MITSUBISHI OUTLANDER PHEV 2019 Owner's Manual (in English)

ScreenCauseSolution (Reference)
zYou have forgotten to turn off the lamps.zRefer to “Lamps (headlamps, fog lamps,
etc.) auto-cutout function” on page 6-59.z The washer fluid is running low.
z Replenish the container with washer fluid.
Refer to “Washer fluid” on page 11-08.
Refer to “Refill capacities” on page
12-10.
z There is a fault in the LED headlamps.
zHave your vehicle inspected by a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “LED headlamp warning lamp”
on page 6-61.
z There is a fault in the keyless operation
system.z Refer to “Keyless operation system” on
page 4-06.
Indication lamp, warning lamp, and information screen display list
6-332**((Instruments and controls6

ScreenCauseSolution (Reference)
zThe keyless operation key is not detected.
zInsert the keyless operation key into the
key slot.
Refer to “If the keyless operation key is not operating properly” on page 7-15.
z You have forgotten to remove the keyless
operation key from the key slot.
z Remove the keyless operation key from
the key slot.
Refer to “Keyless operation key remind-
er” on page 7-15.
z There is a fault in the EPS.
z Have the vehicle inspected by a
MITSUBISHI MOTORS Authorized
Service Point as soon as possible.
Refer to “Electric power steering system (EPS)” on page 7-42.
z The RBS (regenerative brake system) can-
not be used.z Have your vehicle inspected by a
MITSUBISHI MOTORS Authorized
Service Point.
Indication lamp, warning lamp, and information screen display list
6-342**((Instruments and controls6

ScreenCauseSolution (Reference)
zThere is a fault in the ABS.
z Avoid sudden braking and high-speed
driving, stop the vehicle in a safe place, and take corrective measures. Refer to“ABS warning lamp/display” on page
7-41.
z The tyre pressure in one of the tyres is
low.z Refer to “Tyre pressure monitoring sys-
tem warning lamp/display” on page
7-93.z There is a fault in the tyre pressure moni-
toring system.z Refer to “Tyre pressure monitoring sys-
tem warning lamp/display” on page 7-93.z One of the doors or the tailgate is not
completely closed.
The open door is displayed.z Close the door or tailgate.
Refer to “Door ajar warning display screen” on page 6-11.
z The bonnet is open.zClose the bonnet.
Refer to “Bonnet” on page 11-04.Indication lamp, warning lamp, and information screen display list
6-352**((Instruments and controls6

ScreenCauseSolution (Reference)
zThere is a fault in the electronic immobil-
izer (Anti-theft starting system).
z Put the operation mode in OFF, and then
start the Plug-in Hybrid EV System again.
If the warning is not cancelled, please
contact a MITSUBISHI MOTORS Au-
thorized Service Point.z The driver’s door is open when the opera-
tion mode is in any mode other than OFF.z Put the operation mode in OFF.
Refer to “Operation mode ON reminder
system” on page 7-13.z An attempt was made to lock all the doors
and the tailgate when the operation mode
is in any mode other than OFF.z Put the operation mode in OFF.
Refer to “Operation mode OFF reminder
system” on page 7-13.
z There is a fault in the electrical system.
z Immediately stop the vehicle in a safe
place.
We recommend you to contact a MITSUBISHI MOTORS Authorized
Service Point.
z The engine is overheated.
zStop the vehicle in a safe place and take
corrective measures.
Refer to “Engine overheating” on page 9-04.
z You put the operation mode in ON with-
out fastening your seat belt.z Fasten your seat belt properly. Refer to
“Seat belt reminder” on page 5-11.Indication lamp, warning lamp, and information screen display list
6-362**((Instruments and controls6

ScreenCauseSolution (Reference)
zThere is a fault in the fuel system.z We recommend you to have it checked,
immediately.z The fuel is running low.z Refuel as soon as possible. Refer to
“Fuel
remaining warning display” on page 6-12.z You are driving with the parking brake
still applied.z Release the parking brake. Refer to
“Brake warning display” on page 6-58.z The brake fluid level in the reservoir has
fallen to a low level.
z There is a fault in the brake system.
zImmediately stop the vehicle in a safe
place.
We recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Brake warning display” on page 6-58.z When the brake pedal has been repeatedly
depressed over a short period of time, the
brake warning lamp may come on and the brake warning buzzer may sound, and this warning may be displayed.z If this warning display has disappeared
and the brake warning lamp goes out and the buzzer stops a few seconds after stop-
ping the brake operation, there is no ab-
normality.
Indication lamp, warning lamp, and information screen display list
6-372**((Instruments and controls6

ScreenCauseSolution (Reference)
zThere is a fault with the Electric parking
brake.
z We recommend you to have it checked,
immediately.
Refer to “Electric parking brake” on page
7-03.z The parking brake cannot be applied tem-
porarily due to repeated operation of the
Electric parking brake switch within a short time.
z Refer to “Electric parking brake” on page
7-03.z You try to release the Electric parking
brake switch without depressing the brake
pedal.z Refer to “Electric parking brake” on page
7-03.z The Electric parking brake has been auto-
matically applied.z Refer to “Brake auto hold” on page 7-35.zThe brake auto hold is automatically can-
celled.z Refer to “Brake auto hold” on page 7-35.Indication lamp, warning lamp, and information screen display list
6-382**((Instruments and controls6

ScreenCauseSolution (Reference)
zThe brake auto hold is not available.z Refer to “Brake auto hold” on page 7-35.
zThe brake auto hold system does not turn
on because the driver’s seat belt is not fas-
tened.z Press the brake auto hold switch after fas-
tening the driver’s seat belt.
Refer to “Brake auto hold” on page 7-35.z The brake auto hold system does not turn
off because the brake pedal is not pressed.
z Depress the brake pedal more firmly than
usual with the right foot. Then, press the brake auto hold switch.
Refer to “Brake auto hold” on page 7-35.
z There is a fault in the engine oil circula-
tion system.
z Immediately stop the vehicle in a safe
place. We recommend you to have it checked.
Refer to “Oil pressure warning display” on page 6-58.
z There is a fault in the Supplemental re-
straint system (SRS) airbag or the preten-
sioner system.z We recommend you to have it checked,
immediately.
Refer to “SRS warning lamp/display” on
page 5-35.
Indication lamp, warning lamp, and information screen display list
6-392**((Instruments and controls6

ScreenCauseSolution (Reference)zThere is a fault in the Active Stability
Control (ASC).z We recommend you to have it checked.
Refer to “Active stability control (ASC)” on page 7-43.z There is a fault in the hill start assist.zWe recommend you to have it checked.
Refer to “Hill start assist” on page 7-37.
z The outside temperature is
3

ScreenCauseSolution (Reference)zThe Adaptive Cruise Control System
(ACC) control is automatically cancelled
and the system is placed in the ‘standby’
state.
z Refer to “How to use ACC” on page 7-61.
zConditions for the start of control are not
met, the Adaptive Cruise Control System (ACC) can not start the control.z The Adaptive Cruise Control System
(ACC) can not start the control because
the speed is out of speed range.z The Adaptive Cruise Control System
(ACC) can not start the control because
not detected the approach of the vehicles in front.z The Adaptive Cruise Control System
(ACC) is not available temporarily such
as for adhesion of contaminants to the sensor.
This is not a malfunction.
Indication lamp, warning lamp, and information screen display list
6-412**((Instruments and controls6

ScreenCauseSolution (Reference)
zThere is a fault in the Adaptive Cruise
Control System (ACC).z We recommend you to have it checked.
Refer to “Adaptive Cruise Control System
(ACC)” on page 7-55.z There is a fault in the Forward Collision
Mitigation System (FCM).z We recommend you to have it checked.
Refer to “Forward Collision Mitigation System (FCM)” on page 7-67.z FCM braking function of the Forward
Collision Mitigation System (FCM) hasbeen activated.
z Refer to “FCM braking function” on page
7-69.
z The Forward Collision Mitigation System
(FCM) is temporarily unavailable for
some reason. This is not a malfunction.z The Lane Departure Warning (LDW) has
detected that your vehicle is about to
leave or has left the lane.z Refer to “Lane Departure Warning
(LDW)” on page 7-88.Indication lamp, warning lamp, and information screen display list
6-422**((Instruments and controls6