sunroof MITSUBISHI LANCER EVOLUTION VI 1999 User Guide

BODY – Sunroof42-17
SUNROOF MOTOR CHECK
Check the direction of rotation of the drive gear when the
battery is connected to the connector.
Battery connection terminalDrive gear rotation
di ti12direction
Left
Right
LIMIT SWITCH CONTINUITY CHECK
1. Remove the limit switches from the sunroof motor, and
then check the operation of the limit switches.
Switch positionTerminal No.
4567
Limit switch 1ON
OFF
Limit switch 2ON
OFF
Limit switch 3ON
OFF
2. Check the identification colours. Then install the limit
switches as shown in the illustration.
SUNROOF SWITCH CONTINUITY CHECK
Switch positionTerminal No.
3456
Slide open
Off
Tilt up
Slide close, Tilt down
Left rotationDrive gear
Right rotation
(Red)(White)Limit switch 2, 3
ON
OFF
(Black)
(Black)(Blue)
Limit switch 1

BODY – Sunroof42-18
DISASSEMBLY AND REASSEMBLY
Sealant:
3M ATD Part No.8531 or 3M Part
No.8646, or equivalent
1 2
3 4
5
67
89 10
11
12
1110
NOTE
:Clip position
Disassembly steps
1. Side decoration cover
(Refer to P.42-15.)
2. Roof lid glass assembly
3. Sunroof motor
4. Drip rail assembly
5. Sunshade assembly
6. Cushion (B) assembly7. Drive unit assembly
8. Decoration link
9. Guide (A) assembly
10. Slider assembly
11. Rail cover assembly
12. Frame sub assembly

– Dash Panel WIRING HARNESS
CONFIGURATION DIAGRAMS
Connector
symbol
B
C-10
DASH PANEL
B-38 (2) Sunlight sensor <vehicles with fully
automatic air conditioner>
B-39 (6) Air mix damper motor and potentiometer
<vehicles with fully automatic air condi-
tioner>
B-40 (3) Automatic compressor ECU
<vehicles with manual air conditioner>
B-41 (8) A/C switch
<vehicles with manual air conditioner>
B-42 (2) Blower switch illumination lamp <vehicles
with heater or manual air conditioner>
B-43 (6-B) Defogger switch <vehicles with heater or
manual air conditioner>B-44 (6) Body harness and roof harness combina-
tion <vehicles with sunroof>
B-45 (2-B) Diode (for keyless entry system circuit)
B-46 (2) Spare connector for fog lamp switch
<vehicles without fog lamp>
B-48 (14) J/C (2)
B-49 (14) J/C (3)
B-50 (14-L) J/C (4)
B-51 (21-Y) SRS-ECU
B-52 (16-B) Control harness and body harness
combination <vehicles with ABS>

– Floor and Roof WIRING HARNESS
CONFIGURATION DIAGRAMS
Connector
symbol
D
C-12
FLOOR AND ROOF
D-01 (20) Receiver
<vehicles with keyless entry system>
D-02 (2) Seat belt switch
D-03 (2) Front door switch (driver’s side)
D-04 (10) Body harness and fuel harness combina-
tion
D-05 (6) Body harness and rear door harness
(RH) combination
D-06 (18) Body harness and rear harness combina-
tion
D-07 (6) Sunroof switch
D-08 (2) Room lamp <vehicles with sunroof>D-09 (1) Map lamp
D-10 (18) Sunroof ECU
D-11 (2-GR) Room lamp <vehicles without sunroof>
D-12 (8) Sunroof motor
D-13 (3-B) Fuel gauge unit (sub)
D-14 (2-B) Rear speed sensor (LH)
<vehicles with ABS>
D-16 (6) Body harness and rear door harness (LH)
combination
D-17 (2) Front door switch (passenger’s side)
D-18 (6) Fuel gauge unit (main)