check engine MITSUBISHI FTO 2003 1.G Owners Handbook

Downloaded from www.Manualslib.com manuals search engine Owners Handbook
Copyright © Tarkus Services (2003)
www.angelfire.com/emo/ftoAll rights reserved
26-Aug-049
Vehicle Introduction and Safety
Please read this section.
Even if you do not read the entire manual, this section should be studied before
operating the vehicle.
Warning notes
Check exterior of vehicle before driving.
Do not carry flammable liquids or gas
bottles in the vehicle, as this may cause a
fire or explosion in the event of an
accident.
Make sure seat belt is adjusted and
fastened for all passengers as well as the
driver, before driving. For more
information on the seat belts, see later in
this manual.
Do not run the engine in a confined area,
as this will cause a build up of carbon
monoxide, which is dangerous. Make
sure that there is adequate ventilation if
you do need to run the engine in a
confined space.

Downloaded from www.Manualslib.com manuals search engine Owners Handbook
Copyright © Tarkus Services (2003)
www.angelfire.com/emo/ftoAll rights reserved
26-Aug-0410
Make that there is nothing loose that can
interfere with the controls of the vehicle,
such as cans or bottles.
Make sure that any mats or covers do not
interfere with the controls of the vehicle.
Page 6 ?2000cc ? “check translation”.
Do not try to turn the ignition switch off,
while driving. This may cause serious
damage to the engine. If you turn the key
to “ACC” or “LOCK” position while
driving you will lose the use of the power
brakes and power steering, also the
steering lock will engage. Also no
warning lights will be illuminated.
Do not put the seats in the reclined
position, while the vehicle is moving.
When reversing, make sure that the rear
of the vehicle is clear of obstructions and
children.

Downloaded from www.Manualslib.com manuals search engine Owners Handbook
Copyright © Tarkus Services (2003)
www.angelfire.com/emo/ftoAll rights reserved
26-Aug-0429
Instrument panel
Instrument overview
1. Volt-meter.
2. Rev counter.
3. Fuel level.
4. Speedometer.
5. Odometer / trip button.
6. Odometer.
7. Trip meter.
8. Engine temperature.
Volt-meter
The voltmeter should have a reading of
about 13 volts in normal running. If the
reading is below 12 volts, have the
system checked by an auto electrician.

Downloaded from www.Manualslib.com manuals search engine Owners Handbook
Copyright © Tarkus Services (2003)
www.angelfire.com/emo/ftoAll rights reserved
26-Aug-0432
Turn signal indicator. – when the indicator lever is operated
for a left or right turn, the appropriate light will be illuminated, it
will flash along with the outside lights. Pushing the hazard-warning
switch will cause both the turn indicators on the instrument panel
and all the outside lights to flash.
High beam indicator light. – This will be illuminated when
the main lights are switched to high beam.
Exhaust warning light. – If this comes on then the exhaust is
overheating. Stop the car as soon as possible, make sure there is
nothing flammable (grass, paper etc) under the vehicle. Wait approx
15 minutes before restarting, if the light has gone out continue on
your journey. If the light comes back on stop the vehicle again and
wait longer, also have the exhaust checked.
Oil pressure warning light. – This will normally come, on
when the ignition is turned on, but should go out after a few seconds.
Battery warning light. – This will normally come, on when the
ignition is turned on, but should go out after a few seconds. If it
stays on or comes on whilst you are driving, stop the car and have it
checked by an auto electrician.
Engine system. – if this comes on, it indicates a problem with the
engine or electrical system, have the engine / electric’s checked.
Washer reservoir tank warning light. – This will come on
when the water level in the washer bottle is low.
Door open warning light. – This will come on when a door is
open or not closed properly.
Brake / hand brake warning light. – This has 3 functions:-
1. Will be illuminated when the handbrake is on.
2. When the brake fluid is low.
3. When the brake pads need replacing.
Seat belt reminder light. – This will be illuminated until the
driver puts their seat belt on.
Low fuel warning light. – This will come on when the fuel
level is down to about 8 litres.