MINI 5 door 2016 Owner's Manual

'

The wire is long enough to guide the socketdown and through between any heat shield
that may be installed and the bumper.4.Replace nonworking bulb.5.To install the new bulb, proceed in reverse
order of removal.
Right fog lamp:
1.Turn the bulb socket counterclockwise and
remove.
The wire is long enough to guide the socket down and through between any heat shield
that may be installed and the bumper.2.Replace nonworking bulb.3.To install the new bulb, proceed in reverse
order of removal.
Side
turn
signal,
bulb
replacement
Follow the general instructions on lights and
bulbs, refer to page 216.
Bulbs:
'

Vehicle
batteryMaintenance
The battery is maintenance-free.
The added amount of acid is sufficient for the
service life of the battery.
More information about the battery can be re~
quested from a dealer

Fuses
Safety
information WARNING
Incorrect and repaired fuses can overload
electrical lines and components. There is a risk of fire. Never attempt to repair a blown fuse.Do not replace a nonworking fuse with a sub~stitute of another color or amperage rating. '

Breakdown
assistanceVehicle
features
and
op

Safety
informationDANGER
Contact with live components can lead to
an electric shock. There is a risk of injuries or danger to life. Do not touch any components
that are under voltage. '

3.Let both engines run for several minutes.4.Disconnect the jumper cables in the reverseorder.
Check the battery and recharge if needed.
Tow-starting
and
towing
Safety
information WARNING
Due to system limits, individual functions
can malfunction during tow-starting/towing
with the Intelligent Safety systems activated,
e.g., approach control warning with light brak~
ing function. There is a risk of an accident. Switch all Intelligent Safety systems off prior to
tow-starting/towing. '

TowingNOTE
If manual unlocking of the parking brake
is not possible, the vehicle cannot be moved or
towed. There is a risk of property damage. The
vehicle should only be transported on a loading
platform. '

Tow
ropeWhen starting to tow the vehicle, make surethat the tow rope is taut.
To avoid jerking and the associated stresses on the vehicle components when towing, alwaysuse nylon ropes or nylon straps.
NOTE
If the tow bar or tow rope is attached in~
correctly, damage to other vehicle parts can oc~ cur. There is a risk of property damage. Cor~
rectly attach the tow bar or tow rope to the tow fitting. '

pedal. After the engine starts, immediately
press on the clutch pedal again.5.Stop at a suitable location, remove the tow bar or rope, and switch off the hazard
warning system.6.Have the vehicle checked.Seite 230MOBILITYBreakdown
assistance230
Online Edition for Part no. 01 40 2 972 313 - VI/16