light MITSUBISHI GALANT 2005 Service Repair Manual

ON
ACC
LOCK (OFF)
Key removed
ON (Any door is open)
OFF (All doors are closed)
LOCK
OFF
UNLOCK
100
65
0
t1: 30 seconds
t2: 15 secondst1 t1 t2 Ignition switch
Door switch
Keyless entry system
door lock or unlock signal
Interior light intensity
<<PREVIOUS

T1 T2 T2 ON
ON (Any door is open)
IlluminatedACC
OFF
Extinguished Ignition switch
Door switch
Interior lightON
DOOR Dome light switch
T1: 30 minutes
T2: Within 30 minutesT1 T2 OFF (All doors are closed)
T1

ON
OFF
ON (UNFASTENED)
OFF (FASTENED)
ON (ILLUMINATED)
OFF (NOT ILLUMINATED) IGNITION SWITCH (IG1)
SEAT BELT
SWITCH
(DRIVER&#39;S SIDE)
SEAT BELT
WARNING
LIGHT
ON
OFF
ON (UNFASTENED)
OFF (FASTENED)
ON (ILLUMINATED)
OFF (NOT ILLUMINATED) IGNITION SWITCH (IG1)
SEAT BELT
SWITCH
(DRIVER&#39;S SIDE)
SEAT BELT
WA R N I N G
LIGHT8 km/h (5 mph)
0 km/h (0 mph) VEHICLE SPEED
e 3 km/h (2 mph)
ON
OFF
a: 0.48 SECOND
b: 0.52 SECONDc: 1 SECOND
d: 3 SECONDSe: 60 SECONDS OR MORE
f: 10 SECONDS
agggf
b
cc ccc d12 CYCLES
1 CYCLE12 CYCLES 12 CYCLES 12 CYCLES
SEAT BELT
WA R N I N G
LIGHT
g: 0.5 SECOND

CONTROL WIRING
HARNESSINJECTOR WIRING
HARNESS
<3.8L ENGINE>INSTRUMENT PANEL
WIRING HARNESSREAR DOME LIGHT
WIRING HARNESSROOF WIRING
HARNESS
FRONT WIRING
HARNESSFLOOR WIRING
HARNESSREAR DOOR
WIRING HARNESS
*
FRONT DOOR
WIRING HARNESS*

Denotes connector No.
The same connector No. is used throughout the circuit diagrams to facilitate connector location searches.
The first alphabetical symbol indicates the location site of the connector and a number that follows is the unique number.
Numbers are usually assigned to parts in clockwise order on the diagram.
Example: A-19
Number specific to connector (serial number)
Connector location site symbol
A: ENGINE COMPARTMENT D: FLOOR AND ROOF
B: ENGINE AND TRANSAXLE E: DOOR
C: DASH PANEL F: LUGGAGE COMPARTMENT
Denotes ground point.
Same ground number is used throughout circuit
diagrams to facilitate search of ground point.
Refer to GROUP 70 COMPONENT LOCATIONS
-GROUND MOUNTING LOCATIONS for details
of ground points.
Denotes the color of the tube
(If not specified, it is black).
R: Red
Y: Yellow
The number of connector pins and the connector color
(except milk white)* are shown for ease of retrieval.
Example: (2-B)
Connector color
(milk white if no color is indicated)
Number of connector pins
*: Typical connector colors
B: Black BR: Brown
Y: Yellow V: Violet
L: Blue O: Orange
G: Green GR: Gray
R: Red NONE: Milk white
A-15 (2) FOG LIGHT (RH)
A-16 (2-GR) HORN (LOW)
A-17 (2-B) HEADLIGHT (RH)
A-18 (2-B) WINDSHIELD WASHER MOTOR
A-19 (2-GR) DUAL PRESSURE SWITCH
Indicates the device to which the
connector is connected.
The mark shows the
standard mounting position
of wiring harness.
A-17
A-16
A-15 A-18 A-19
Y
Denotes a section covered by a
corrugated tube.
FRONT
WIRING
HARNESS
(RH) Denotes harness name.

CONNECTOR COLOR
CODE
B: BLACK
BR: BROWN
G: GREEN
GR: GRAY
L: BLUE
NONE: MILK WHITE
O: ORANGE
R: RED
V: VIOLET
Y: YELLOW
Connector
symbol
FLOOR
WIRING
HARNESSREAR DOME
LIGHT WIRING
HARNESS
Y
D-01D-02
D-03D-04 D-05 D-06
D-24 D-25 D-26 D-27 D-28 D-29 D-30 D-31 D-32 D-33 D-34 D-35 D-36 D-37
ROOF
WIRING
HARNESS

BatteryBuzzerCapacitorElectrolytic
capacitorVa r i a b l e
capacitorCoil
DiodeLight emitting
diodePhoto diodeZener diodeDual filament bulbSingle filament
bulb
Fus eFusible linkHornMotorPulse generatorPiezoelectric
device
ResistorVariable resistorSpeakerThermistorTransistorPhoto transistor
<F> 1.25 G B
1234
Example: