MINI Clubman 2018 Manual PDF

Forward/backward
Push switch forward or backward.
Height
Push switch up or down. Seat
tilt
Move switch up or down.
Backrest
tilt
Move switch forward or backward.
Lumbar
support
Concept
The curvature of the seat backrest can be ad~
justed in a way that it supports the lumbar re~ gion of the spine. The lower back and the spineare supported for upright posture.
Settings
'

Front
seat
heating
Overview
Seat heating
Switching
on Press button once for each tempera~
ture level.
The maximum temperature is reached when
three LEDs are lit.
If the trip is continued within approx. 15 mi~ nutes after a stop, seat heating is activated au~
tomatically with the temperature selected last.
When GREEN Mode is activated, refer to
page 203, the heater output is reduced.
Switching
off Press and hold the button, until theLEDs go out.
Safety
belts Number
of
safety
belts
and
safety
belt
buckles
The vehicle is fitted with five safety belts to en~
sure occupant safety. However, they can only offer protection when adjusted correctly.
The two outer safety belt buckles of the rear
seat are intended for the persons sitting on the left and right.
The center safety belt buckle of the rear seat isintended for the person sitting in the middle.
General
information Always make sure that safety belts are beingworn by all occupants before driving off. Al~though airbags enhance safety by providingadded protection, they are not a substitute forsafety belts.
The upper shoulder strap's anchorage point will be correct for adult seat occupants of every
build if the seat is correctly adjusted.
Safety
information WARNING
Use of a safety belt to buckle more than
one person will potentially defeat the ability of the safety belt to serve its protective func~
tion.There is a risk of injuries or danger to life. Do not allow more than one person to wear asingle safety belt. Infants and children are not
allowed on an occupant's lap, but must be transported and secured in designated child re~straint systems. '

WARNING
The efficacy of safety gear, including
safety belts, may not be fully functional or fail in
the following situations:'

'

'

Memory
function
Concept The following settings can be stored and, if
necessary, retrieved using the memory func~ tion:'

The current exterior mirror position can bestored using the memory function, refer topage 76.
Safety
information WARNING
Objects reflected in the mirror are closer
than they appear. The distance to the traffic
behind could be incorrectly estimated, for in~
stance while changing lanes. There is a risk of
an accident. Estimate the distance to the traffic
behind by looking over your shoulder. '

DeactivatingSlide the switch to the passenger's sidemirror position.
Interior
mirror,
manually
dimmable Flip
lever
To reduce the blinding effect of the interiormirror, flip the lever forward.
Turn
knob
Turn the knob to reduce the blinding effect by the interior mirror.
Interior
mirror,
automatic
dimming
feature
Overview
Photocells are used for control:
'

Settings1.Fold the lever down.2.Move the steering wheel to the preferred
height and angle to suit your seating posi~ tion.3.Fold the lever back up.Seite 79SettingsCONTROLS79
Online Edition for Part no. 01402983278 - X/17

Transporting
children
safelyVehicle
features
and
op