MITSUBISHI L200 2020 (in English) Workshop Manual

2.Remove the wire (A) on one side while
aligning the hole in the wire with the hook (B).
3. Remove the wire on the other side in the
same manner, and have the rear gate
swing down slowly.
CAUT,ONz Never close the rear gate with the wire left
unhooked.Manual window control*
1- To open
2- To close
Electric window control*
The electric windows can only be operated with the ignition switch or the operation
mode in ON.
Electric window control switch
Each door window opens or closes while the
corresponding switch is operated.
1- Driver’s door window
2- Front passenger’s door window
3- Rear left door window (Double cab)
4- Rear right door window (Double cab)
5- Lock switch
:ARN,NGz Before operating the electric window con-
trol, make sure that nothing can get trap-ped (head, hand, finger, etc.).
z Never leave the vehicle without removing
the key.
z Never leave a child (or other person who
might not be capable of safe operation of the electric window control) in the vehicle alone.
Manual window control*
3-212.7(20(1Locking and unlocking3 Driver’s switch
LHDDriver’s switch
RHD

:ARN,NGzThe child may tamper with the switch at
the risk of its hands or head being trap-
ped in the window.
Driver

Safety mechanism (driver

2.7(20(1

Seat adjustment................................................................................... 4-02Front seats........................................................................................... 4-02
Rear seat (Club cab and Double cab)*................................................ 4-04
Head restraints*...................................................................................4-05
Seat belts............................................................................................. 4-07 Pregnant women restraint....................................................................4-10
Seat belt pretensioner system and force limiter system*.................... 4-10
Child restraint...................................................................................... 4-11 Seat belt inspection............................................................................. 4-23Supplemental restraint system (SRS)-airbag...................................... 4-246eatandseatbelts
2.7(20(14

Seat adjustment
Adjust the driver’s seat so that you are com- fortable and that you can reach the pedals,
steering wheel, switches etc. while retaining a clear field of vision.:ARN,NGz Do not attempt to adjust the seat while
driving. This can cause loss of vehicle con- trol and result in an accident. After ad-
justments are made, ensure the seating is
locked in position by attempting to move
the seat forward and rearward without using the adjusting mechanism.
z It is extremely dangerous to ride in the
cargo area (inside or outside) of a vehicle. Also, the cargo area and rear seats shouldnever be used as a play area by children.
In a collision, people or children riding unrestrained in these areas are more like- ly to be seriously injured or killed.
z Do not allow people or children to ride in
any area of your vehicle that is not equip- ped with seats and seat belts, and make
sure that everyone travelling in your vehi- cle is in a seat and wearing a seat belt, or
in the case of a child is strapped in a child restraint.:ARN,NGz To minimize the risk of personal injury in
the event of a collision or sudden braking,the seatbacks should always be in the al- most upright position while the vehicle is
in motion. The protection provided by the seat belts may be reduced significantly when the seatback is reclined. There is
greater risk that the passenger will slide
under the seat belt, resulting in serious in- jury, when the seatback is reclined.
z Do not place objects under the seats. This
could prevent the seat from locking se- curely, and it could lead to an accident. It
may also cause damage to the seat or oth-
er parts.CAUT,ONz Make sure the seat is adjusted by an adult or
with adult supervision for correct and safe operation.
z Do not place a cushion or the like between
your back and the seatback while driving.The effectiveness of the head restraints will
be reduced in the event of an accident.
z The reclining mechanism of the front man-
ual seat’s seatback is spring loaded, causing it to fold the seatback forward when the lock lever is operated. When using the lever, sit
close to the seatback or hold it with your hand to control its return motion.
z When sliding the seats, be careful not to
catch your hand or foot.CAUT,ONz When sliding or reclining the seat rearward,
pay careful attention to the rear seat passen-
gers.Front seats
Manual type
1- To adjust forward or backward
Lift the handle and adjust the seat to the
desired position, and release the handle.
2- To recline the seatback Pull the lever up and then lean backwardto the desired position, and release the lever.
3- To adjust seat cushion height (driver’s
side only)
Turn the dial and adjust the seat cushion
height to the desired position.
Seat adjustment
4-022.7(20(1Seat and seat belts4

Power type*
1- To adjust forward or backwardOperate the switch as indicated by thearrows and adjust the seat to the desired
position.
2- To recline the seatback Operate the switch as indicated by thearrows and adjust the seatback angle to
the desired position.
3- To adjust seat height Operate the switch as indicated by thearrows and adjust the seat height to the
desired position.
If the entire switch is operated, then the entire seat moves.
4- To adjust seat cushion angle Operate the switch as indicated by thearrows and adjust the seat cushion angle
to the desired position.
NOTEz To prevent the battery from running down,
operate the switch with the engine running.Heated seats*
The heated seats can be operated with the ig-
nition switch or the operation mode in ON. Operate the switch as indicated by arrows.
The indication lamp (A) will illuminate while the heater is on.
1 (HI)Heater high (for quick heating).2Heater off.3 (LO)Heater low (to keep the seat warm).CAUT,ONz Operate in the high position for quick heat-
ing. Once the seat is warm, set the heater to low to keep it warm. Slight variations in seat
temperature may be felt while using the heated seats. This is caused by the operation
of the heater’s internal thermostat and does not indicate a malfunction.
z If the following types of persons use the
heated seats, they might become too hot or
receive minor burns (red skin, heat blisters, etc.):

Rear seat (Club cab andDouble cab)*
When a person is sitting in the middle seating position of the rear seat, adjust the head re-
straint to height at which it lock in position.
Refer to “Head restraints*” on page 4-05.Folding the seatback forward
(Double cab)
Pull up the band on the top of the seatback
and fold it forward.
To return (Double cab)
Raise the seatback until it is locked securely in place.
Push and pull the seatback lightly to be sure
it is secure.
Folding up the seat cushion
(Club cab)
The right and left seat cushions can be folded up separately.
To fold the seat cushions up, raise the seat
cushions.
Securely retain the seat cushion by hooking
the retaining band (A) onto the head restraint (B) of the rear seat.
Armrest (Double cab)
To use the armrest, fold it down.
To return to the original position, push it
backward (into the seatback) until it is level
with the seat.NOTEz Do not climb or sit on the armrest. Doing so
could damage the armrest.
z The top surface of the armrest contains a cup
holder for rear seat occupants.
Refer to “Cup holder” on page 7-104.
Rear seat (Club cab and Double cab)*
4-042.7(20(1Seat and seat belts4

Head restraints*:ARN,NGzDriving without the head restraints in
place can cause you and your passengers serious injury or death in an accident. To
reduce the risk of injury in an accident,
always make sure the head restraints are installed and properly positioned when
the seat is occupied.
z Never place a cushion or similar device on
the seatback. This can adversely affect head restraint performance by increasing
the distance between your head and the restraint.
To adjust height
Front seats
Adjust the head restraint height so that the
centre of the head restraint is as close as pos-
sible to ear level to reduce the chances of in- jury in the event of collision. Any person too
tall for the head restraint to reach their seated ear level, should adjust the restraint as highas possible.
To raise the head restraint, move it upward.
To lower the restraint, move it downward while pushing the height adjusting knob (A)
in the direction of the arrow. After adjust- ment, push the head restraint downward andmake sure that it is locked.
Rear centre seat (Double cab)
To reduce the risk of injury in an accident,pull up the head restraint to the locked posi- tion.

To raise the head restraint, move it upward.
To lower the restraint, move it downward
while pushing the height adjusting knob (A) in the direction of the arrow. After adjust- ment, push the head restraint downward and
make sure that it is locked.
Head restraints*
4-052.7(20(1Seat and seat belts4

:ARN,NGzWhen a person sits in the middle seating
position of the rear seat, pull up the head
restraint to a height at which it locks in position. Be sure to make this adjustment
before starting to drive. Serious injuries
could otherwise be suffered as the result of an impact.NOTEz The head restraint height of the outer seat in
the rear seat cannot be adjusted.
To remove
Lift the head restraint with the height adjust-
ing knob (A) pushed in.
To install
Confirm that the head restraint is facing the
correct direction, and then insert it into the
seatback while pressing the height adjusting knob (A) in the direction indicated by the ar-
row.
The head restraint stalk with the adjustment notches (B) must be installed in the hole withthe adjusting knob (A) (except head restraints
of the outer seat).
CAUT,ONz Confirm that the height adjusting knob (A)
is correctly adjusted as shown in the illustra- tion, and also lift the head restraints to en- sure that they do not come out of the seat-back.CAUT,ONz The shape and size of the head restraint dif-
fers according to the seat. Always use the
correct head restraint provided for the seat and do not install the head restraint in the
wrong direction.
Head restraints*
4-062.7(20(1Seat and seat belts4