MITSUBISHI OUTLANDER PHEV 2020 Owner's Manual (in English)

ScreenCauseSolution (Reference)zThe vehicle had not been refueled about
15 litres or more at one time for nearly 3months.
This display may appear frequently de-
pending on the use conditions of your ve- hicle such as when fuel has been staying
in the fuel tank for a long time.z Refill the 15 litres more at one time.
This display will disappear.
If the fuel remaining display will be be- low half, you can refill the fuel more than
15 litres certainly.
z If you cannot refill the fuel due to the
large amount of remaining fuel, start the
engine and drive the vehicle enough to re- duce the fuel level to approximately half
tank.z If the vehicle had not been refuelled about
15 litres or more at one time for three
months, the engine starts automatically for the maintenance of the engine or the
fuel system components while the ready indicator is illuminated.
This display may appear frequently de-
pending on the use conditions of your ve- hicle such as when fuel has been staying
in the fuel tank for a long time.
When the engine is running, this display shows the state where the drive battery is
charged, and the battery charge mode dis-
play (
) is displayed. But the
drive battery will not be full charge.
z Refill the 15 litres more at one time. This
display and battery charge mode display will disappear, and the engine will not au- tomatically start for maintenance.
If the fuel remaining display will be be- low half, you can refill the fuel more than
15 litres certainly.
z If you cannot refill the fuel due to the
large amount of remaining fuel, start the engine and drive the vehicle enough to re-
duce the fuel level to approximately half
tank.
Indication lamp, warning lamp, and information screen display list
6-492**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zThe accelerator pedal has been depressed
when the select position is in the “N”
(NEUTRAL) position.z When you start the vehicle, be sure to
check the select position indicator and make sure the select position is in the “D”(DRIVE) or “R” (REVERSE) position.
Then, please depress the accelerator ped-
al.
Refer to “Select position indicator” on page 7-17.z The selector lever has been operated when
the select position is in “P” (PARK) posi-
tion and the brake pedal is not depressed.z Operate the selector lever while depressed
firmly on the brake pedal.
The operation status of each system is displayed on the information screen. Refer to the appropriate page for the system for further details.
ScreenSystem operation statusReferencez When charging of the drive battery is
completed.Refer to “Charging” on page 3-02.z When “NORMAL” mode of S-AWC is
selectedRefer to “S-AWC drive mode” on page 7-21.
Indication lamp, warning lamp, and information screen display list
6-502**(20(1Instruments and controls6

ScreenSystem operation statusReferencezWhen “SNOW” mode of S-AWC is selec-
tedRefer to “S-AWC drive mode” on page 7-21.z When “LOCK” mode of S-AWC is selec-
tedRefer to “S-AWC drive mode” on page 7-21.z When the mode is changed by the ECO
mode switch.Refer to “ECO mode switch” on page 6-67.z When approaching the guidance location,
etc.Refer to “Navigation information display” onpage 6-46.z When the EV priority mode is activated.Refer to “EV switch” on page 7-25.
Indication lamp, warning lamp, and information screen display list
6-512**(20(1Instruments and controls6

ScreenSystem operation statusReferencezWhen the battery save mode is activated.Refer to “Battery save mode” on page 7-28.zWhen the battery charge mode is activa-
ted.Refer to “Battery charge mode” on page 7-29.z When the SPORT mode is activatedRefer to “SPORT mode switch” on page
7-30.z When the reversing sensor system detects
an obstruction.Refer to “Reversing sensor system” on page7-97.z When the parking sensors detect an obsta-
cle.Refer to “Parking sensors (Front/Rear)” on
page 7-101.
Indication lamp, warning lamp, and information screen display list
6-522**(20(1Instruments and controls6

ScreenSystem operation statusReferencezWhen the Forward Collision Mitigation
System (FCM) is activated or the timing of an alarm is changed.Refer to “FCM and UMS ON/OFF switch” on
page 7-70.z When the Forward Collision Mitigation
System (FCM) is deactivated.Refer to “FCM and UMS ON/OFF switch” on
page 7-70.z When the Ultrasonic misacceleration Mit-
igation System (UMS) is deactivated.Refer to “To turn on/off the UMS” on page 7-81.
This informs you that a periodic inspection is due.
ScreenSolutionWe recommend you to have it checked. Refer to “Service reminder” on page 6-12.
Indication lamp, warning lamp, and information screen display list
6-532**(20(1Instruments and controls6

The setting for rest interval can be changed.ScreenSolutionStop the vehicle in a safe place, stop the Plug-in Hybrid EV system, and take a rest.
Use this display as rough guide for taking rests during a long drive.
The interval from the start of your trip until this message is displayed can be set. Refer to “Changing the time until REST REMINDER is displayed” on page 6-21.
The display and buzzer alert the driver when the set time is reached. If you continue to drive without having a rest, the buzzer sounds about every 5 minutes to encourage
you to take a rest.
z In the following cases, the time driven is reset and the display returns to the pre-
vious display screen. After this, when the set time is reached again, the buzzer
and display encourage you to take a rest.

Rear fog lamp indication lamp
This lamp illuminates whilethe rear fog lamp is on.
Position lamp indication lamp
This indication lamp illumi-
nates while the position
lamps are on.
Ready indicator
The ready indicator keeps flashing until the Plug-in
Hybrid EV System is activa-
ted. When the Plug-in Hy- brid EV System has activa-
ted normally and the vehicle
becomes ready to run, the lamp stops flashing and stays lit. Refer to “Starting the Plug-in
Hybrid EV System” on page 7-13.
If the indicator keeps flashing, the vehicle
cannot be driven.
Charging indicator
This indicator flashes when
the EV charging cable or
quick charging cable is con- nected.
After that, the lamp switches to being illuminated when
charging starts and goes out when charging is completed.
NOTEz Although it is possible to start the Plug-in
Hybrid EV System if quick charging has notfinished normally, the charging indicator is
continuously blinking.
Refer to “Charging troubleshooting guide” on page 3-28.Warning lampsBrake warning lamp
This lamp illuminates when
the operation mode of the power switch is put in ON,
and goes off after a few sec- onds.
Always make sure that the
lamp goes off before driving.
With the operation mode in ON, the brake
warning lamp illuminates under the following
conditions:
z When the parking brake lever has been
engaged.
z When the brake fluid level in the reser-
voir falls to a low level.
z When the braking system is an abnor-
mality.
With the operation mode in ON, a buzzer
sounds under the following condition:
z The vehicle speed exceeds 8 km/h
(5 mph) with the parking brake applied.CAUT,ONz In the situations listed below, brake perform-
ance may be compromised or the vehicle may become unstable if brakes are applied
suddenly; consequently, avoid driving at
high speeds or applying the brakes suddenly. Furthermore, the vehicle should be brought
to a stop in a safe location and to have it checked.

CAUT,ONzThe vehicle should be brought to a halt in
the following manner when brake perform-
ance has deteriorated.

Auxiliary battery charge warn-ing lamp
This warning lamp will illu- minate when there is a fault
with the charging system of
the auxiliary battery.
Normally, when the opera-
tion mode of the power
switch is put in ON, this warning lamp will illuminate. Then, when the Plug-in Hybrid EV System is started and the ready indicator
illuminates, the warning lamp will go out.
CAUT,ONz If the warning lamp stays on after the ready
indicator illuminates, there may be a prob- lem with the charging system for the auxili- ary battery.

CAUT,ONzIf a vehicle is driven without releasing the
parking brake, the brake will be overheated,
resulting in ineffective braking and possible brake failure.
If this warning is displayed, release the park-
ing brake.
When the operation mode of the power
switch is put in ON, if the brake fluid is low,
this warning is displayed.
The warning lamp in the instrument cluster also illuminates.
CAUT,ONz If this warning stays illuminated and does
not go out while driving, there is a danger of
ineffective braking. In this case, immediately
park your vehicle in a safe place and we rec-
ommend you to have it checked.CAUT,ONz If the brake warning display is displayed and
the brake warning lamp and the ABS warn-
ing lamp are illuminated at the same time,
the braking force distribution function will not operate, so the vehicle may be destabi-
lised during sudden braking. Avoid sudden
braking and high-speed driving, stop the ve- hicle in a safe place, and we recommend you
to have it checked.
z The vehicle should be brought to a halt in
the following manner when brake perform-
ance has deteriorated.