MITSUBISHI L200 2020 (in English) Service Manual

Unlocking the doors
When you are carrying the keyless operation
key, if you press the driver’s or front pas- senger’s door lock/unlock switch (A), within
the operating range, all the doors are un-
locked.
If the room lamp switch is in the middle (

NOTEzOnly use the emergency key for emergen-
cies. If the keyless operation key battery
wears out, replace it as quickly as possible so that you can use the keyless operation
key.
z The emergency key is built in the keyless
operation key.
z After using the emergency key, always re-
turn it into the original position.
Locking and unlocking the door
Turning the emergency key in the forward di-
rection locks the door, and turning it in the rear direction unlocks the door. Also refer to
“Locking and unlocking: Doors” on page 3-15.
1- Lock
2- Unlock
Operation of the Dead Lock
System
For vehicles equipped with the Dead Lock System, it is possible to set the Dead Lock
System using the driver’s or front passenger’s door lock/unlock switch.
(Refer to “Dead Lock System*” on page 3-18.)Keyless operation system*
3-122.7(20(1Locking and unlocking3

Warning activation
In order to prevent vehicle theft or the accidental operation of the keyless operation system, the buzzer and the display on the information screen
in the multi information display are used to alert the driver.
If a warning is activated, always check the vehicle and the keyless operation key. The warning is also displayed if there is a fault in the keyless operation system.
ItemDisplayBuzzerNote (Solution)Detection of failureInner buzzer sounds onceThere is a fault in the keyless operation system.Fall of battery voltageInner buzzer sounds onceThe battery starts to run out, the warning is activated. (The warning is
not activated if the battery is completely dead.)Key not detectedInner buzzer sounds onceWhen the engine switch is turned to the ACC or ON from OFF or when
the engine is started, the warning is activated, if any of the following conditions is occurred.
z Carrying another keyless operation key with a different code, or the
keyless operation key could be outside the operating range.
z The battery of the keyless operation key is dead.
z Communication is blocked by electric wave environment.Keyless operation key
reminderInner buzzer sounds approxi-
mately 1 minute
Outer buzzer sounds approxi- mately 3 seconds intermit- tentlyIf the operation mode is in OFF and the driver’s door is opened with the
keyless operation key in the key slot, a warning is issued and the outer buzzer sounds for approximately 3 seconds and the inner buzzer sounds for approximately 1 minute to remind you to remove the key. If the key
removed from key slot, the buzzer is stopped.
Keyless operation system*
3-132.7(20(1Locking and unlocking3

ItemDisplayBuzzerNote (Solution)Keyless operation key
takeout monitoring systemInner buzzer sounds once
Outer buzzer sounds intermit-
tentlyz When the vehicle is parked with the operation mode in any mode
other than OFF, if you close the door after opening any of the doors
and taking the keyless operation key out of the vehicle, a warning is
issued until the key is detected in the vehicle.
z If you take the keyless operation key out of the vehicle through a
window without opening a door, the keyless operation key take-out monitoring system does not operate.
z It is possible to change the setting to make the keyless operation key
take-out monitoring system operate if you take the keyless operation
key out from the vehicle through a window without opening a door. For further information, please contact a MITSUBISHI MOTORS
Authorized Service Point.
z Even if you have the keyless operation key within the engine start
operating range, if the keyless operation key and vehicle ID codes
cannot be matched, for example due to the ambient environment or
electromagnetic conditions, the warning may be activated.Key lock-in preven-
tion systemInner buzzer sounds once
Outer buzzer sounds approxi- mately 3 seconds intermit- tentlyz When the operation mode is in OFF, if you close all the doors with
the keyless operation key left in the vehicle and you try to lock the
doors by pressing the driver’s or front passenger’s door lock/unlock
switch, a warning is issued and you cannot lock the doors.
z Make sure you have the keyless operation key with you before lock-
ing the doors. Even if you leave the keyless operation key inside the
vehicle, it is possible that the doors will lock depending on the sur- rounding environment and wireless signal conditions.Door ajar prevention
systemInner buzzer sounds once
Outer buzzer sounds approxi- mately 3 seconds intermit- tentlyWhen the operation mode in OFF, if you try to lock the doors by pressing
the driver’s or front passenger’s door lock/unlock switch, with one of the doors not completely closed, a warning is issued and you cannot lock the
doors.
Keyless operation system*
3-142.7(20(1Locking and unlocking3

ItemDisplayBuzzerNote (Solution)Operation mode OFFreminder systemInner buzzer sounds once
Outer buzzer sounds approxi- mately 3 seconds intermit- tentlyWhen the operation mode is in any mode other than OFF, if you try to
lock the doors by pressing the driver’s or front passenger’s door lock/
unlock switch, a warning is issued and you cannot lock the doors.

DoorsCAUT,ONz Make sure the doors are closed: driving with
doors not completely closed is dangerous.
z Never leave children in the vehicle unatten-
ded.
z Be careful not to lock the doors while the
key is inside the vehicle.NOTEz To prevent the key from being locked inside
the vehicle, neither the lock knob on the driver’s door nor the key can be used to lock
the driver’s door when it is open.To lock or unlock with the key
1- Lock
2- Unlock
NOTEz On vehicles with central door locks, when
locking or unlocking with the key, all doors
will be locked or unlocked.
Refer to “Central door locks” on page 3-17.NOTEz If the vehicle is equipped with the keyless
operation system, the driver’s door can be locked or unlocked with the emergency key.
Refer to “Emergency key” on page 3-11.
To lock or unlock from inside
the vehicle
1- Lock
2- Unlock
Doors
3-152.7(20(1Locking and unlocking3

NOTEzThe driver’s door can be opened without us-
ing the lock knob by pulling on the inside
door handle.
On vehicles with central door locks, all other doors are unlocked at the same time.
z In a vehicle that has a Dead Lock System, it
is not possible to unlock the door by pushing the lock knob to the unlock side while the Dead Lock System is set.
(Refer to “Dead Lock System*” on page
3-18.)
To lock without using the key
Set the inside lock knob (1) to the locked po-
sition, and close the door (2).
NOTEz The driver’s door cannot be locked using the
inside lock knob while the driver’s door is
opened.To open or close the rear door
(Club cab)
You can open or close the rear door while the
front door is opened. 1. Open the front door wide.
2. Pull the door handle (A) of the rear door.
3. Open the rear door.
4. When closing these doors, close the
front door after closing the rear door.
:ARN,NGz When opening the rear door, confirm that
the occupant of the front seat has taken off the seat belt before opening the rear
door.
If you open the rear door with the front
seat belt being worn, the occupant of the
front seat may be tightened with the locked seat belt and could result in serious
injury.
z When closing the rear door, make sure
not being trapped your hands or your fin-gers in the doors.
z Before driving, make sure that the rear
door is securely closed.
If a door is ajar, the door ajar warning
lamp will illuminates. If a door is not completely closed, the rear door couldopen while driving and this could cause
an accident such as occupants being thrown from the vehicle.CAUT,ONz When opening or closing the rear door,
please observe the followings. If you do not
follow them, it could result in damage to your vehicle.

Central door locksNOTEzRepeated continuous operation between lock
and unlock could activate the central door
locking systems built-in protection circuit
and prevent the system from operating. If
this occurs, wait approximately 1 minute be- fore operating the central door lock system.
All of the doors can be locked and unlocked
as described hereafter.
Driver

NOTEzEven if the vehicle suffers significant defor-
mation from a collision etc., depending on the location and angle of the collision, as
well as on the shape and condition of the
other object in the collision, the doors may
not unlock. The extent of deformation or damage to the vehicle does not necessarily correlate with unlocking of the doors.
z These functions are activated when the vehi-
cle is shipped from the factory. If you wish to activate or deactivate these functions,please contact a MITSUBISHI MOTORS
Authorized Service Point.
Unlocking by using the ignition
switch, the engine switch or theselector lever
It is possible to unlock all of the doors when- ever as follows.
[Vehicles with M/T@
The ignition switch is turned to the “LOCK”
position or the operation mode is put in OFF.
[Vehicles with A/T@
The selector lever is placed in the “P” (PARK) position while the operation mode is
in ON. Or the operation mode is put in OFF.

These functions are deactivated when the ve-
hicle is shipped from the factory. If you wishto activate or deactivate these functions,
please contact a MITSUBISHI MOTORS
Authorized Service Point.Dead Lock System*
The Dead Lock System helps prevent theft.
When the keyless entry system or the keyless operation function has been used to lock all
of the doors, the Dead Lock System makes it
impossible to unlock the doors using the in- side lock knobs.
CAUT,ONz Do not set the Dead Lock System when
someone is inside the vehicle. With the Dead
Lock System set, it is not possible to unlock the doors using the inside lock knobs. If you
erroneously set the Dead Lock System, un-
lock the doors using the UNLOCK switch on the key or using the keyless operation
function.Setting the system
1. Turn the ignition switch to the “LOCK”
position and then remove the key (vehi-
cles with keyless entry system), or put the operation mode in OFF (vehicles
with keyless operation system).
2. Get out of the vehicle. Close all of the
doors.
3. Press the LOCK switch (A) on the key,
the driver’s or front passenger’s door
lock/unlock switch (C) to lock all of the doors. The turn-signal lamps will blink
once.
4. Press the switch again within 2 seconds.
The turn-signal lamps will blink three
times to show that the Dead Lock Sys- tem has been set.
Dead Lock System*
3-182.7(20(1Locking and unlocking3 Keyless entry system Keyless operation system

NOTEzPressing the LOCK switch (A) on the key
once while the Dead Lock System is set cau-ses the turn-signal lamps to blink three
times, so it is possible to confirm that the Dead Lock System is set.Cancelling the system
When the following operation is performed,
the doors will unlock and the Dead Lock Sys- tem will be simultaneously cancelled.
z The UNLOCK switch (B) on the key is
pressed.
z The driver’s or front passenger’s door
lock/unlock switch (C) is pressed while
you are carrying the keyless operation key.
NOTEz If a door is not opened within 30 seconds of
unlocking, the doors are automatically re-
locked and the Dead Lock System is simul-
taneously set again.
z Even when it is not possible to use the key-
less entry system or keyless operation func- tion to unlock the doors, it is possible to use
the key to unlock the driver’s door. When
the key is used to unlock the driver’s door, the Dead Lock System is cancelled for onlythe driver’s door. If you wish to subsequent-
ly unlock all other doors, turn the ignition switch to the “ON” or “ACC” position, or
put the operation mode in ON or ACC.
z It is possible to adjust the time between
pressing the UNLOCK switch (B) on the key or the driver’s or front passenger’s door
lock/unlock switch (C) and automatic lock-
ing. For details, please contact a MITSUBISHI MOTORS Authorized Serv-
ice Point.
z It is possible to lock the doors and set the
Dead Lock System at the same time with a
single push of the LOCK switch (A) on the
key, the driver’s or front passenger’s door lock/unlock switch (C). For details, please
contact a MITSUBISHI MOTORS Author-
ized Service Point.Testing the system
Open all of the door windows, then set the
Dead Lock System.
(Refer to “Setting the system” on page 3-18.)
After setting the Dead Lock System, reach
into the vehicle through a window and con-
firm that you cannot unlock the doors using the lock knobs.NOTEz If you need advice on how to set the Dead
Lock System, please contact a MITSUBISHIMOTORS Authorized Service Point.“Child-protection” rear
doors (Double cab)
1- Lock
2- Unlock
Child protection helps prevent doors from be-
ing opened accidentally, especially when small children are in the rear seat.
A lever is provided on each rear door.
“Child-protection” rear doors (Double cab)
3-192.7(20(1Locking and unlocking3

If the lever is set to the locked position, therear door cannot be opened using the inside
handle.
To open the rear door while the child protec- tion is in use, pull the outside door handle.
If the lever is set to the “Unlock” position,
the child protection mechanism does not function.CAUT,ONz When driving with a child in the rear seat,
please use the child protection to prevent ac-
cidental door opening which may cause an accident.Rear gateCAUT,ONz Do not stand behind the exhaust pipe when
loading and unloading luggage. Heat fromthe exhaust could lead to burns.
z Pay attention not to catch your fingers in the
rear gate.
z Do not weight the rear gate.
z Before driving, make sure that the rear gate
is securely closed. If the rear gate opens
while driving the vehicle, objects stored in
the cargo area could fall out onto the road.To open
Lift up the handle and lower the rear gate.
To close
Raise the rear gate and close with enough
force to latch the assembly securely into posi-
tion.
To swing down
The rear gate can be swung down in two
stages except some models. To lower it to the
second stage, proceed as follows:
CAUT,ONz On vehicles with the rear bumper, never
swing down the rear gate because the rear
gate could be damaged.
1. Swing open the rear gate to the first po-
sition. Then, lift it up to the position shown in the illustration while holding
the wire (A).
Rear gate
3-202.7(20(1Locking and unlocking3