack at the rear cross bridge for the rear-axle carrier The garage jack can use
5Synchronize sliding/pop-
up roof Refer also to operating
instructions.

Glass electric
sliding/tilting roof, code
(414a).GF77.20-P-3002GH
6Standardize lamella sliding
roof Refer also to operating
instructions.
Lamella sliding roof,
code (417a).GF77.20-P-3006GH
7Code radioMB Refer also to
operating instructions.AR82.60-P-7502-01B

Hi-Line, Premium with
Bose.
Refer also to operating
instructions.AR82.60-P-7502-01GH
8Calibrate compass See Operating
Instructions

2004 Mercedes-Benz ML350
1998-2005 GENINFO Overall vehicle - 163 Chassis
me
Saturday, October 02, 2010 3:47:52 PMPage 395 © 2006 Mitchell Repair Information Company, LLC.

the side jacking points.
Fig. 639: Identifyin g Lifting At Rear

RAISING, JACKING UP VEHICLE - AR00.60-P-1000GH
MODEL 163
Fig. 640: Raising, Jacking Up Vehicle

Fig. item, etc.Work instructions
Lethal injuries are
possible if vehicle slips
off of lifting platformAlign vehicle between the
four lifting platform pillars
and position the four
support plates at the hoist
mounting points specified
by the vehicle
manufacturer.AS00.00-Z-0010-01A
Danger of accident
through self-acting
movement of the vehicle
when jacked up Risk of
injury through intrusion
into engine compartment
or driveline where rotating
parts pose a serious
hazard.Make sure that the jack
stands are securely
positioned. Authorized
person should occupy
driver's seat. Wear closed
and close-fitting work
clothes. Do not grasp hot
or rotating parts.AS00.00-Z-0008-01A

2004 Mercedes-Benz ML350
1998-2005 GENINFO Overall vehicle - 163 Chassis
me
Saturday, October 02, 2010 3:47:52 PMPage 396 © 2006 Mitchell Repair Information Company, LLC.

Workshop equipment
MAINTENANCE
PREFACE - AP00.20-P-0000-01C
These "Service Documents" contain all the maintenance operations for the basic and national versions of the
following models:
Model 170, 129, 140, 202 as of 1.6.97
Model 210 as of 1.3.97
Models 163, 168, 203, 208, 209, 215, 220, 230
Type 414
This maintenance manual became necessary with the introduction of the Active Service System (ASSYST). It
contains all maintenance operations for vehicles with the Active Service System (ASSYST) and is divided into
the two volumes 4 and 4.1.
The system for demand-related complete vehicle maintenance is described in the Introduction into Service
manual "Active Service System (ASSYST)".
If the support plates are
not properly mounted
(012) at the vehicle's
designated jacking points
(1, 2) damage may occur
to the side sill covers (3).
The vehicle should be
secured against tipping or
falling off the platform
when removing any units.
Lifting vehicle with
inspection pit lift or
garage jack
Inspection pit lift.
AR00.60-P-1000-01GH
*WE58.40
-Z-1002-05A
1Forward jacking points
2Rear jacking points
3Side sill covers
011Lifting platform *WE58.40-Z-1001-05A
012Support platesAll four support plates
must be extended to an
equal distance (Dimension
X).
WE58.40-Z-1001-05ATwo-post lifting platform
WE58.40-Z-1002-05APit lift

2004 Mercedes-Benz ML350
1998-2005 GENINFO Overall vehicle - 163 Chassis
me
Saturday, October 02, 2010 3:47:52 PMPage 397 © 2006 Mitchell Repair Information Company, LLC.

AR00.60-P-1000-01GH
Lifting vehicle with pit lift or workshop jack

P00.60-2016-01

Lifting at front


Place inspection pit lift or garage jack at the front cross bridge for the front-axle carrier

The garage jack can use the side jacking points.

P00.60-2017-01

Lifting at rear

Place inspection pit lift or garage jack at the rear cross bridge for the rear-axle carrier
The garage jack can use the side jacking points.

Copyright DaimlerChrysler AG 17.05.2006 CD-Ausgabe G/10/04 . This WIS print-out will not be recorde
d by Modification services.
Page 1

AR00.60-P-1000GH
Raising, jacking up vehicle
27.1.00

MODEL
163

P00.60-2013-09

Fig. item, etc.
Work instructions


Danger!
Lethal injuries
are possible if vehicle slips off

of lifting platform
Align vehicle between the four lifting platform

pillars and position the four support plates
at

the hoist mounting points specified by the

vehicle manufacturer.

AS00.00-Z-0010-01A


Danger!
Danger of accident
through self-acting

movement of the vehicle when jacked up
Risk of injury
through intrusion into engine

compartment or driveline where rotating parts

pose a serious hazard.
Make sure that the jack stands are securely

positioned.

Authorized person should occupy driver's seat.

Wear closed and close-fitting work clothes.

Do not grasp hot or rotating parts.

AS00.00-Z-0008-01A


If the support plates are not properly mounted

(012) at the vehicle's designated jacking

points (1,2) damage may occur to the side sill

covers (3).


The vehicle should be secured against tipping

or falling off the platform when removing any

units.


Lifting vehicle with inspection pit lift or garage

jack

AR00.60-P-1000-01GH

Inspection pit lift.

*WE58.40-Z-1002-05A

1
Forward jacking points

2
Rear jacking points

3
Side sill covers

011
Lifting platform

*WE58.40-Z-1001-05A

012
Support plates
All four support plates must be extended to an

equal distance (Dimension X).

Workshop equipment/MB testers
(see Workshop Equipment Manual)

WE58.40-Z-1001-05A
Two-column lift

WE58.40-Z-1002-05A
Inspection pit lift

Copyright DaimlerChrysler AG 17.05.2006 CD-Ausgabe G/10/04 . This WIS print-out will not be recorde
d by Modification services.
Page 1