roof MITSUBISHI 3000GT 1994 2.G Workshop Manual

Downloaded from www.Manualslib.com manuals search engine 14GENERAL - Control Unit Location
CONTROL UNIT LOCATION
NameSymbol
ABS control unit
J
Active exhaust control module cup to 1994H
models>
Air conditioning compressor lock controller
C
Air conditioning control unitB
Name
Engine control module
ETACS control unit
Keyless entry control unit
Light automatic shut-off unit
Motor antenna control unit
SRS diagnosis unit
Sunroof control unitSymbol
d
B
A
F
19FO134
16FO26700004239
control module
TSB Revision

Downloaded from www.Manualslib.com manuals search engine GENERAL - Junction Block19
/
L
To roofwiring -harness
Front
/ITo frontwiring harness
- TO instrument panel
wiring harness
Theft-
alarm
horn
relay
L ,.c !!II {+J . ,i/11
\oi
Z16FO304
Back
To bodywiringharness
W-9
Z16FOO5800002704
/
id
TSB Revision

Downloaded from www.Manualslib.com manuals search engine L
DEDICATED FUSE
GENERAL - Centralized Junction21
Power supply circuitNo.Rated capacity
(A)Housing color
Circuit
Battery
,!. I/
120YellowMFI circuit
Tailliaht relavI2 1151 Blue1 Tailliaht circuitI
Fusible link (6)
Fusible link (3)
Headlight relay
Battery
310RedHorn circuit
415RedFog light circuit
510RedUpper beam circuit
610RedHazardlightcircuit
7*’10RedABS circuit
7*220Yellow
Sunroof circuit
Fusible link (6)
a20
910
Defogger relay10 10
NOTE*l: Vehicles produced up to Oct. 1993.
*2: Vehicles with sunroof
Yellow
Red
RedCondenser fan motor circuit
Air conditioning circuit
Remote controlled mirror heater circuit
L
<Relay box in engine compartment>1
216FO256
<Air conditioning relay box
in engine compartment><Interior relay box>
Up to 1993 models From 1994 models
Z16FOOO2Z16FOOO3Z16FO43100002705
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 24GENERAL - Harness Connector Inspection
ess connector
contact pressure
checking harness
201 R057
Z16R1317
HARNESS CONNECTOR INSPECTION
CONNECTOR CONTINUITY AND VOLTAGE TESTWhen checking continuity and/or voltage at the waterproof
connectors, follow the steps below to avoid poor connector
contact and/or reduced waterproof performance of connectors.
(1) When checking is performed with the circuit in the stateof continuity, be sure to use the special tool (harness
connector).
Never insert a test bar from the harness side, because
to do so will reduce the waterproof performance and result
in corrosion.
(2) When the connector
JS disconnected for checking the fe-
male pin, the harness for checking the contact pressureof connector pins should be used.
Never force the insertion of a test bar, because to do
so will cause poor contact.(3) When the male pin is to be checked, apply the test bar
against the pin directly.
Care must be taken not to short-circuit the connector pins.
TERMINAL ENGAGEMENT CHECK
When the terminal stopper of connector is out of order, engage-
ment of male and female terminals becomes improper even
when the connector itself is engaged perfectly and the terminal
sometimes slips out to the rear side of connector. Ascertain,
therefore, that each terminal does not come off the connector
by pulling each harness wire.
CONNECTOR TERMINAL ENGAGEMENT AND
DISENGAGEMENTConnectors which are loose shall be rectified by removing
the female terminal from connector housing and raising its
lance to establish a more secure engagement. Removal of
connector terminal used for MFI and 4 A/l control circuit shallbe done in the following manner.
COMPUTER CONNECTOR(1) Insert screwdriver
[1.4 mm (.06 in.) width] as shown in
the figure, disengage front holder and remove it.
1 TSB Revision
IJ
I
I
I

Downloaded from www.Manualslib.com manuals search engine GENERAL - Harness Connector Inspection25 ~
Z16R1320
(2)Insert harness of terminal to be rectified deep into connec-tor from harness side and hold it there.
Housing lance/
’ Needle
’ Housing lance
Z16R132
(3)Insert tip of screwdriver [1.4 mm (.06 in.) width] into connec-tor in a manner as shown in the figure, raise housing
lance slightly with it and pull out harness.
CautionTool No. 753787-l supplied by AMP can be used
instead of screwdriver.(4)
insert needle through a hole provided on terminal and
raise contact point of male terminal.
ROUND WATERPROOF CONNECTOR
(1) Remove waterproof cap by using a screwdriver.
(2) Insert tip of screwdriver
[I.4 mm (.06 in.) or 2.0 mm (.08in.) width] into connector in a manner as shown in the
figure, raise housing lance slightly with it and pull out
harness.(3) Insert screwdriver through a hole provided on terminal
and raise contact point of male terminal.
1 TSB Revision

Downloaded from www.Manualslib.com manuals search engine 26GENERAL - Harness Connector Inspection
Front holder
\\Z16R1325]
Housing lance7,fiEL,
c
Terminal lance00000400\
RECTANGULAR WATERPROOF CONNECTOR
(1)Disengage front holder by using a screwdriver and remove
it.
(2) Inset-t tip of screwdriver [*0.8 mm (.03 in.) width] into con-
nector in a manner as shown in the figure, push it lightly
to raise housing lance and pull out harness.
*If right size screwdriver is not available, convert a conven-
tional driver to suit the size.
(3) Press contact point of male terminal down by holding a
screwdriver [1.4 mm (.06 in.) width] in a manner as shown
in the figure.
INJECTOR CONNECTOR
(1) Remove waterproof cap.
(2)Insert tip of screwdriver [1.4 mm (.06 in.) width] into connec-
tor in a manner as shown in the figure, press in terminal
lance and pull out harness.
(3) Press contact point of male terminal down by holding a
screwdriver [1.4 mm (.06 in.) width] in a manner as shown
in the figure.
CautionMake sure that lance is in proper condition before
terminal is inserted into connector.
1 TSB Revision

Downloaded from www.Manualslib.com manuals search engine 36CONFIGURATION DIAGRAMS - Overall Configuration Diagram
OVERALL CONFIGURATION DIAGRAM
<HAT1
Roof wiring
CHBACK>Instrument panel
wiring harness
- ,;
/Front wiring“l,
Door wiring*harness
harness
.-----y ,,\.Body wiring
harness (LH)Y36FOO19
<CONVERTIBLE>
Body wiring
harness (RH)Roof wiring
Instrument panel
wiring harness
Control wiring/harness
Door wiring*
harness
/Z36FO124Front wiring‘x\..e----qT .\, ’ Body\Niring00002733
harness‘-*harness (LH)
NOTE
(1)This illustration shows only the major wiring harness.
(2)* indicates also equipped at the right side.
TSB Revision

Downloaded from www.Manualslib.com manuals search engine CONFIGURATION DIAGRAMS - Dash Panel53
c-86*3C-87*3c-88’3
-J-----1)!_1/t’ \.- -b!w
C-89*3
i
c-71
C-72c-73
c-74
C-76c-77
C-78c-79
C-80C-81
C-82Adapter wiring harness and junction block
combination
Theft-alarm horn relay
Blower motor relayRoof wiring harness and junction block
combinationBody wiring harness (LH) and junction block
combinationBody wiring harness (LH) and junction block
combinationBody wiring harness (LH) and junction block
combinationData link
connector*3Body wiring harness (LH) and junction block
combinationBody wiring harness (LH) and junction block
combinationBody wiring harness (LH) and junction block
combination
36FO17900004256
C-83
C-84
C-85
C-86
C-87
C-88
C-89c-90
c-91
c-92
c-93
c-94
c-95Body wiring harness (LH) and junction block
combination
Auto-cruise relay
Spare connector (Hand free microphone)
Passenger’s air bag
module*3
No connection <Turbo>
Control wiring harness and front wiring harness
combination*3Body wiring harness (LH) and body wiring
harness (RH) combination*3
Engine control module*3
<Turbo, Non Turbo - Up to 1995 models
for California>
Data link connector <Convertible>*4y*5
Engine control module*5MFI
relay*5
Body wiring harness (RH) and front wiring
harness combination*5
Motor antenna control unit*5
TSB Revision

Downloaded from www.Manualslib.com manuals search engine CONFIGURATION DIAGRAMS - InteriorE-45 E-46 E-47
E-48E-4g
E-28
E-29
E-30
E-31
E-32
E-33
E-34
E-35
E-37
E-38
E-39
E-40
\
’ E-18
E-19ECS G sensor
Door speaker
Turn signal and hazard flasher unit
Diode (for MFI circuit)
Body wiring harness (LH) and door wiring
harness (LH) combination
Door mirror (LH)
Power window main switch
Power window motor (LH)
Keyless control Unit”’Door lock power relay 2*’
(for keyless control system)
Amplifier*2
Body wiring harness (LH) and door wiring
harness (LH) combination <Convertible>A36F0180
E-41
E-42
E-43
E-44
E-45
E-46
E-47
E-48
E-49
E-50
E-51
Jumper connector A (LH) <Convertible>
Jumper connector B <Convertible>Body wiring harness (RH) and door wiring
harness (RH) combination <Convertible>
Jumper connector A (RH) <Convertible>
Sunroof control unit
Liftgate wiring harness and sunroof
wiring harness combination <Hatchback>
Sunroof switch
Sunroof motor
Interior temperature sensor
<Vehicles with sunroof>
Rear courtesy light (LH)
cConvertible>*4Rear courtesy light (RH)
cConvertible>*4
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 61
i
CIRCUIT
DlAG.RAMS
CONTENTSActive Aero Circuit.........................
428Active Exhaust System Circuit..............
370
Anti-lock Braking System (ABS) Circuit......322
Auto-cruise Control Circuit..................380
Back-up Light...........................54-85
Buzzer Circuit.............................208
Car Telephone Circuit......................435
Central Door Locking Circuit................222
Charging System..........................16-3
Cigarette Lighter Circuit.................54-120
Cooling Circuit.............................176
Defogger Circuit........................54-193Dome Light, Foot Light and Ignition Key
Cylinder Illumination Light................54-72
Door Light and Luggage Compartment
Light...................................54-81
ELC-4 A/T Circuit..........................186
Electronic Control Suspension (ECS) Circuit . . 352
Fog Light Circuit.........................
54-58
Full Auto Air Conditioning’ Circuit............272Glove Box Light, Vanity Mirror
Light and Inspection Light Circuit..........
54-84
Headlight...............................
54-40
Heater Circuit.............................,239
Horn..................................54-116
How to Read Circuit Diagrams..............
62
Ignition System.........................16-32
Manual Air Conditioning Circuit.............242
Meter and Gauges Circuit...............54-12
MFI Circuit................................84
Power Distribution Circuit...................68
Power Seat Circuit....:...................416
Power Window Circuit.....................212
Radio and Tape Player................54-124
Rear. Wiper and Washer Circuit............318
Remote Controlled Mirror Circuit...........320
Starting System.........................16-20
Stop Light.............................54-98
Sunroof Circuit.............................442
Supplemental Restraint System (SRS)
Circuit....................................374
Taillight, Parking/Side Marker Light and
License Plate Light Circuit................54-64
Tension-reducer Type Seat Belt Circuit......423
Theft-alarm System....................54-206
Top Stack Circuit.........................438
Turn-signal Light and Hazard Light.......54-90
Windshield Wiper and Washer Circuit........316
I
LiI