warning NISSAN 300ZX 1984 Z31 Electrical System User Guide

VOICE WARNING SYSTEM
Wiring Diagram

VOICE WARNING SYSTEM
Operational Check
Fuel level
I Condition I Voice Warning -~ ~
Item
Fuel level less than
1OP (2-5/8USgal, - “Fuel level is low’’
2-1/4 Imp gal) ~~
Left
door
Door switch L H is “ON“
(Left door is open)
ignition switch
“OFF” Light
Door switch L H is
”ON”
(Left door is open)
Lighting switch is “ON” “Lights are ON”
“Left door is open”
Speed switch is “ON”
Vehicle speed is more
than
10 km/h (6 MPH)
Door switch R H is
”Right door is open”
Parking brake switch Parking brake is “ON” ”Parking brake is ON”
e If rhe warning is not properly given under the above condition, go to “Trouble-Shooting”.
EL-78

VOICE WARNING SYSTEM
Trou ble-shooting
Voltmeter
Condition
1 Ignition sw "ACC"
Check if speaker in driver's door
produces sound wheri radio
is
turned "ON"
Ignition sw "OFF"
Normal
i
Check harness connector run-
ning to driver's door speaker
Lighting switch "ON"
Check voice warning switch
CNG>
More than 9V
Replace voice warning switch i
v
Disconnect connector running to voice warning device and check voltage
at each terminal of connector
I- I I
I OK T
Replace voice warning device
I NG i
Check harness
EL-79

rn I-
0
do
Left door Right door Parking brake Fuel level Light
OK (7) Check if step lamp
left or right door
is opened
Check door switch
I
I
lxeed % Sensor
Signal Check"
-1 (Refer to "METER I
Check if fuel
warning lamp
comes on when Check if parking
brake warning
lamp comes on
when parking
brake lever
is
pulled with
ignition switch
"ON"
NG
Check parking
brake switch Check fuel tank
gauge unit
(Refer to "METER
AND GAUGES")
Repair or
replace
AND GAUGES" )
v
Check for loose connector,
poor grounding
or broken wire
'""I
Repair or
replace
OK
Replace voice warning device
Check if all illumi-
nation lamps come
on when lighting
switch
is "ON"
Check lighting
switch

TIME CONTROL SYSTEM
CAUTION
Never touch the terminals of time control unit with bare hands.
1) Intermittent wiper control timer 5) Light warning timer
2) Interior lamp timer 6) Key warning timer
3) Door key hole illumination timer 7) Seat belt warning timer
4) Illumination control timer 8) Rear defogger timer
Time control unit has the following functions
ltNlTlON SWlTCH IGNITION lGNlTlON
FUSE
TlME CONTROLUNil /I
1
SEL705D
EL-81

TIME CONTROL SYSTEM
Trouble-shooting (Cont'd)
(Interior lamp will not illuminate when outside door
handle
on driver's side IS pulled 1 I
Interior lamp and step lamps do not fade out after
all doors are closed
Check if door warning lamp goes off after all doors
are closed Check if interior lamp fades out after all doors
are closed
OK NG Check door switch
Go to "Interior lamp
circuit check" Go to "Power Supply Circuit Check"
OK NG
Check harness between
T C U and interior lamp
v
Check door handle switch circuit check
OK NG
Check door handle switch
Replace T C U Check harness between T c u
and door handle switch
NG
Check harness between
T C U and interior lamp
1
INTERIOR LAMP CIRCUIT CHECK
1 Turn Ignition switch to "OFF"
2 Measure voltage across @ and @
Check from harness ride
0 V when door 15 open 0- 12 V when
door IS closed after once opened
SEL7lZO
DOOR HANDLE SWITCH CIRCUIT
CHECK
1
2
3
Turn ignition switch to "OFF"
Pull outside door handle (driver's side)
Check continuity between @ and @
Check from harness sade
I OR
ye?! door handle (driver's rude)
SEL713D ohmmeter
EL-85

TIME CONTROL SYSTEM
Trouble-shooting (Cont'd)
CHIME CIRCUIT CHECK
1
2
Turn ignition switch to "OFF"
Measure voltage across @ and @ when
driver's door
is opened and closed
Check from harness ride I
I Warning chime does not actlvate
1
I Go to "Power SUDD~V Circuit Check" 1
ignition rwltch OFF Approx 12Vwhen drlver'r stde door IS closed Voltmeter needle swings (0 - 12V) when dnver's
%,de door tr opened SEL718D Voltmeter
STEERING LOCK SWITCH CIRCUIT
CHECK
1
2
Turn ignition switch to "OFF"
Check voltage between @ and @
Check from harness side
12V when ignmon key IS ret into key cyllndei OV when tgnltlon key 16 pulled out of key cylinder Voltmeter SEL7190
lamp does not go off nor come on
I + Go to "Power Supply Circuit Check" 1 1 OK 1 NG
Check harness for T c u
power supply circuit
Check belt warning circuit
OK NG
Check warning lamp
v
Check seat belt switch circuit
OK 1 NG
Check seat belt switch.
and harness between T c u
and seat belt switch
Replace T C U ~~
BELT
WARNING CIRCUIT CHECK
1 Unfasten seat belt.
2 Measure voltage across @I and @ when
ignition switch
is "ON"
Che& from harness ride
0 -12v Joltmeter needle keeps SwlngInQ appr~x 0-12Vl for about 7 ;econdr after ngnition witch Is Voltmeter :urned ON SEL720C
SEAT BELT SWITCH CIRCUIT CHECK
1 Turn ignition switch to "OFF"
2. Unfasten driver's seat belt.
3. Check for continuity between 0 and @
4 Fasten driver's seat belt
5 Check to determine if continuity does not
exist between 0 and @
Check from harness %de
Ohmmeter
SEL7211
EL-87

LOCATION OF ELECTRICAL UNITS
LWarning chime Meter power unit (For digital
type combination
meter1
Hold relay (only for Canada
analog type
Clutch witch (For AS C D I
(For A 5 C D )
box
SEL753D
EL-I 06

@3 Fuse block
TOEFI H
A S C D control unit
To door harness
L H White)
To door harness L H (Blue)
To door harness L H (SF models) To 0 (Blue) (CLL models)
To
@ (White)
To @ (Non-turbocharger models)
. Clutch switch (A S C D ) . Stop switch (A S C D ) Stop lamp switch
Step lamp L H
Kickdown switch (A/T models)
Lightlng switch
Wiper switch
Horn switch
Key
lamp
ul
Cigarette hghter
Ash tray lamp
Step lamp R H
To @I (Blue)
To 0 Wite)
Flasher unit
Ignition switch
AS C D switch
Headlamp switch
Intermittent wiper tune
control
Steermg lock swltch
An conditioner harness
Au conditioner harness Au conditioner harness To 0 (Non-turbocharger models) To 0 (Turbocharger models) @ To @I (Black)
To @ (Blue) To @ (White) @ Tune control unit
TO door harness R H (ST models)
To door harness R H (CL and GLL models)
To door harness
R H (GL and GLL models)
@ . To @I (Blue) (GLL models)
@ Voice warning unit
I@
@J
To E P I harness (Non-turbocharger models)
To E P I harness

Diode
L & GLLxodelr
TO ENGINE ROOM
H R H (HORN RELAY]
HRH
ITHEFT
WARNING RELAY-11
TO ENGINE ROOM
TO THEFT WARNING
CONTROL UNIT
TO HORN SWJ
TO BACK DOOR SW TOTHEFT WARNING 3TlME CONTROL UNIT CONTROL UNIT
TO ENGINE ROOM H R H ro INST H R H :DOOR WARNING LAMPI sw TOEFI H
TO LIGHT SW TO ENGINE ROOM H R H (POWER
STEERING SWI
TO INJECTOR BLOWER IFAN MOTOR RELAY)
(For theft warning system & E F I systeml
ode 6&
F model9
Not used
TOEFI H
TO ENGINE ROOM
HRH (POWER
STEERING SWI
TO LIGHT SW
TO FUSE
TO REAR
DEFOGGERRELAY
(For E F I system1 ode
TO TIME CONTROL
TO INST H
L H
TO ENGINE ROOM H
TO KEY SW UNIT
TO ENGINE ROOM H L H
(HEADLAMP MOTOR) (CHIME]
TO LIGHT SW
TO LIGHT SW IUPHOLD RELAY)
TO STEP LAMP TO DOOR SW R H
TO TIME
CONTROL UNIT
[For headlemp system & time control system)
Itode @
TO BACK DOOR ,LOCK SW
TO DOOR SW L H
TO DOOR SW R H
TO DOOR H LH
TO DOOR H
RH
TO VOICE WARNING UNIT AN0
TllEFT WARNING COhTROL UNIT
TO THEFT
WARNING
rCONTROL UNIT
TO BACK
DOOR SW
TO
DOOR SWRH
TO INST H R H (DOOR WARN-
ING LAMP)
TO TIME CONTROL UNIT
(Far voice warning system & theft warning system)
(Far theft warning system & tlme control system)
Turbocharger models
Nan turbocharger models
2+2 seater
2 seater
Door muror defogger swtch
A/T indicator lamp
RcmGlc
con1;a: miiiDi 8...itCh
0 D switch (AIT models)
Headlamp
cleaner switch
Shock absorber switch (Turbocharger models)
Body ground
Diode Diode
(Sf modcls)
Diode (GL and GLL models)
Diode (2+2 seater)
Theft warning control unit Seat belt switch R H (GLL models)
0, Sensor control amp (GLL models)
Parking brake switch
Radio amphfier
(GLL models)
Seal
bell switch L H (SF models) Seat belt switch L H (GL models) lo power seat harness (GLL models)
Body ground
(GLL models)
Didoe
(GL and GLL models)
Body ground (GLL models)
Body ground
(GLL models)
I