MITSUBISHI OUTLANDER PHEV 2020 Owner's Manual (in English)

SRS warning lamp/display
There is a Supplemental Restraint System(“SRS”) warning lamp on the instrument
panel. The system checks itself every time the operation mode of the power switch is put
in ON. The SRS warning lamp will come on
for several seconds and then go out. This is
normal and means the system is working properly.
If there is a problem involving one or more of the SRS components, the warning lamp will come on and stay on. At the same time, thewarning display will appear on the informa-
tion screen in the multi information display.
The SRS warning lamp/display is shared by
the SRS airbag and the seat belt pretensioner system.
:ARN,NGz If any of the following conditions occur,
there may be a problem with the SRS air-
bags and/or seat belt pretensioners, and they may not function properly in a colli-
sion or may suddenly activate without a
collision:

2**(20(1

Instruments.......................................................................................... 6-02
Multi information display................................................................... 6-04
Indication lamp, warning lamp, and information screen display list....................................................................................... 6-23
Indication lamps.................................................................................. 6-54
Warning lamps.................................................................................... 6-55
Information screen display.................................................................. 6-57
Combination headlamps and dipper switch........................................ 6-58
Headlamp levelling............................................................................. 6-65
Turn-signal lever................................................................................. 6-66
Hazard warning flasher switch............................................................6-67 ECO mode switch............................................................................... 6-67
Fog lamp switch.................................................................................. 6-68
Wiper and washer switch.................................................................... 6-68 Wiper de-icer switch*......................................................................... 6-73
Rear window demister switch............................................................. 6-73
Heated windscreen switch*.................................................................6-74 Heated steering wheel switch*............................................................6-75Horn switch......................................................................................... 6-75,nstrumentsandcontrols
2**(20(16

Instruments
1- Energy usage indicator o p. 6-02
2- Multi information display o p. 6-04
Information screen display list
o p. 6-24
3- Speedometer (km/h or mph + km/h)
4- Rheostat illumination button o p. 6-03
Energy usage indicatorReady OFF position
Indicates that the vehicle cannot run
(READY OFF).
When the vehicle is ready for running, the
needle of the energy usage indicator moves to the horizontal position.
EV zone
The EV zone shows the output during EV
drive (driving with the engine stopped).
The EV zone is covered by the numbers 1 and 2 in the illustration.
Zone 1 shows the state that the EV drive can
be maintained, while zone 2 shows the state that the engine starts in high possibility. As
the motor output increases, the movement range of the needle of the energy usage indi-cator increases.
In addition, the needle of the energy usage in-
dicator indicates the horizontal position when the engine is stopped or when there is noelectric energy generated by the motor output
and the regenerative brake.
Instruments
6-022**(20(1Instruments and controls6 EV zoneEngine out- put zone
Charge zone Ready OFF position
Charging power gauge
EV zone details1: Zone that the EV drive can be maintained2: Zone that the engine starts in high possibility

NOTEzDepending on the state of the vehicle (such
as during heating of the air conditioner), the engine may start even if the needle of the en-
ergy usage indicator is indicated before zone
2 (the zone that the engine starts in high pos- sibility).
z Even when the EV priority mode is selected
and the engine does not start, the needle of the energy usage indicator may indicate zone
2 (the zone that the engine starts in high pos- sibility).
z When the EV priority mode is selected, even
if the needle of the energy usage indicator
enters zone 2, it will not start the engine un- less it is over the specified point by pressing
the accelerator pedal.
z Depending on the vehicle condition, the
movement of the needle of the energy usage
indicator may be different or fluctuate.
z Economical driving can be achieved by op-
erating in such state that the swing of the needle is small within zone 1.
Charge zone
Indicates the charging power generated by
the regenerative brake.
The more the needle moves, the more electric energy is charged.
The needle of the energy usage indicator may not enter the charge zone when the drive bat-
tery is close to full charge.
Also, if the needle of the energy usage indi-
cator indicates the engine output zone, the needle does not indicate the charge zone even
when there is charging of the electrical ener-
gy by regenerative braking.NOTEz With the charging power gauge of the multi
information display, you can check thecharging power of electric energy generated
by regenerative braking even while the en- gine is operating.
z Both the display of the charge zone by the
energy usage indicator needle and the dis- play of the charging power gauge in the mul-
ti information display indicate the charging power of electric energy by regenerative
braking.
Engine output zone
Indicates the instantaneous output (kW) of
the engine.
Meter illumination control
Each time you press the rheostat illumination
button, there is a sound and the brightness of the instruments changes.
1- Brightness level
2- Rheostat illumination button
NOTEz You can adjust to 8 different levels respec-
tively for when the position lamps are illu- minated and when they are not.
z When the lamp switch is in a position other
than the “OFF” position, the meter illumina-
tion switches automatically to the adjusted brightness, depending on the brightness out- side the vehicle.
z The brightness level of the instruments is
stored when the operation mode of the pow-
er switch is put in OFF.
Instruments
6-032**(20(1Instruments and controls6

NOTEzIf you press and hold the button for about 2
seconds or more when the position lamps are illuminated, the brightness level changes to
the maximum level. Pressing and holding the button for about 2 seconds or more again
returns the brightness level to the previous
level.Multi information display
Always stop the vehicle in a safe place before
operating.
The following information is included on the multi information display: warnings, odome-
ter, tripmeter, average fuel consumption, EV
cruising range, total cruising range, EVHV driving rate, energy flow, etc.
[When the operation mode of the power
switch is OFF@
1- mark display screen o p. 6-10
2- Information screen o p. 6-06
Interrupt display screen o p. 6-09
3- Drive battery level display screen
o p. 6-10
4- Odometer o p. 6-12
5- “
” or “ ” mark indicator o p. 6-09
6- Door ajar warning display screen
o p. 6-10
NOTEz The drive battery level display screen ap-
pears when any of the doors or the tailgate is
opened during charging.
[When the operation mode of the power
switch is ON@
Multi information display
6-042**(20(1Instruments and controls6

1- NORMAL mode indicator display
2- SNOW mode indicator display
3- LOCK mode indicator display S-AWC (Super All Wheel Control)
o p. 7-20
4- ECO mode indicator display ECO mode switch o p. 6-67
5- SPORT mode indicator display SPORT mode switch o p. 7-30
6- Battery charge mode display screen
o p. 7-29
7- Battery save mode display screen
o p. 7-28
8- EV priority mode display screen
o p. 7-25
9-
mark display screen o p. 6-10
10- Speed Limit Display screen* o p. 7-91
11- Lane Departure Warning (LDW) display
screen* o p. 7-87
12- Cruise control display screen*
o p. 7-44
13- Adaptive Cruise Control System (ACC)
display screen* o p. 7-54
14- Speed limiter display screen*
o p. 7-49
15- Drive battery level display screen
o p. 6-10
16- Odometer o p. 6-12
17- “
” or “ ” mark indicator o p. 6-09
18- Information screen o p. 6-08
19- Select position indicator o p. 7-17
20- Fuel remaining display screen
o p. 6-10
21- Outside temperature display screen
o p. 6-12
22- Charging power gauge o p. 6-11Multi information display
switch
Each time the multi information display
switch is operated, the buzzer sounds and the multi information display changes between
information such as warnings, tripmeter, average fuel consumption, EV cruising range,
total cruising range, EVHV driving rate, en-
ergy flow, etc.
It is also possible to change elements such as the language and units used on the multi in-formation display by operating the multi in-
formation display switch.
Multi information display
6-052**(20(1Instruments and controls6

Information screen (when the operation mode is OFF)
Each time you lightly press the multi information display switch, the display screen switches in the following order.
*1
: When there is no warning display
* 2
: When there is a warning display
1- Tripmeter o p. 6-12
2- Tripmeter
o p. 6-12
3- ECO score display o p. 6-16
4- Predicted charging time o p. 3-10, 3-17
5- Service reminder o p. 6-126- Redisplay of a warning display screen
o p. 6-09

Multi information display
6-062**(20(1Instruments and controls6* 2*1

Information screen (when the operation mode is changed from OFF to ON)
When the operation mode is put in ON, the display screen switches in the following order.
*1
: When the inspection time has arrived
1- Screen when the operation mode is OFF
2- System check screen o p. 6-143- Screen when the operation mode is ON
4- Service reminder o p. 6-12

Multi information display
6-072**(20(1Instruments and controls6

Information screen (when the operation mode is ON)
Each time you lightly press the multi information display switch, the display screen switches in the following order.
*1
: When the vehicle is charged
* 2
: When there is no warning display
* 3
: When there is a warning display
1- Tripmeter o p. 6-12
2- Tripmeter
o p. 6-12
3- EV cruising range display/Total cruising range display o p. 6-14
4- Average fuel consumption display o p. 6-15
EVHV driving rate display o p. 6-15
5- Energy flow display o p. 6-15
or
Energy flow display during charging
o p. 3-27
6- ECO score display o p. 6-16
7- S-AWC (Super-All Wheel Control) op- eration display o p. 7-228- Service reminder o p. 6-12
9- Function setting screen o p. 6-16
10- Redisplay of a warning display screen o p. 6-09
Multi information display
6-082**(20(1Instruments and controls6or