MITSUBISHI OUTLANDER PHEV 2020 Owner's Manual (in English)

ScreenCauseSolution (Reference)zWhen the operation mode of the power
switch is put in ON during charging.z The electric devices can be used during
charging. Refer to “How to use an electricdevice during charging” on page 3-24.
z EV priority mode is not available because
the drive battery level is low.
z Refer to “EV switch” on page 7-25.
zEV priority mode is not available because
the cruise control or the Adaptive Cruise
Control System (ACC) is operating.
z EV priority mode is not available because
the drive battery is too cold.z EV priority mode is not available because
the EV priority mode is limited to protect
the Plug-in Hybrid EV System or the out-
side temperature is too low.
Indication lamp, warning lamp, and information screen display list
6-292**(20(1Instruments and controls6

ScreenCauseSolution (Reference)
zEV priority mode is cancelled because the
drive battery level is low.
z EV priority mode is cancelled because the
vehicle speed of the cruise control or theAdaptive Cruise Control System (ACC) is
set.z EV priority mode is cancelled because the
drive battery temperature has become too
cold.
z EV priority mode is cancelled because the
protecting device of the Plug-in Hybrid
EV System is operated.
z Preparation to open the fuel tank filler
door is in progress.z Wait until the preparation is complete. Re-
fer to “Filling the fuel tank” on page 2-15.
Indication lamp, warning lamp, and information screen display list
6-302**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zPreparation to refuel has been completed
and the fuel tank filler door is open.z Please begin refueling.
For information on how to refuel, refer to “Filling the fuel tank” on page 2-15.z There is a fault in the refueling system.zContact a
MITSUBISHI MOTORS Au-
thorized Service Point to have the system checked.
Refer to “Filling the fuel tank” on page
2-15.z The fuel tank filler door is open.z Check that the fuel cap is closed, then
close the fuel tank filler door.
Refer to “Filling the fuel tank” on page 2-15.z You have selected the warm air with the
air conditioner switch while driving in the EV priority mode.
(Vehicle without electric heater)z If you want to use the heating, cancel the
EV priority mode.
Refer to “EV switch” on page 7-25.z You have pressed the EV switch while
heating.
(Vehicle without electric heater)z If you want to use the EV priority mode,
stop the heating.
Refer to “Automatic climate control air conditioner” on page 8-06
Indication lamp, warning lamp, and information screen display list
6-312**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zSPORT mode is not available because the
remaining fuel quantity is low.z Refer to “SPORT mode switch” on page
7-30.z SPORT mode is cancelled because the re-
maining fuel quantity has become low.z Battery save mode or battery charge mode
is not available because the engine cool-
ant temperature is high or the remaining fuel quantity is low.z Refer to “SAVE/CHARGE mode switch”
on page 7-27.z Battery save mode or battery charge mode
is cancelled because the engine coolant
temperature has become high or the re- maining fuel quantity has become low.
z You have forgotten to turn off the lamps.zRefer to “Lamps (headlamps, fog lamps,
etc.) auto-cutout function” on page 6-58.Indication lamp, warning lamp, and information screen display list
6-322**(20(1Instruments and controls6

ScreenCauseSolution (Reference)
zThe washer fluid is running low.
z Replenish the container with washer fluid.
Refer to “Washer fluid” on page 11-07.
Refer to “Capacity” on page 12-10.
z There is a fault in the LED headlamps.
zHave your vehicle inspected by a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “LED headlamp warning lamp”
on page 6-60.
z There is a fault in the keyless operation
system.z Refer to “Keyless operation system” on
page 4-07.
Indication lamp, warning lamp, and information screen display list
6-332**(20(1Instruments and controls6

ScreenCauseSolution (Reference)
zThe keyless operation key is not detected.
zInsert the keyless operation key into the
key slot.
Refer to “If the keyless operation key is not operating properly” on page 7-14.
z You have forgotten to remove the keyless
operation key from the key slot.
z Remove the keyless operation key from
the key slot.
Refer to “Keyless operation key remind-
er” on page 7-15.
z There is a fault in the EPS.
z Have the vehicle inspected by a
MITSUBISHI MOTORS Authorized
Service Point as soon as possible.
Refer to “Electric power steering system (EPS)” on page 7-41.
z The RBS (regenerative brake system) can-
not be used.z Have your vehicle inspected by a
MITSUBISHI MOTORS Authorized
Service Point.
z There is a fault in the ABS.
z Avoid sudden braking and high-speed
driving, stop the vehicle in a safe place, and take corrective measures. Refer to“ABS warning lamp/display” on page
7-40.
Indication lamp, warning lamp, and information screen display list
6-342**(20(1Instruments and controls6

ScreenCauseSolution (Reference)
zThe tyre pressure in one of the tyres is
low.z Refer to “Tyre pressure monitoring sys-
tem warning lamp/display” on page
7-93.z There is a fault in the tyre pressure moni-
toring system.z Refer to “Tyre pressure monitoring sys-
tem warning lamp/display” on page 7-93.z One of the doors or the tailgate is not
completely closed.
The open door is displayed.z Close the door or tailgate.
Refer to “Door ajar warning display screen” on page 6-10.
z The bonnet is open.zClose the bonnet.
Refer to “Bonnet” on page 11-04.z There is a fault in the electronic immobil-
izer (Anti-theft starting system).
z Put the operation mode in OFF, and then
start the Plug-in Hybrid EV System again.
If the warning is not cancelled, please
contact a MITSUBISHI MOTORS Au-
thorized Service Point.
Indication lamp, warning lamp, and information screen display list
6-352**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zThe driver’s door is open when the opera-
tion mode is in any mode other than OFF.z Put the operation mode in OFF.
Refer to “Operation mode ON reminder
system” on page 7-13.z An attempt was made to lock all the doors
and the tailgate when the operation mode
is in any mode other than OFF.z Put the operation mode in OFF.
Refer to “Operation mode OFF reminder
system” on page 7-13.
z There is a fault in the electrical system.
z Immediately stop the vehicle in a safe
place.
We recommend you to contact a MITSUBISHI MOTORS Authorized
Service Point.
z The engine is overheated.
zStop the vehicle in a safe place and take
corrective measures.
Refer to “Engine overheating” on page 9-04.
z You put the operation mode in ON with-
out fastening your seat belt.z Fasten your seat belt properly. Refer to
“Seat belt reminder” on page 5-11.z There is a fault in the fuel system.z We recommend you to have it checked,
immediately.Indication lamp, warning lamp, and information screen display list
6-362**(20(1Instruments and controls6

ScreenCauseSolution (Reference)
zThe fuel is running low.z Refuel as soon as possible. Refer to
“Fuel
remaining warning display” on page 6-11.z You are driving with the parking brake
still applied.z Release the parking brake. Refer to
“Brake warning display” on page 6-57.z The brake fluid level in the reservoir has
fallen to a low level.
z There is a fault in the brake system.
zImmediately stop the vehicle in a safe
place.
We recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Brake warning display” on page 6-57.z When the brake pedal has been repeatedly
depressed over a short period of time, the
brake warning lamp may come on and the brake warning buzzer may sound, and this warning may be displayed.z If this warning display has disappeared
and the brake warning lamp goes out and the buzzer stops a few seconds after stop-
ping the brake operation, there is no ab-
normality.
z There is a fault with the Electric parking
brake.
z We recommend you to have it checked,
immediately.
Refer to “Electric parking brake” on page
7-03.
Indication lamp, warning lamp, and information screen display list
6-372**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zThe parking brake cannot be applied tem-
porarily due to repeated operation of the
Electric parking brake switch within a short time.
z Refer to “Electric parking brake” on page
7-03.z You try to release the Electric parking
brake switch without depressing the brake
pedal.z Refer to “Electric parking brake” on page
7-03.z The Electric parking brake has been auto-
matically applied.z Refer to “Brake auto hold” on page 7-34.zThe brake auto hold is automatically can-
celled.z Refer to “Brake auto hold” on page 7-34.zThe brake auto hold is not available.z Refer to “Brake auto hold” on page 7-34.Indication lamp, warning lamp, and information screen display list
6-382**(20(1Instruments and controls6