stop start MITSUBISHI ENDEAVOR 2010 1.G MMCS Manual

Error in the Current Location 1-9
Introduction
 When starting and stopping frequently at low
speed, such as in a traf c jam When driving on snowy or unpaved roads When driving on roads parallel to others
 When driving on grid-shaped roads When driving on a road that turns around in the
same direction, such as a loop-shaped bridge
or interchange When driving on roads where map data is not
available
 When GPS measurements could not be made
for an extended distance.

Trip 2-11
Operation of MMCS
Lap Time
Time, distance, speed and mileage
can be measured.
1 Display the 3/3 Trip screen
2 Touch [Start]
eng_492

Total Line
eng_545
The measurement starts. At this time, the speed
and mileage are being measured, so they are not
displayed.
3 Touch [Lap]

eng_546
The current measurement results are displayed in
“A”.NOTE Touch [Lap]
again and the
measurement
results displayed
in "A” are moved
to “B”.

eng_547
4 Touch [Stop]

eng_548
The measurements stop and the measurement
results are displayed in the total line.
NOTE Touch [Start] to restart the measurements from
where they stopped.
 The measurements stop if the ignition switch
is turned “OFF” during measurement. If this
happens, the measurements restart when the
ignition switch is turned “ON”. 5 Touch [Reset]

eng_549
All the measurement results are reset.

View Route 5-2
Preview Route
The map can be scrolled along the
route. The type of route taken to the
destination can be viewed.
1 Touch [Preview] in the view
route screen
(5-1)
The preview screen is displayed. 2 Touch [Backward], [Stop] or
[Forward]
eng_062
NOTE Touch [Backward] to scroll towards the starting
position.
 Touch [Stop] to stop the scrolling.
 Touch [Forward] to scroll towards the
destination.
Remaining Route
Displaying a map of the entire
remaining route, in a scale where it
can all be displayed.
1 Touch [Remaining] in the view
route screen
(5-1)

eng_063
Displays a map of the entire remaining route, in a
scale where it can all be displayed.
Route Outline
A list of the intersections up to the
destination where turns are required is
displayed.
1 Touch [Rt. Outline] in the view
route screen
(5-1)

eng_064
A list of the intersections where turns are required
is displayed.NOTE Touch an inter-section on the list
to display a map of its vicinity.
eng_065

Information 8-2
POI by Freeway
Searching for POI along a freeway or
in the vicinity of the exit.
Can only be used when driving on a
freeway.
1 Touch [POI by FWY]
The FWY area list screen is displayed.
The remaining operations are the same as
“POI
by Freeway” (4-11)
.
Support Information
System information for this navigation
system can be viewed.
1 Touch [Support Information]

eng_163
The support information screen is displayed.
SW Version The software version of the
system is displayed.
MAP VersionThe map data version is
displayed.
SW Area The area supported by the
software is displayed.
Map Coverage The area supported by the
map disc is displayed.
Start Demo.
The set route can be viewed with a
demo.
1 Touch [Start Demo.]

eng_164
The demo is started.Stop DemoStopping the demo that is operating. 1 Display the information screen
during the demo
2 Touch [Stop Demo.]
eng_165

The demo is stopped.