fuel tank removal MITSUBISHI LANCER EVOLUTION VI 1999 Workshop Manual
Page 52 of 558
ENGINE – Fuel and Emission Control Parts11-27
FUEL AND EMISSION CONTROL PARTS
REMOVAL AND INSTALLATION
1
2 3
456
78 9
1011
12
1314
15
16
9 Nm 11 N m
9 Nm 11 N m
18 Nm
Removal steps
1. Throttle body
C2. Throttle body gasket
3. Fuel return pipe
B4. Fuel pressure regulator
5. O-ring
6. Insulator
7. Insulator
A8. Injector9. O-ring
10. Grommet
11. Delivery pipe
12. Vacuum hose and vacuum pipe
13. Vacuum tank
14. Vacuum tank bracket
15. Solenoid valve
16. Solenoid valve bracket
Page 181 of 558
FUEL SUPPLY – General / Fuel Tank13-69
FUEL SUPPLY
GENERAL
OUTLINE OF CHANGE
The service procedures have been revised as shown below because of change in the fuel pump & gauge
assembly and the fuel gauge unit. <EVOLUTION-VI>
FUEL TANK <EVOLUTION-VI>
REMOVAL AND INSTALLATION
4
32 1
65
7
11
Removal steps
1. Fuel hose
2. Fuel pump & gauge assembly
3. Packing
A4. High-pressure fuel hose5. Fuel pipe assembly
6. Fuel gauge unit
7. Packing
NOTE
The service procedures other than those mentioned above
remain unchanged.
INSTALLATION SERVICE POINT
AHIGH-PRESSURE FUEL HOSE INSTALLATION
Caution
After connecting the quick-release joint of the
high-pressure fuel hose, pull it gently in the direction
of removal to check that the hose is firmly connected
with a play of about 3 mm.