MINI 3 door 2016 Owner's Manual

CoolantVehicle
features
and
op

Adding1.Let the engine cool.2.Turn the lid of the coolant reservoir slightly
counterclockwise to allow any excess pres~
sure to dissipate, then open it.3.If the coolant is low, slowly add coolant up
to the specified level; do not overfill.4.Close cap.5.Have the cause of the coolant loss elimi~
nated as soon as possible.
Disposal
Comply with the relevant environmen~tal protection regulations when dispos~ ing of coolant and coolant additives.
Seite 212MOBILITYCoolant212
Online Edition for Part no. 01 40 2 972 313 - VI/16

MaintenanceVehicle
features
and
op

service center or repair shop. Records of regu~
lar maintenance and repair work should be re~
tained.
Socket
for
OBD
Onboard
Diagnosis
Safety
information NOTE
The socket for Onboard Diagnosis is an
intricate component intended to be used in
conjunction with specialized equipment to
check the vehicle

Replacing
componentsVehicle
features
and
op

Replace
rear
wiper
blade1.Fold up and hold the wiper arm firmly.2.Turn the wiper blade all the way back.3.Continue turning the wiper blade all the
way so that it pops out of the holder.4.Press the new wiper blade into the holder
until you hear it snap into place.5.Fold the wipers in.
Lamp
and
bulb
replace

NOTE
Dirty bulbs have a reduced service life.
There is a risk of property damage. Do not hold
new bulbs with your bare hands. Use a clean
cloth or something similar, or hold the bulb by
its base. '

LED
low
beams/LED
high
beamsFollow the general instructions on lights andbulbs, refer to page 216.
The lights feature LED technology. In the case
of a malfunction, contact a dealer

5.Pull the bulb out of the fixture.6.Insert the new bulb and install the cover in
the reverse order.
LED
parking
lights/LED
fog
lights
Follow the general instructions on lights and
bulbs, refer to page 216.
The lights feature LED technology. In the case of a malfunction, contact a dealer

Vehicle
with
two
rear
fog
lights1Side tail lamps2Rear fog lights3License plate lamp4Center brake lamp
Side
tail
lamps
1Brake lights/tail lamps2Turn signal3Reversing lights
Side
LED
tail
lights
1Tail lamps2Turn signal3Brake light4Reversing lights
Side
tail
lampsFollow the general instructions on lights and
bulbs, refer to page 216.
Bulbs: P21W
1.Open tailgate, refer to page 40.2.Remove left or right cover.3.Through the opening, loosen the plug con~
nector, arrow 2 on the bulb holder.
Press the latches together, arrows 1, and
remove the bulb holder.4.Remove the bulb holder from the opening.5.Press the nonworking bulb gently into the socket, turn counterclockwise and remove.'