MINI Clubman 2018 Owner's Manual

CoolantVehicle
features
and
op

Adding1.Let the engine cool.2.Turn the lid of the coolant reservoir slightly
counterclockwise to allow any excess pres~
sure to dissipate, then open it.3.If the coolant is low, slowly add coolant up
to the specified level; do not overfill.4.Close the cap.5.Have the cause of the coolant loss elimi~
nated as soon as possible.
Disposal
Comply with the relevant environmen~tal protection regulations when dispos~ ing of coolant and coolant additives.
Seite 242MOBILITYCoolant242
Online Edition for Part no. 01402983278 - X/17

MaintenanceVehicle
features
and
op

dealer

Replacing
componentsVehicle
features
and
op

Rear
wiper
blades1.Fold up and hold the wiper arm firmly.2.Turn the wiper blade all the way back.3.Push the wiper blade out of the fasteningby continuing to turn it all the way.4.Insert the new wiper blade by following the
steps in reverse order. The wiper blade
must engage audibly.5.Fold down the wiper arm.
Light
and
bulb
replace

If despite driving with the headlights switched
on, increasing humidity forms, for instance wa~
ter droplets in the light, have the headlights checked.
Headlight
setting
The headlight adjustments can be affected by
changing lights and bulbs. After the headlight
adjustment was changed, have it checked and, if necessary, corrected by a dealer

5.Remove the bulb from the headlight hous~ing.6.Insert the new bulb and install the cover in
the reverse order.
Turn
signal
Follow the general instructions on lights and
bulbs, refer to page 246.
Bulbs: PWY24W
1.Turn the steering wheel.2.Turn the lid counterclockwise, arrow 1, and remove.3.Unscrew the inner cover counterclockwise,and remove it.4.Pull bulb holder out of the bulb housing; ifneeded, loosen it with small tilting move~ments if possible.5.Pull the bulb out of the fixture.6.Insert the new bulb and install the cover in
the reverse order.
Parking
lights/fog
lights/daytime
running
lights
Follow the general instructions on lights andbulbs, refer to page 246.
Bulbs:
'

'

Bulbs: PWY24W1.Turn the steering wheel.2.Turn the lid counterclockwise, arrow 1, andremove.3.Unscrew the inner cover counterclockwise,and remove it.4.Pull bulb holder out of the bulb housing; ifneeded, loosen it with small tilting move~ments if possible.5.Pull the bulb out of the fixture.6.Insert the new bulb and install the cover in
the reverse order.Tail
lights,
bulb
replacement
Overview1Tail lights in split doors2Tail lights in bumpers3License plate light4Center brake light
Tail
lights
in
split
doors
1Turn signal2Tail lights3Rear fog light4Reversing lightsSeite 250MOBILITYReplacing
components250
Online Edition for Part no. 01402983278 - X/17