bulb MITSUBISHI LANCER EVOLUTION VIII 2004 Workshop Manual

REFERENCE MATERIAL – MAIN EQUIPMENT87
4WD
RSGSR
Equipment
5M/T6M/T
Seat finishFabriclll
Standard typell
Recaro seatr*1r*1l
SlideAdjustment
mechanism
Reclining
lll
Front
Seat
Headrest
Low back bench seat (fixed)
ll
High back bench seat (fixed)
Rear
Seat
Centre arm rest (with cup
holder)
l
2 ¥ 3point with
ELR
With pretensioner
(driver’s seat &
front passenger
seat)
Front
Adjustable
seatbelt anchor
SRS
airbags
Rear2 ¥ 3point with
ELR / ALR + 1 ¥ 2
point belt
lll
Driver’s seatlllSRS
airbags
Front passenger’s seatrrl
Accessories box (1 DIN)ll
Parcel box (with lid)l
Parcel
boxes
Coin box
Glove box
lll
Standard typell
Large typeWith lidl
Shift boot ringl
Front seatlllAshtray
Rear seatl
Floor
console
Cup holder (front seat)lll
Centre panel (unique type)ll
2 DIN typel
HeadliningClothlll
Moulded type (soft)Front door
trim
Door pocket (driver’s
seat, front passenger’s
seat)
Interior
Rear doorMoulded type (soft)
lll
4WD
RSGSR
Equipment
5M/T6M/T
Boot interior trim
Boot interior
floor carpetNeedle punch
l
¥ 1 (front passenger’s seat)llRetractable
assistance
straps
¥ 3 (front passenger’s seat,
rear seats)l
Driver’s seatlll
Front passenger’s seatrrl
Ticket holder (driver’s seat)lll
Sun
visors
Vanity mirror (with lid)l
Internal
mirrorDay / night switchable
Interior
Foot rests
lll
44B20LlllBattery
55B24Lrrr
Halogen (low and
high beam)ll
Discharge (low
beam)
Halogen (high
beam)
Fog lamps
(halogen)
rrl
Position lightslll
Automatic lightsl
Headlight levellingrrl
Extension (black)rrl
Rear combination
lights
(clear type *2)lll
External
lightsHeadlight
assembly
(Clear
type *2)
Extension (black)rrl
High mount stop
lightRear shelf mounting
(bulb type)
Front cabin lights (with map light)
lll
Rear cabin lightslll
Interior
lights
Boot interior light
Combination meterSpecial type
Electric type analogue
speedometer
Twin type trip meter
Tachometer
Water temperature
Meter
gauge
Fuel
lll
Fog lightsrrl
High beam
Turn signal and hazard lights
Equip
ment
Indicator
lights
ACD
lll
Note : *1: 4point seatbelt asymmetric type seat*2: Turn signal lamps coloured amber

MANUAL TRANSMISSION TROUBLESHOOTING2216
Code No.63 Parking brake switchAssumed cause of concern
In cases where, at 15kph or over, the parking brake switch
remains ON for 15 minutes or more, code No.63 is output.• Parking brake switch malfunction
•Harness, connector malfunction
• ABSECU malfunction, <ACD+AYC fitted vehicles>
•4WDECU malfunction
Remarks*1: Refer to ’005 Lancer Sedia Service Manual (No.1036K00)
MUTII/III Service data
• No.62 Parking brake switch
(1)Apply parking brake lever
OK:ON
(2)Release parking brake lever
OK:OFF
OK > intermittent malfunction
When parking brake lever is
released, does the brake
warning lamp go off?
Measurement at D25, parking
brake switch connector
•Undo connector, take
measurement on harness side
•Ignition switch: ON
• Voltage between 1 – earth
OK:battery voltage
Connector check:D25
NG > repair
Check, and if necessary adjust,
the play in the parking brake
lever
(refer to Group 36 – Vehicle
Servicing)
*1
NG > Adjust
Check parking brake switch
(refer to Group 36 – Vehicle
Servicing)
*1
NG > adjust
Connector check:C37, D25,
C20NG > repair
Connector check:D25, C37,
C20, B109 <ACD + AYC fitted
vehicles>
D25, C20, C37 <ACD fitted
vehicles>
NG > repair
(1)Check harness between
parking brake switch – 4WD
ECU
• Check output wire for
earth, damage
(2)Check harness between
parking brake switch –
combi.meter
• Check power supply wire
for earth, damage
(3) Check harness between
parking brake switch – ABS
ECU.
<ACDAYC fitted vehicles>
• Check output wire forearth, damage
NG > repair
Replace hydraulic unit, ABS
ECUCheck harness between
parking break switch – 4WD
ECU
• Check output wire to see if
broken or damaged
NG > repair
MUTII/III Service data
• No.62 Parking brake switch
(1)Apply parking brake lever
OK:ON
(2)Release parking brake lever
OK:OFF
NG > replace 4WDECU
OK > intermittent malfunction
Check brake warning lamp bulb
NG > replace
Replace combi. meter
YESOK
(1) OK
(2) OK
NG
NG
NO
OK
OK
OK
(3) OK
OK
OK
OK